Kenmore 11087984100 gas dryer Parts

To tell what Kenmore dryer model you have, we look for the model number on the appliance’s ID label. For Kenmore model 11087984100, the label is typically in the door opening or on the back panel; matching that number ensures you get the right parts and diagrams.

Check these common locations on Kenmore dryers:

• Inside the dryer door opening (on the cabinet frame)
• On the back panel of the dryer
• On the door itself (edge or inner surface)
• Near the lint screen housing (depending on design)
• Behind the lower access panel (some configurations)

Kenmore model numbers are usually a long string of digits (sometimes with a dot). The full model number is what we use to match the correct part list for your exact gas dryer.

Before you buy a replacement part, we recommend:

• Write down the full model number exactly as shown
• Double-check for transposed digits (common issue)
• Use the model number to confirm fit before ordering items like a belt, thermal fuse, or door latch
• If you’re troubleshooting a symptom (won’t start, no heat), use a model-specific guide when available

If your dryer is a Kenmore 110-series electronic control style, our Kenmore 110 series electronic control model dryer error codes guide can help you match symptoms to likely causes.

Kenmore dryers can look identical across different model families, but internal parts (like the drive system, blower wheel, or sensors) can vary. Using the exact model number prevents mismatched parts and repeat repairs.

Last updated: February 2026

The most common problems we see with Kenmore gas dryer model 11087984100 are no heat or poor drying, won’t start, drum not turning, and loud noises. These issues usually trace to airflow restrictions, heat-safety parts, or belt-drive wear.

• Clothes take too long to dry: blocked venting, lint buildup, damaged blower wheel
• No heat: failed radiant sensor, airflow overheating, burner ignition issues
• Won’t start: blown thermal fuse, failed start switch, door switch problems
• Drum won’t turn: worn idler pulley, belt-drive issue, motor problem
• Squealing or thumping: idler pulley wear, drum seal wear, blower wheel rubbing

1. Clean the lint screen and confirm strong airflow at the outside vent hood.
2. Inspect the vent path for kinks, crushed duct, or heavy lint.
3. If the dryer won’t run, test the thermal fuse and door/start switches with a meter.

Helpful model-matched parts include the dryer blower wheel WP697772, dryer radiant sensor WP338906, and dryer start switch WP346343.

Gas dryers depend on steady airflow to heat safely. When airflow drops, the dryer overheats, trips safety devices, and drying performance falls fast. Fixing venting and replacing the failing part restores normal cycle times.

For safe meter use, we follow steps like those in how to use a multimeter to test electrical parts video.

Last updated: March 2026

A Kenmore gas dryer like model 11087984100 typically lasts 13 years with normal household use. Regular lint cleaning, good airflow through the vent, and replacing wear parts early (belt-drive and safety parts) helps you reach that lifespan.

• Vent restriction (long runs, crushed flex duct, clogged hood)
• Overloading the drum and frequent high-heat cycles
• Lint buildup inside the cabinet or blower housing
• Worn drum support and belt-drive components
• Heat safety shutdowns from overheating

These are normal wear or safety parts that often get replaced during a dryer’s life:

Model 11087984100 examples from our parts list include the thermal fuse WP3390719 and dryer idler pulley 279640.

A dryer can seem “worn out” when the real issue is airflow or a single failed component. Fixing overheating and belt-drive wear early prevents repeat breakdowns and helps clothes dry faster with less gas use.

Last updated: March 2026