Installation guide
Owner’s manual
Error Codes
How to reset Frigidaire side by side refrigerator not cooling?
If your Frigidaire FGSC2335TF0 side-by-side refrigerator isn’t cooling because the cooling system was turned off, press and hold POWER OFF for 3 seconds to turn cooling back on. If it’s still not cooling, use DEFAULT SETTINGS to reset control settings to factory defaults (hold 3 seconds). See the control panel steps in the FGSC2335TF0 use & care manual.
- Check the display for “power off”; if shown, cooling is disabled.
- Press and hold POWER OFF for 3 seconds to re-enable cooling.
- If settings seem wrong, press and hold DEFAULT SETTINGS for 3 seconds.
- After a reset, allow time for temperatures to stabilize (cooling recovery is not instant).
- If a Power Fail alert is lit, acknowledge it using the alarm reset option shown on your control panel.
These checks help separate a control issue from an airflow or sealed-system problem:
- Doors sealing: make sure doors close fully and gaskets are not torn or folded.
- Airflow: do not block vents with food packages in either compartment.
- Condenser area: clean dust buildup so the condenser fan and compressor can shed heat.
- Evaporator fan: if you do not hear airflow in the freezer, the fan circuit may be the issue.
- Frost pattern: heavy frost on the freezer back wall can point to a defrost problem.
| What you notice | Likely area | What we typically do next |
|---|---|---|
| Display shows “power off” | Control setting | Turn cooling back on (POWER OFF 3 sec) |
| Freezer cold, fridge warm | Airflow/damper | Inspect diffuser/damper and vents |
| Warm everywhere, compressor quiet | Control or power | Verify outlet power, then test control board |
| Heavy frost on freezer panel | Defrost system | Check heater/defrost circuit |
If troubleshooting points to a failed component, these are common matches for this model:
- Frigidaire refrigerator electronic control board 5304512770 (can affect cooling operation)
- Refrigerator evaporator fan motor 242290001 (moves cold air through the freezer)
- Refrigerator air damper 241853801 (controls cold air flow into the fresh food section)
On FGSC2335TF0, the POWER OFF function disables the cooling system without unplugging the refrigerator. A quick control reset can restore cooling, but persistent warm temperatures usually mean an airflow, defrost, or control component problem.
Last updated: January 2026
What is the most common problem with Frigidaire refrigerators?
For the Frigidaire FGSC2335TF0 side-by-side refrigerator, the most common customer-reported issues we see are cooling performance problems (warm fresh food section, freezer frost buildup) and ice maker or water dispenser troubles. Many of these start with airflow restrictions, filter maintenance, or door sealing problems.
- Not cooling well: clean condenser area, confirm vents are not blocked by food, verify temperature settings.
- Freezer frost buildup: check for a door not sealing, frequent door openings, or a defrost system issue.
- Ice maker not making ice: confirm ice maker is ON, water supply is on, and the filter is not overdue.
- Slow or no water dispensing: often tied to a restricted filter, low water pressure, or a valve issue.
- Warm fridge but freezer seems OK: commonly points to an airflow problem between compartments.
For model-specific operating checks like temperature ranges, alarms, and ice maker on/off control, use the FGSC2335TF0 use & care manual.
If basic checks do not fix the problem, these model-compatible parts are often involved:
| Symptom | Common system involved | Example model-compatible part |
|---|---|---|
| Ice maker not filling or weak water flow | Water supply/valve/filter | Refrigerator filter assembly EPTWFU01 |
| No ice, intermittent ice, or dispenser issues | Ice maker assembly | Refrigerator ice maker 243297613 |
| No water to dispenser/ice maker | Water inlet valve | Frigidaire refrigerator water inlet valve assembly 242252702 |
| Warm temps, poor airflow | Evaporator fan/air movement | Refrigerator evaporator fan motor 242290001 |
Cooling and ice maker problems can look “major,” but they often start with maintenance items (filters, airflow, door sealing). Catching those early helps protect food temperatures and can prevent unnecessary part replacement.
Last updated: January 2026
How do I find the model number on my FGSC2335TF0?
Your Frigidaire side-by-side refrigerator’s model number is printed on the appliance ID label. On FGSC2335TF0 units, we typically see this label inside the fresh food (refrigerator) compartment on a side wall or near the top, where it’s easy to read when the door is open. For label locations and illustrations, use the FGSC2335TF0 owner's manual.
Check these common ID label spots on a Frigidaire side-by-side refrigerator:
- Inside the refrigerator compartment on the left or right side wall
- Along the ceiling area inside the refrigerator compartment
- On the door frame (the cabinet face that’s visible when the door is open)
- Behind the crisper drawers area (less common, but possible)
The ID label usually includes multiple identifiers. Copy them exactly as shown.
| Label item | What it’s used for | Example format |
|---|---|---|
| Model number | Finds the correct diagrams and parts list | FGSC2335TF0 |
| Serial number | Identifies production run and date | Letters and numbers |
| Electrical ratings | Confirms power requirements | Volts/amps |
Using the full model number matters because small suffix changes can affect fit.
- Write the model number exactly, including all letters and numbers
- Take a clear photo of the label before it fades or gets smudged
- Use the model number to match parts like the water filter head, ice maker, or control board
- If the label is hard to read, clean it gently with a damp cloth and dry it immediately
The model number ties your refrigerator to the correct parts diagrams, installation details, and troubleshooting steps. That is how we make sure items like a refrigerator ice maker or air filter match your FGSC2335TF0 correctly.
Last updated: March 2026
