Kenmore 10657989700 side-by-side refrigerator Parts

For Kenmore model 10657989700 (side-by-side), the exact cubic-foot capacity is listed on the model’s rating label and in the 10657989700 owner's manual. If you are seeing “Kenmore Elite 30.6 cu. ft.” online, that typically refers to a different French door style, not this side-by-side model.

We recommend checking these common locations first:

• Inside the fresh food compartment on a side wall near the crisper drawers
• On the ceiling or upper side wall inside the refrigerator section
• Behind the toe grille (base grille) area
• On the back exterior panel near the power cord
• In the specifications section of the 10657989700 owner's manual

If the listing you found shows a different door style, the capacity will not match your unit.

Cubic-foot capacity affects how you shop for replacement parts and accessories (like shelves, bins, and filters) and helps you compare cooling performance and storage space accurately across Kenmore refrigerator models.

Last updated: February 2026

Kenmore Elite refrigerator dimensions vary by the exact model and style (side-by-side, French door, top freezer). For Kenmore model 10657989700 (a side-by-side), we use the exact measurements listed in the 10657989700 owner's manual so you can confirm fit, door swing clearance, and installation space before moving or replacing the unit.

If you do not have the exact model number, these ranges help you estimate what will fit in your kitchen opening.

• Side-by-side: about 32 to 36 in. wide, 65 to 71 in. tall, 30 to 35 in. deep
• French door: about 33 to 36 in. wide, 68 to 71 in. tall, 29 to 36 in. deep
• Top freezer: about 28 to 33 in. wide, 61 to 67 in. tall, 28 to 34 in. deep
• Plan extra space for door swing, handles, and airflow behind the cabinet

Measure the space and the refrigerator, then compare.

• Measure the opening width at the front and back (cabinets are not always square)
• Measure height to the lowest overhead cabinet or soffit
• Measure depth from the back wall to the front edge of counters
• Add clearance for hinges/handles and for pulling out crisper drawers
• Leave ventilation space as specified in the 10657989700 owner's manual

Correct dimensions prevent delivery problems, doors that will not open fully, and poor cooling from restricted airflow. Getting the clearances right also helps avoid water line kinks for the dispenser and ice maker.

Last updated: February 2026

The most common problems we see on Kenmore refrigerators like model 10657989700 are cooling issues, water leaks, ice maker or dispenser failures, and unusual noises. These usually trace back to airflow restrictions, frost buildup in the defrost system, or worn water-system parts; use the 10657989700 owner's manual for model-specific checks and settings.

• Not cooling or warm temperatures: dirty condenser coils, evaporator fan not running, or a defrost problem causing ice buildup
• Water under the refrigerator: clogged defrost drain, loose water line, or a leaking inlet valve
• Ice maker not making ice: water supply issue, failed ice maker module, or a bad inlet valve
• Water dispenser slow or not dispensing: clogged water filter, air in the line, or low house water pressure
• Clicking, buzzing, or rattling: fan blade hitting ice, condenser fan obstruction, or compressor start components

1. Confirm the doors seal and close fully; poor sealing causes temperature swings and frost.
2. Set temperatures to normal targets (about 37°F fresh food and 0°F freezer).
3. Clean condenser coils and make sure airflow around the cabinet is clear.
4. If water or ice is affected, verify the refrigerator is connected to a cold water pipe and allow 24 hours after installation or heavy use for the water supply to cool.
5. Replace the water filter on schedule; a restricted filter can reduce dispenser flow and ice production.

Catching the root cause early protects food temperatures, prevents recurring leaks, and reduces strain on major components like the compressor and electronic control.

For water and filter-related issues, follow how to replace the water filter in a Kenmore refrigerator. For model-family troubleshooting, use Kenmore 106 model refrigerator error codes to interpret any displayed codes.

Last updated: February 2026

Most Kenmore refrigerators average 10 to 15 years of service life. For a Kenmore side-by-side like model 10657989700, lifespan depends most on basic care such as cleaning, good door sealing, and keeping airflow clear; those habits reduce compressor and cooling-system strain (see the 10657989700 owner's manual).

• 10 to 15 years: common for many household refrigerators
• 15 to 20 years: achievable with consistent maintenance and timely repairs
• Under 10 years: more likely when coils are clogged, doors leak air, or the unit runs hot

• Clean condenser coils regularly (dust buildup makes the compressor run longer)
• Confirm proper air circulation inside the cabinet (avoid blocking vents)
• Keep door gaskets sealing so the refrigerator does not run constantly
• Use the correct water filter and replace on schedule if you have a dispenser
• Address unusual noises early (fan rubbing, clicking, or buzzing can signal wear)

A refrigerator that runs hotter or longer than normal wears out key components faster, especially the compressor, fans, and defrost system. The care steps above help your Kenmore side-by-side maintain stable temperatures with less strain.

Last updated: February 2026

On the Kenmore 10657989700 side-by-side refrigerator, the water filter is located in the base grille at the bottom front of the unit. You access it from the front; the filter uses a cap and an eject-style release described in the 10657989700 owner's manual.

• Look at the very bottom front of the refrigerator for the base grille.
• Open both doors if you need more room to work at the grille.
• Find the filter cap area in the grille; the cap stays with the refrigerator when you change filters.
• If you are removing the filter to run unfiltered water temporarily, keep the cap and install it in the grille as directed.

If your filter is missing its cap or you are replacing the cartridge, these model-compatible parts are commonly used:

• Genuine Kenmore refrigerator water filter EDR3RXD1 (replacement filter cartridge)
• Refrigerator water filter cap (black) WP2260518B (cap that fits the filter opening)

Knowing the filter is in the base grille helps you avoid removing interior shelves or panels unnecessarily. It also makes routine maintenance easier, which helps water flow and reduces issues like slow dispensing after a clogged or incorrectly installed filter.

Last updated: February 2026

On Kenmore side-by-side refrigerator model 10657989700, the model number is printed on the appliance identification label; we typically find this label inside the fresh food (refrigerator) compartment on a side wall or near the ceiling, and it lists both the model and serial information. See the 10657989700 owner's manual for the exact label location and diagrams.

• Inside the refrigerator section on the left or right interior wall
• On the ceiling area inside the refrigerator compartment
• Behind the base grille area (lower front) on some Kenmore 106 models
• On the door frame (hinge side) when you open the refrigerator door
• On the back exterior panel near the power cord (less common)

The ID label usually includes a model number and a serial number. Record both before ordering parts like a water filter or ice maker.

Kenmore side-by-side refrigerators can look similar across multiple 106-series models, but parts such as the water filter cap, inlet valve, or ice maker can vary by revision. Using the exact model number helps us match the correct Kenmore refrigerator parts the first time.

Last updated: February 2026

Kenmore model 10657989700 was made for Sears by Whirlpool. The 106 prefix in the model number is the key identifier that ties this Kenmore side-by-side refrigerator to Whirlpool manufacturing.

We recommend verifying the full model number from the rating label, then matching the prefix.

• Look for the model and serial tag inside the fresh food compartment (often on a side wall)
• Confirm the model reads 10657989700 (all digits, no missing characters)
• Use the first three digits (106) as the manufacturer prefix
• Keep the full model number handy when ordering parts like a water filter or inlet valve

Knowing Whirlpool made Kenmore 10657989700 helps us narrow down the correct part design and troubleshooting approach, especially for common systems like the ice maker, water dispenser, and defrost circuit.

For model-specific diagrams, part locations, and maintenance details, use the 10657989700 owner's manual.

Last updated: February 2026