Owner’s manual
Error Codes
What size is a side-by-side refrigerator?
Most side-by-side refrigerators are about 30 to 36 inches wide, 67 to 70 inches tall, and 29 to 35 inches deep. For your Kenmore 10658904801, use the exact cabinet dimensions and clearance requirements in the 10658904801 owner's manual.
Typical size ranges (what to expect)
These are the most common exterior dimension ranges for a full-size side-by-side refrigerator:
- Width: 30 to 36 inches
- Height: 67 to 70 inches
- Depth: 29 to 35 inches (often deeper with handles)
- Door swing clearance: varies by kitchen layout and hinge style
Installation clearances that affect the real space you need
Even if the cabinet fits, you still need airflow and door-swing room. For Kenmore 10658904801, our manual guidance includes:
- Allow 1/2 inch of space on each side and at the top for ventilation
- If installed next to a fixed wall, allow at least 2 inches on the hinge side (depending on setup) so doors can open
- If the refrigerator has an ice maker, allow extra space behind for the water line connection
Quick clearance checklist
| Space needed | Typical recommendation | Why it matters |
|---|---|---|
| Side and top ventilation | 1/2 inch | Prevents overheating and poor cooling |
| Wall-side door swing | 2 inches minimum | Lets doors open fully without binding |
| Rear space (water line) | Extra as needed | Prevents kinks and leaks |
How we recommend measuring before you buy or move the fridge
- Measure the opening width, height, and depth in at least two spots
- Measure doorways and hallways the refrigerator must pass through
- Add space for handles and door swing (especially near walls or islands)
- Plan for leveling (an unlevel refrigerator can affect door alignment)
Why it matters
A side-by-side refrigerator that is “the right size” on paper can still run hot, rub cabinets, or fail to open fully if clearances are tight. Following the spacing guidance in the manual helps protect cooling performance and makes daily use easier.
If you are also planning water hookup or filter replacement for this model, you can order parts from the list for Kenmore 10658904801 or search by model on Sears PartsDirect.
Last updated: February 2026
How many cubic feet is my Kenmore refrigerator by model number?
For Kenmore model 10658904801, the most accurate way to get the exact cubic-foot capacity is to use the model’s specifications in the 10658904801 owner's manual or read the rating plate inside the fresh food section. That capacity is a fixed spec for your model, not something you have to estimate.
Fast ways to find the exact capacity
Use these options in order; they are the quickest and most reliable for this model.
- Check the rating plate (usually on an interior side wall or ceiling of the fresh food compartment).
- Look up the specifications section in the 10658904801 owner's manual.
- If the label is hard to read, take a clear photo and zoom in; the capacity is typically listed as “cu. ft.” or “total capacity.”
- If you are comparing models for fit, measure the cabinet opening too; capacity does not tell you exterior dimensions.
What the rating plate typically shows
| Item on rating plate | What it helps with | Why you might need it |
|---|---|---|
| Model number | Confirms exact unit | Prevents ordering wrong parts |
| Serial number | Identifies production run | Useful for service history |
| Electrical info | Confirms power requirements | Helps with installation checks |
| Capacity (cu. ft.) | Confirms storage size | Helps compare to other refrigerators |
Why cubic feet matters
Capacity helps you compare storage space between side-by-side refrigerators, but it also affects real-world performance expectations like how full shelves can block airflow, how quickly temperatures recover after door openings, and how often the ice maker and water system get used.
Related parts you might replace while checking specs
If you are confirming capacity because you are planning maintenance or troubleshooting, these common items for this model are available:
- Water filtration: Genuine Kenmore refrigerator water filter EDR3RXD1
- Ice production: Refrigerator ice maker 2198597
- Water supply to dispenser/ice maker: Refrigerator inlet valve W10408179
If you need to order parts for Kenmore 10658904801, use the parts list for this model or search by model number on Sears PartsDirect.
Last updated: February 2026
Where is the model number on a Kenmore side by side refrigerator?
On Kenmore side-by-side refrigerator model 10658904801, the model number is printed on the appliance identification label (the same label that lists the serial number). We use that model number to match the correct parts list and diagrams for your exact refrigerator; see the owner's manual for label location details.
Common places to check first
On most Kenmore side-by-side refrigerators, the model and serial label is typically found in one of these spots:
- Inside the fresh food (refrigerator) compartment on a side wall
- Along the ceiling of the fresh food compartment near the light housing
- On the door frame (hinge side) when you open the refrigerator door
- Behind the base grille area (less common, but possible on some designs)
How to identify the model number vs. the serial number
The label usually shows both. Use this quick guide:
| Item on label | What it’s for | What it looks like |
|---|---|---|
| Model number | Identifies the exact refrigerator design for parts | Often a longer number string (for this unit: 10658904801) |
| Serial number | Identifies the specific unit built | Often a mix of letters and numbers |
Why it matters
Kenmore model numbers can look similar, but small differences change which parts fit (for example, the correct water filter, ice maker, or inlet valve). Using 10658904801 helps us match parts like the genuine Kenmore refrigerator water filter EDR3RXD1 correctly.
Tips before you order parts
- Write down the full model number exactly as shown
- Take a clear photo of the label for reference
- Use the model number to confirm fit before ordering from the parts list, or search by model on Sears PartsDirect
Last updated: February 2026
What does er if mean on a Kenmore refrigerator?
On Kenmore model 10658904801, the ER IF code points to a problem with the ice maker fan (ice compartment fan) airflow or feedback, so the refrigerator cannot move cold air properly to the ice box. Start by checking for ice buildup or a blocked fan, then reset power and recheck.
What to check first (fast, no parts)
- Unplug the refrigerator (or turn off the breaker) for 2 minutes, then restore power.
- Make sure the freezer door closes fully and the door gasket seals all the way around.
- Remove any ice clumps in the ice bin and clear cubes from the chute.
- Look for frost or ice buildup around the ice box area that could jam the fan.
- Confirm freezer temperature is set correctly (typical target is 0°F).
Access and inspection basics
Use the disassembly steps and safety notes in the 10658904801 owner's manual before removing drawers or covers.
When you inspect the ice box area:
- Listen for the fan running when the unit is calling for ice cooling.
- Spin the fan blade by hand (power off); it should turn freely.
- Check for wiring damage or a loose connector near the fan housing.
Likely fixes and the parts that commonly relate
If the fan is not moving air because the blade is damaged or the motor is weak, these model-compatible parts are common solutions:
| Symptom you notice | Most likely cause | Part that often applies |
|---|---|---|
| Fan hums but little airflow | Cracked/loose blade or ice rubbing | Refrigerator evaporator fan blade WP2169142 |
| No fan sound, warm ice box | Failed fan motor or seized motor | Refrigerator evaporator fan motor WP2315549 |
| Heavy frost, fan hitting ice | Defrost problem causing ice buildup | Refrigerator defrost heater WP2323198 or refrigerator bi-metal thermostat WPW10225581 |
Why it matters
The ice fan keeps the ice compartment cold. When airflow stops, you can get slow ice production, melting and refreezing clumps, and temperature swings that also stress the cooling system.
If you need to order parts for Kenmore 10658904801, use the parts list for this model or search by model number on Sears PartsDirect.
Last updated: February 2026
What are the most common problems with Kenmore refrigerators?
The most common issues we see on Kenmore refrigerators like model 10658904801 are cooling problems, water leaks, ice maker or dispenser failures, and unusual noises. These typically trace back to airflow restrictions, defrost system trouble, water supply problems, or worn components; our 10658904801 owner's manual troubleshooting section helps narrow it down fast.
Common problems and what usually causes them
- Not cooling or warm temperatures: dirty condenser coils, evaporator fan not running, blocked vents, or a defrost problem causing ice buildup.
- Freezer cold but fresh food warm: poor airflow (frosted evaporator, failed evaporator fan motor, damper/vent blockage).
- Water leaking or puddles: clogged defrost drain, cracked water tubing, loose fittings, or a seeping inlet valve.
- Ice maker not making ice: water supply shut off, frozen fill tube, failed ice maker assembly, or a weak inlet valve.
- Noisy operation: fan blade rubbing ice, worn fan motor, or vibration from the cabinet or lines.
Quick checks we recommend first (no parts required)
- Confirm control settings: your manual notes that turning the refrigerator or freezer control one setting colder or warmer is the first step when temps are off.
- Limit door openings and let temperatures stabilize after loading groceries.
- Check door sealing: look for gaps, torn gasket areas, or doors not closing fully.
- Listen for fans: a stalled evaporator fan often changes how the refrigerator sounds and cools.
- For dispenser issues: flush the water system if it was not flushed after installation (the manual describes dispensing in short intervals).
Parts that commonly fix these symptoms on 10658904801
| Symptom | Common part to check | Example from this model’s parts |
|---|---|---|
| Ice maker not working | Ice maker assembly | Refrigerator ice maker 2198597 |
| No water or slow water at dispenser | Inlet valve, filter | Refrigerator inlet valve W10408179, genuine Kenmore refrigerator water filter EDR3RXD1 |
| Frost buildup, warm temps | Defrost heater, defrost thermostat | Refrigerator defrost heater WP2323198, refrigerator bi-metal thermostat WPW10225581 |
| Warm fridge, odd fan noise | Evaporator fan motor/blade | Refrigerator evaporator fan motor WP2315549, refrigerator evaporator fan blade WP2169142 |
Why it matters
Most “big” refrigerator complaints are really airflow, defrost, or water supply problems. Catching them early prevents food spoilage, repeat ice jams, and compressor overwork.
If you need to order parts for Kenmore 10658904801, you can use the parts list for this model or search by model number on Sears PartsDirect.
Last updated: February 2026
