LG LFC23760SW/00 refrigerator Parts

The LG LFC23760SW is a 33-inch wide, bottom-mount (3-door) refrigerator with about 22.7 cu. ft. of total capacity. For the exact height, depth, and required clearances for your kitchen, use the LFC23760SW owner's manual.

What “size” usually means (and what to check)

When customers ask how big a refrigerator is, we typically look at these specs:

• Width (often listed as 33 inches for this model family)
• Total capacity (about 22.7 cu. ft.)
• Height (varies by hinge and leveling leg adjustment)
• Depth (cabinet depth vs. depth with handles)
• Clearances (space needed behind, above, and at the sides for airflow and door swing)

Quick size snapshot

Spec type	What you can expect for LG LFC23760SW	Where to confirm
Width class	33-inch refrigerator	LFC23760SW owner's manual
Capacity	About 22.7 cu. ft.	LFC23760SW owner's manual
Fit details	Height, depth, door swing, ventilation clearance	LFC23760SW owner's manual

Why it matters for installation and performance

Getting the full dimensions and clearances right helps prevent common issues like doors not opening fully, drawers hitting nearby cabinets, and poor cooling from restricted airflow around the condenser area.

If you are shopping for parts for this model

Use the parts list for LG LFC23760SW on this page to match parts by diagram and description, or search by model number on Sears PartsDirect.

Last updated: February 2026

Common freezer problems on an LG LFC23760SW bottom-mount refrigerator include weak or uneven freezing, frost buildup, water/ice at the bottom of the freezer, and temperature swings caused by restricted airflow or a control/sensor issue. Start by confirming the freezer is set to 0°F (-18°C) per the owner's manual.

Quick checks we recommend first

• Make sure air vents are not blocked by food packages (air must circulate between freezer and fresh food sections).
• Confirm the doors close and seal fully; warm air leaks quickly reduce freezing performance.
• Verify the freezer control is set correctly (initial setting is 0°F).
• Keep proper clearance around the refrigerator for airflow and efficiency.
• After loading a lot of warm food, allow time for temperatures to stabilize.

Most common symptoms and what they usually point to

Symptom	Most likely cause	What to do next
Freezer not freezing but fridge is cold	Compressor or control issue	Check for consistent compressor/fan operation; consider the refrigerator electronic control board CSP30000202 if other basics check out
Frost buildup, poor airflow	Defrost system or airflow restriction	Inspect vents for blockage; if icing persists, check the refrigerator defrost sensor assembly 6615JB2005C
Water pooling or ice sheet in freezer	Drain restriction	Clear the drain path; replace the refrigerator drain 5251JA3003D if the tube is damaged or won’t clear
Temps swing, food softens then refreezes	Temperature sensing or damper/airflow issue	Check for blocked vents; consider the refrigerator sensor 6500JB2001B if temps are erratic

Why it matters

Your LFC23760SW uses a designed airflow path (top-to-bottom circulation in the freezer and return airflow back to the freezer). When vents are blocked, doors leak, or sensors/control components misread temperature, freezing capability drops and energy use rises.

Helpful DIY guidance

For model-specific settings, clearances, and airflow details, use the owner's manual. For broader parts lookup by model number, we also support search on Sears PartsDirect.

Last updated: February 2026

To remove the bottom freezer pullout drawer on your LG LFC23760SW, pull the drawer fully open, lift out the lower basket, then lift the drawer front up and off the rails. Use two people and avoid pulling on the handle to prevent injury or damage; see the owner's manual.

Steps to remove the bottom freezer drawer (pullout drawer)

• Unplug the refrigerator and remove food from the freezer drawer.
• Pull the drawer open to full extension.
• Lift the lower basket straight up to remove it from the rail system.
• With both hands, hold both sides of the drawer front and lift up to separate it from the rails.
• Press both hangers with your thumbs to lift them up (this helps release the drawer front).
• If you need to remove the rails, remove the rail covers and take out the screws on both sides.

Safety notes (important)

• Do not hold the drawer by the handle while removing it; the handle can come off.
• Use two people for the procedure to reduce the risk of injury and to protect the rails.
• When setting the drawer down, watch sharp edges on the hinge side and protect the floor.

What you may need

Item	Typical use
Phillips screwdriver	Removing rail cover screws (if rail removal is needed)
Flat-head screwdriver	Helping release covers (if equipped)
10 mm socket or 1/4 in hex-head socket wrench	Fasteners on some assemblies (varies by setup)

Why it matters

Removing the drawer the right way prevents bent slide rails, broken rail covers, and door alignment issues that can cause air leaks and poor cooling.

Last updated: February 2026

On LG model LFC23760SW, ice building up on the freezer floor is most often caused by a defrost drain that is clogged or frozen, so defrost water cannot flow to the drain pan and instead refreezes at the bottom. Use the steps in the owner's manual to safely access panels and restore airflow.

Most common causes

• Clogged or frozen defrost drain (water backs up and refreezes into a sheet of ice)
• Door not sealing tightly (warm, moist air enters and adds frost)
• Blocked air vents (poor circulation can increase moisture and frost)
• Frequent door openings (adds humidity that later freezes)

Quick fix: clear the drain safely

1. Unplug the refrigerator.
2. Remove the freezer drawer/bins so you can see the bottom panel.
3. Melt the ice with the door open (towels help). Use only gentle heat (no sharp tools).
4. Locate the drain opening and flush with warm water until it flows freely.
5. If the drain tube is damaged or won’t clear, replace the drain tube: refrigerator drain 5251JA3003D.

What to check while you’re in there

• Make sure food packages are not blocking vents; the manual notes blocked vents can cause temperature and moisture problems.
• Confirm the doors close completely; the manual notes you may need slight pressure for full closure.

Door seal and airflow checks (prevents repeat icing)

• Clean the gasket sealing surfaces and the cabinet mating surface.
• Do the paper test: close the door on a sheet of paper; it should resist pulling out.
• If the gasket is torn, hardened, or warped, consider replacement (this model uses door gasket assemblies such as refrigerator door gasket ADX73410707).

Symptoms and what they usually mean

Symptom	Most likely cause	What to do first
Solid ice sheet on freezer floor	Drain clogged/frozen	Defrost and clear drain
Frost around door edges	Door not sealing	Clean/inspect gasket, level unit
Moisture and temp swings	Vents blocked or doors opened often	Clear vents, reduce openings

Why it matters

A blocked drain can lead to recurring ice buildup, restricted airflow, warmer temperatures, and water leaks when the ice melts. Fixing the drain and improving door sealing helps the freezer maintain stable temperatures and reduces future frost.

If you need to order parts for LFC23760SW, use the parts list for this model or search by model number on Sears PartsDirect.

Last updated: February 2026