Kenmore 25371132105 top-mount refrigerator Parts

Kenmore model 25371132105 is a top-mount refrigerator, not an upright freezer. The cubic-foot capacity is listed on the model’s rating information and in the 25371132105 owner's manual; use that spec to confirm the exact refrigerator and freezer compartment sizes for your unit.

Quick way to find the capacity for model 25371132105

We recommend checking these spots first:

• The specifications section in the 25371132105 owner's manual
• The model and serial tag inside the fresh food compartment (the manual notes this location)
• Any product label or tech sheet stored behind the toe grille or rear access area (common on many refrigerators)
• If you are comparing similar Kenmore 253-series units, match the full model number exactly (25371132105)

Refrigerator vs. upright freezer: what to compare

If you are shopping for space or replacing an appliance, here is how the numbers are usually presented.

Appliance type	Capacity label usually means	Typical range
Top-mount refrigerator	Total cubic feet (fresh food + freezer)	About 14 to 22 cu. ft.
Upright freezer	Total freezer-only cubic feet	About 12 to 21 cu. ft.

Why it matters

Capacity is used for fit and storage planning, but it also affects cooling performance expectations. A top-mount refrigerator like the Kenmore 25371132105 splits space between the refrigerator and freezer, so its “total cu. ft.” is not comparable to an upright freezer’s “all-freezer” capacity.

Related help if you are troubleshooting instead of measuring

If your question is really about a display code or cooling issue, start with Kenmore 253 series french door refrigerator error codes for common code meanings and next steps.

Last updated: January 2026

Most Kenmore refrigerators, including model 25371132105, typically last 12 to 15 years with normal household use. Consistent cleaning, good airflow around the cabinet, and fixing small issues early are the most reliable ways to reach (or beat) that range.

What affects lifespan the most

• Ventilation and airflow: keep condenser area clear so the sealed system does not run hot.
• Stable power supply: low voltage can stress the compressor over time.
• Door seal condition: a leaking gasket forces longer run times and adds wear.
• Coil and fan cleanliness: dust buildup raises operating temperatures.
• How it is used: frequent door openings and warm food loads increase run time.

Maintenance checklist we recommend

• Vacuum dust from the condenser area and surrounding floor space.
• Confirm doors close fully and do the “paper test” around the gasket.
• Keep interior vents unblocked so cold air can circulate.
• Use a grounded outlet (avoid extension cords and adapter plugs).
• Review the care and safety guidance in the 25371132105 owner's manual.

Quick reference: lifespan vs. what you can control

Item	Typical impact on lifespan	What to do
Dirty condenser area	Shortens lifespan	Clean dust regularly
Weak/warped door gasket	Shortens lifespan	Inspect and replace if leaking
Poor airflow around cabinet	Shortens lifespan	Leave space for ventilation
Stable temperatures and settings	Extends lifespan	Use recommended control settings

Why it matters

A refrigerator that runs longer to hold temperature puts more load on key components like the compressor and fans. Simple upkeep reduces run time, helps food stay at safe temperatures, and lowers the chance of expensive sealed-system repairs.

Last updated: January 2026

Kenmore model 25371132105 is a Kenmore-branded top-mount refrigerator built for Sears; the 253 model prefix identifies the original manufacturer as Frigidaire (Electrolux) for this unit. For model-specific identification details, we recommend checking the serial plate location and information in the 25371132105 owner's manual.

How to confirm it on the refrigerator

You can verify the manufacturer code by locating the model and serial tag inside the fresh food compartment (the manual notes the serial plate is inside the refrigerator compartment).

• Open the refrigerator door and look along the side wall or ceiling area
• Confirm the model number starts with 253
• Record the full model and serial number for parts matching
• Use the manufacturer prefix when comparing compatible parts (ice maker, door gasket, fan blade)

Why the manufacturer matters for parts

Kenmore is the brand on the door, but the original manufacturer determines the engineering platform and many compatible replacement parts.

• Helps match the correct style of ice maker components
• Helps identify the correct door gasket profile and fit
• Helps narrow down electrical and cooling-system components
• Reduces returns caused by “looks similar” parts

Quick reference

What you see	What it means	Why it helps
Model prefix 253	Built by Frigidaire (Electrolux) for Kenmore	Better parts compatibility matching
Serial plate inside refrigerator compartment	Official ID location	Confirms exact model/series

Related maintenance tip

If you are troubleshooting cooling or ice production issues after identifying the platform, start with the basics (airflow, temperatures, and door sealing). For door sealing help, see how to fix a fridge door seal.

Last updated: January 2026