Kenmore Elite 10658964701 side-by-side refrigerator Parts

Your Kenmore Elite model 10658964701 is a side-by-side refrigerator, not a washer; cubic feet refers to refrigerator capacity (not washer tub size). For the exact capacity rating for this specific refrigerator, check the model specifications in the owner's manual.

If you were trying to size a Kenmore Elite washer, the number you want is usually tub capacity (cu. ft.). For model 10658964701, the correct sizing term is refrigerator capacity (cu. ft.), which is the total fresh food plus freezer volume.

Use these steps to get the exact number for your refrigerator:

• Open the owner's manual and look for “Product data sheet”, “Specifications”, or “Capacity”.
• Check the model/serial tag inside the refrigerator compartment; confirm it reads 10658964701.
• If you are comparing refrigerators, note that capacity is typically listed as total cu. ft. and sometimes split into refrigerator and freezer sections.
• If you are measuring for fit (space planning), use cabinet opening measurements separately from capacity.

Most side-by-side refrigerators are commonly in these ranges:

Capacity (cu. ft.) helps you compare usable storage between refrigerators, but it does not tell you whether your ice maker, water filter, or airflow system is working correctly. For performance issues like warm temperatures or slow ice production, we focus on components such as the air diffuser, evaporator fan motor, and inlet valve.

Last updated: February 2026

On Kenmore Elite refrigerator model 10658964701, a bad compressor usually shows up as poor or no cooling with the unit trying to run (often repeated clicking) or running for long periods without reaching temperature. Because this model uses a high-efficiency compressor that can run longer and sound different, we confirm “bad compressor” only after basic airflow, power, and start-component checks in the owner's manual.

• Refrigerator and freezer both warm, even though the lights and controls work
• Compressor area is very hot to the touch after it has been trying to run
• Repeated clicking every few minutes (start attempt, then shutoff)
• Constant running with little temperature improvement (especially in a warm room)
• Unusual new noises that are not the normal “pulsating/high-pitched” efficiency sounds described for this model

Many “compressor” complaints are caused by airflow or defrost problems. Before condemning the sealed system, we check these basics:

• Controls and power: Make sure the controls are on and the unit has steady power.
• Give it time after setup: After a new installation or a full defrost/unplug, allow 24 hours to cool completely.
• Door use and room conditions: Frequent door openings, warm room temps, or a big food load can make the compressor run much longer.
• Listen for normal sounds: This model can make buzzing (ice maker fill), rattling (refrigerant flow), sizzling (defrost), and pulsating sounds that are normal.

If the compressor is clicking off or not starting, the issue is often in the start circuit or controls.

If you are diagnosing cooling problems that point toward defrost failure (heavy frost, weak airflow), a common service part is the refrigerator defrost bi-metal thermostat WPW10225581.

Replacing a compressor is a sealed-system repair; it is more involved than typical refrigerator parts like a water filter, inlet valve, or fan motor. Confirming the basics first prevents unnecessary cost and downtime.

Last updated: February 2026

Common problems on a Kenmore Elite side-by-side refrigerator like model 10658964701 include warm temperatures (cooling complaints), ice maker or water dispenser issues, water leaks, and unusual noises. Most of these trace back to airflow restrictions, dirty coils, door sealing problems, or a defrost or water-supply component that is not operating correctly; our 10658964701 owner's manual troubleshooting section helps narrow it down fast.

• Not cooling well (fresh food or freezer warm): blocked air vents, dirty condenser coils, evaporator fan not moving air, or a defrost problem causing frost buildup
• Ice maker not making ice: water supply turned off, frozen fill tube, inlet valve not opening, or ice maker failure
• Water leaking: clogged/iced defrost drain, loose water line connection, cracked tubing, or filter housing issues
• Noisy operation: normal compressor/fan cycling sounds, items vibrating on the cabinet, or a failing fan motor
• Runs “all the time”: frequent door openings, warm room, large food load, or doors not sealing

• Confirm controls are on and allow 24 hours after installation for full cool-down.
• Make sure air vents are not blocked by food packages.
• Clean condenser coils and verify the condenser area has good airflow.
• Check door gaskets for gaps; close a dollar bill in the door and confirm it drags when pulled.
• If you hear buzzing during ice maker fill, verify the water supply is on and not kinked.

If your symptoms point to water supply or ice production, these model-compatible parts are common fixes:

Cooling, ice, and leak problems often get worse over time: restricted airflow can drive longer run times, frost buildup can block circulation, and small water leaks can turn into floor damage. Catching the root cause early usually keeps the repair simpler.

Last updated: February 2026

On Kenmore Elite side-by-side refrigerator model 10658964701, the model number is printed on the appliance identification label inside the fresh food (refrigerator) compartment. We use that exact model number to match the correct parts list and the right Kenmore-compatible replacement parts for your unit.

Look for a white or silver sticker (rating plate) in one of these spots:

• Inside the refrigerator section on a side wall (often upper right or upper left)
• On the ceiling of the fresh food compartment near the light housing
• Behind the crisper or deli drawer area on an interior wall
• Along the door frame (hinge side) when the refrigerator door is open
• Occasionally behind the base grille area (less common for side-by-side units)

For diagrams and label-location guidance specific to this refrigerator, use the 10658964701 owner's manual.

Record both the model and serial information exactly as shown on the label.

• Model number: identifies the design family and parts fit
• Serial number: helps narrow production changes within the same model
• Type/series codes (if shown): can affect which door bins, gaskets, or ice maker parts fit

Using the exact model number prevents ordering the wrong refrigerator water filter, ice maker, or inlet valve. Even small model-number differences can change fitment for items like a door cam, door bin, or defrost thermostat.

Last updated: February 2026