GE ZISP420DKCSS refrigerator Parts

To change the water filter in your GE ZISP420DKCSS side-by-side refrigerator, open the top access panel, slowly twist the old cartridge to the left to remove it, then install the new cartridge by aligning the arrows and turning it to the right until it stops (do not overtighten). See the owner's manual for the exact steps and reset procedure.

• Locate the filter behind the top access panel.
• Remove the old filter by slowly turning it left; do not pull down on it.
• Fill the new cartridge with tap water first for better initial flow.
• Align the arrow on the cartridge with the arrow on the holder.
• Insert the top of the cartridge into the holder (do not push it up).
• Turn the cartridge right until it stops; it will raise itself into position.

After installing the new filter, we recommend clearing air and resetting the indicator.

• Dispense water for about 1-1/2 gallons (about 3 minutes) to clear the system and reduce sputtering.
• Press and hold the RESET WATER FILTER pad for 3 seconds (location varies by model: dispenser or temperature control panel).

For the ZISP420DKCSS, a common replacement is the GE refrigerator water filter MWFP. Match the cartridge style and confirm fit before ordering.

A fresh refrigerator water filter helps maintain water flow to the dispenser and ice maker, and it prevents sputtering and trapped air after a filter change.

Last updated: February 2026

The most common issue we see with GE refrigerators like model ZISP420DKCSS is a cooling complaint (fresh food or freezer too warm). In many cases, it is caused by settings, door sealing/leveling problems, or airflow restrictions that keep the system from stabilizing properly (often needing a full 24 hours after changes). See the owner's manual for the model-specific “Problem Solver” checks.

• Too warm in fresh food or freezer: confirm temperature controls are set cold enough; avoid frequent/long door openings.
• Door not closing properly: check for packages blocking the door; inspect the door gasket for being out of position.
• Temperature not matching the set point: allow 24 hours after plugging in, changing settings, adding warm food, or after a defrost cycle.
• Long run times: normal after first startup; modern variable-speed compressors can run longer to maintain even temperatures.
• Small or hollow ice cubes: a clogged water filter is a common cause; replace the refrigerator water filter MWFP.

Cooling and temperature stability affect food safety, ice production, and energy use. Simple issues like a door left slightly open, a mispositioned gasket, or not waiting the full 24 hours after adjustments can look like a major failure when the sealed system is actually working normally.

• GE refrigerator error codes
• How to replace the water filter in a GE refrigerator

Last updated: February 2026

For your GE ZISP420DKCSS refrigerator, the model number and serial number are printed on an ID label inside the fresh food (refrigerator) compartment. Look on the lower right-hand side, beneath the climate control drawer.

• Open the fresh food door (not the freezer door)
• Look along the lower right interior wall
• Check beneath the climate control drawer area
• Find a label that lists Model and Serial
• Write both numbers down before ordering parts or scheduling service

• Copy the model number exactly as shown (letters and numbers)
• Take a clear photo of the label for reference
• Use the model number when selecting items like a water filter or door gasket
• If the label is hard to read, wipe it gently with a damp cloth and dry it

GE built-in and side-by-side refrigerators can have similar-looking doors, dispensers, and control panels, but parts like the main control board, temperature sensor, or water filter head can vary by model. Using the exact model number helps ensure a proper fit and correct function.

For a diagram-style reference to common label locations and model identification info, use the ZISP420DKCSS owner’s manual.

Last updated: March 2026