Kenmore Elite 79575196400 refrigerator Parts

On Kenmore Elite model 79575196400, a bad compressor shows up as warm fridge and freezer temperatures even though the unit has power, often with repeated clicking at the compressor area or a compressor that runs extremely hot. Use the checks in the 79575196400 owner's manual to rule out common look-alikes first.

Symptoms that strongly point to a compressor problem

• Fridge and freezer stay warm after 24 hours of operation
• Repeated click, hum, then stop from the compressor area
• Compressor runs almost constantly but cooling stays weak
• Compressor is very hot after trying to start (use caution)
• No steady running sound, only start attempts

Rule out common causes first (fast checks)

These issues can mimic a failed compressor and are quicker to fix:

• Power and controls: confirm the outlet has power and controls are not set to OFF
• Condenser coils: clean dust from coils to restore heat removal
• Door sealing: inspect the freezer door gasket for gaps; replace if torn (see refrigerator gasket assembly MDS64172918)
• Airflow: make sure vents are not blocked; listen for fans running
• Room and usage: hot kitchens and frequent door openings increase run time

What confirms a bad compressor (technician tests)

A compressor diagnosis is based on electrical and sealed-system checks:

• Measure start and run amperage draw
• Check winding resistance and continuity, including to ground
• Verify the start device and wiring connections
• Check for sealed-system restrictions; a restricted filter dryer can contribute (see refrigerator drier assembly ADH73150208)

Normal vs. problem quick guide

What you notice	Often normal	More likely a problem
Long run times	Warm room, heavy use	Constant running with poor cooling
Clicking	Control cycling	Repeating click every few minutes with no cooling
Gurgling/sizzling	Refrigerant flow, defrost	Clicking plus overheating and warm temps

Why it matters

Compressor and sealed-system repairs are major. Ruling out airflow, dirty coils, and door-seal leaks first prevents unnecessary parts replacement and gets cooling restored faster.

Last updated: February 2026

Common problems on the Kenmore Elite 79575196400 bottom-mount refrigerator include warm temperatures from restricted airflow or dirty condenser coils, frost buildup from defrost system issues, water leaks from drain or water-line problems, and door sealing issues that cause moisture and temperature swings. Use the owner's manual troubleshooting and care sections to pinpoint the symptom.

Most common symptoms and what they usually point to

• Not cooling or weak cooling: blocked air vents, dirty condenser coils, evaporator fan or compressor system issues
• Frost buildup or ice on the back wall: defrost sensor/heater or airflow problems
• Loud humming, buzzing, or rattling: condenser fan area, evaporator fan area, or compressor mounting vibration
• Water under the refrigerator or in the crisper: clogged defrost drain, loose water tubing, inlet valve seepage
• Doors hard to open or won’t seal: dirty or warped gaskets, door alignment, vacuum effect after closing

Quick checks we recommend first (fast, no parts)

1. Confirm settings: start at 37°F (3°C) fresh food and 0°F (-18°C) freezer, then wait 24 hours for stabilization.
2. Make sure food packages are not blocking interior air vents.
3. Clean condenser coils (dust buildup is a top cause of poor cooling).
4. Inspect and clean door gaskets; sticky gaskets can also make doors feel hard to open.
5. If ice maker is slow, allow 24 hours after water hookup and verify the door is closing fully.

Parts that commonly solve these problems (when a failure is confirmed)

Symptom	Common suspect part	Example from this model’s parts
Frost buildup, warm fridge	Defrost sensing/control issue	Refrigerator defrost sensor assembly 6615JB2005H
Water dispenser/ice maker issues	Water supply control problem	Refrigerator water inlet valve 5221JB2006K
Light won’t turn off, door alarm behavior	Door switch not closing	Refrigerator door push-button switch 6600JB1010A
Leaks at fittings or lines	Cracked/loose tubing	Refrigerator water tubing (match by location and length)

Why it matters

These symptoms often overlap. For example, a door gasket leak can cause frost buildup, which blocks airflow and leads to warm temperatures. Starting with airflow, settings, and cleaning prevents unnecessary part replacement and helps you target the real failure.

Last updated: February 2026

On Kenmore Elite refrigerator model 79575196400, dH (often shown as Er dH) indicates a defrost heater or defrost cycle problem. The refrigerator may stop responding to some buttons while it protects the cooling system, and you can also see warming temperatures or frost buildup.

What you’ll usually notice

• Frost or ice building up on the freezer back wall
• Refrigerator section getting warm because airflow is restricted
• Fan noise changes (airflow sounds weaker) after the door closes
• Water dripping or refreezing in the freezer after a partial defrost
• The display shows dH or Er dH again after you reset power

Quick checks you can do safely

1. Power reset: Unplug the refrigerator (or switch off the breaker) for 5 minutes, then restore power.
2. Check airflow: Make sure packages are not blocking the vents; this model relies on steady circulation between freezer and fresh food sections.
3. Look for heavy frost: If the freezer back panel is packed with frost, the defrost system is not clearing ice.
4. Door seal check: Inspect the gaskets for gaps or tears; warm air leaks can overload the defrost system.

Parts that commonly cause a dH / Er dH condition

In this model family, the most common causes are in the defrost circuit (sensor, heater, wiring, or control). A frequent service part is the defrost sensor.

Symptom	Most likely area	What it affects
Heavy frost, weak airflow	Defrost system	Air can’t move through the evaporator
Temps swing up and down	Sensor or control logic	Defrost timing and termination
Returns after reset	Failed component	Error reappears once conditions repeat

If you’re troubleshooting parts, start with the refrigerator defrost sensor assembly 6615JB2005H.

Why it matters

When defrost ice is not cleared, airflow drops and both compartments can warm up. Fixing the defrost issue restores normal cooling and helps prevent repeat icing.

For model-specific troubleshooting steps and control information, use the owner's manual.

Last updated: February 2026

Most Kenmore Elite refrigerators, including model 79575196400, typically last 10 to 15 years with normal household use and basic maintenance. Keeping airflow clear, cleaning condenser coils, and maintaining good door seals helps you reach the upper end of that range; see the owner's manual for care and cleaning guidance.

Typical lifespan and what affects it

A refrigerator’s service life depends most on heat management, door sealing, and how hard the sealed system has to work.

• Condenser coil cleanliness (dust and pet hair shorten life)
• Door gasket condition (warm air leaks increase run time)
• Room temperature and ventilation (tight enclosures trap heat)
• Ice maker and water system upkeep (leaks and clogs create secondary damage)
• Power quality (frequent outages and surges add stress)

Maintenance checklist that extends life

Use these habits to reduce compressor run time and prevent common failures:

• Vacuum condenser area and clean the base/grille regularly
• Confirm doors close fully and gaskets seal all the way around
• Keep vents inside the fresh food section and freezer unblocked
• Replace filters on schedule and flush the dispenser after changes
• Fix small water leaks quickly (tubing, fittings, valve connections)

Repair vs. replace: a practical guide

When a refrigerator is in the later part of its lifespan, the decision usually comes down to the type of repair.

Issue type	Common examples	Typical decision driver
Maintenance or minor parts	door switch, small leaks, gasket issues	Usually worth repairing
Cooling/defrost problems	frost buildup, warm temps, fan or sensor issues	Repair if parts cost is reasonable
Sealed system or compressor	compressor or refrigerant-side repairs	Often higher cost; compare to age

Model 79575196400 includes warranty coverage for the sealed refrigeration system for a longer period than the full appliance warranty; details are listed in the owner's manual.

Why it matters

A refrigerator that runs longer to hold temperature uses more energy and wears out key components faster. Simple upkeep (especially coils and gaskets) reduces heat load, stabilizes temperatures, and helps the compressor last.

Last updated: February 2026