Whirlpool GS5SHAXNL00 side-by-side refrigerator Parts

On the Whirlpool GS5SHAXNL00 side-by-side refrigerator, the main temperature controls are inside the fresh food (refrigerator) compartment, and the ice and water dispenser controls (light, lock, ice type) are on the dispenser area on the freezer door. See the GS5SHAXNL00 use & care manual for your exact control style.

Most owners will find controls in these spots:

• Refrigerator temperature control: inside the refrigerator section (fresh food side)
• Freezer temperature control: inside the refrigerator section (fresh food side)
• Ice maker ON/OFF switch: top right area inside the freezer compartment
• Dispenser controls (if equipped): on the freezer door dispenser area (light, lock, cubed/crushed)

The GS5SHAXNL00 uses separate controls for each compartment.

We recommend these best practices for GS5SHAXNL00:

• Start at the factory “mid-setting” for both controls.
• Wait 24 hours after an adjustment before changing again.
• If the refrigerator is warm, move the refrigerator control one setting colder.
• If ice is soft or production is low, move the freezer control one setting colder.
• Avoid setting both controls to the coldest position; it won’t cool faster and can cause freezing in the fresh food section.

Using the correct control location and making small, timed adjustments helps the GS5SHAXNL00 maintain stable temperatures, protect food quality, and support normal ice maker and dispenser performance.

Last updated: January 2026

For Whirlpool GS5SHAXNL00, the exact freezer-only cubic feet isn’t called out in the model-specific information we have here, but the unit’s total capacity is commonly listed as about 25.5 cu ft. In side-by-side designs of this size, the freezer is often roughly 8 to 10 cu ft. See the GS5SHAXNL00 use & care manual for capacity and configuration details.

Most side-by-side refrigerators split space between fresh food and freezer more evenly than top-freezer models, but the freezer side is usually smaller than the refrigerator side.

• Freezer space is often about 30% to 40% of total capacity
• In-door ice systems can reduce usable shelf room
• Door bins add storage but can limit clearance for wide items
• Shelf and basket layout affects “real-world” capacity

• Ice maker and ice bin hardware (especially in-door systems)
• Thick shelf frames or extra dividers
• Air tower and vent locations that block bulky items
• Frost buildup from a door not sealing fully

Knowing the typical freezer share helps you plan for bulky items (pizza boxes, turkeys) and decide whether features like an ice maker trade convenience for storage.

Last updated: January 2026

On the Whirlpool GS5SHAXNL00 side-by-side refrigerator, the use & care information describes a “base grille water filtration system,” which typically means the water filter is accessed at the bottom front of the refrigerator behind the toe grille. Exact placement can vary by configuration, so confirm by checking for a filter cap or cartridge behind the lower grille.

Use these quick checks to verify you are looking in the right spot:

• Look along the bottom front edge for a removable toe grille (base grille)
• Remove the grille and look for a round filter cap or a twist-out cartridge
• If you see a cap, it may transfer to the new filter after removal
• If you do not see a filter behind the grille, check inside the fresh food compartment for a filter housing
• Match what you see to the filtration section in the GS5SHAXNL00 use & care manual

Once you locate the cartridge, replacement is usually straightforward:

• Dispense water for a few seconds to relieve pressure
• Place a towel under the filter area for drips
• Turn the filter counterclockwise to remove (or follow the arrow/lock markings)
• Install the new filter and turn clockwise until it seats and seals
• Flush the system by dispensing water for several minutes

The GS5SHAXNL00 manual text references a “Base Grille Water Filtration System” and explains using the dispenser without a filter by moving the cap to the base grille. It does not explicitly call out the exact exterior access point in the extracted text we have.

Finding the correct filter location helps you avoid forcing the wrong cover, prevents leaks at the housing, and restores normal water flow to the dispenser and ice maker after a filter change.

Last updated: January 2026