Kenmore Elite 10657863801 side-by-side refrigerator Parts

To reset your Kenmore Elite side-by-side refrigerator model 10657863801, do a simple power reset: turn the temperature control(s) OFF, unplug the refrigerator for about 5 minutes, then plug it back in and return the controls to your normal settings. See the owner's manual for the exact control locations and button names.

• Power reset (recommended): Set controls to OFF, unplug for 5 minutes, plug back in, then set temperatures.
• Control panel sound/feature reset: Press and hold ICE and TEMP together for 3 seconds to toggle control and dispenser sounds off or back on.
• Dispenser lock toggle: Press and hold TEMP and LOCK together for 3 seconds to turn the lock on or off.

1. Turn the refrigerator control (and freezer control, if separate) to OFF.
2. Unplug the power cord from the wall outlet (do not use an extension cord).
3. Wait 5 minutes.
4. Plug the refrigerator back in.
5. Set the control(s) to your desired temperature settings.

• Confirm the dispenser is not locked (TEMP + LOCK for 3 seconds).
• If water flow is weak, replace the refrigerator water filter EDR3RXD1.
• If the filter will not seat or leaks, inspect the refrigerator water filter housing WPW10121138.
• If ice is clumping or not dispensing, check the ice bin and chute door for frost buildup.

A proper reset on model 10657863801 starts with turning controls OFF before disconnecting power; this prevents accidental setting changes and helps the control system restart cleanly.

Last updated: February 2026

The cubic-foot capacity depends on the exact Kenmore Elite model. For Kenmore Elite model 10657863801 (side-by-side), the capacity is listed in the specifications section of the owner's manual; use that value because other Kenmore Elite models (including French door units) can be a very different size.

“Kenmore Elite” is a series name, not one single refrigerator size. A capacity quoted for a different model (for example, a 30+ cu. ft. French door) will not match a side-by-side like 10657863801.

Common differences by style:

• Side-by-side models typically have less total cubic feet than extra-wide French door models
• Usable space can change with ice maker and dispenser configurations
• Shelf and bin layouts affect how much you can actually store

Check these spots:

• The specifications page in the owner's manual
• The model and serial tag inside the fresh food compartment (often on a side wall)
• The parts list for your model on this page, then compare to the spec section in the manual

If you are comparing sizes while shopping or planning a move, these are common ranges:

These parts do not change the official “cubic feet,” but they can change how much you can fit day to day:

• Refrigerator shelf WPW10276348 (shelf layout and spill-safe design)
• Refrigerator door bin WPW10160952 (door storage capacity)
• Refrigerator ice bin WPW10191430 (freezer storage taken up by ice)

Knowing the correct cubic feet helps you plan cabinet clearance, grocery capacity, and storage organization. It also prevents ordering the wrong shelves, bins, or door parts for a different Kenmore Elite model.

You can order replacement parts for Kenmore Elite 10657863801 from the parts list for this model, or search by model number on Sears PartsDirect.

Last updated: February 2026

A bad compressor on Kenmore Elite side-by-side refrigerator model 10657863801 usually shows up as poor cooling with long run times, repeated clicking as it tries to start, or the unit running but never reaching temperature. First rule out normal “high-efficiency” run sounds and basic power or control issues using the owner's manual.

• Confirm the outlet has power and the cord is fully plugged in.
• Make sure the temperature controls are turned on and set correctly.
• If it is a new install or was recently moved, allow 24 hours to cool completely.
• Listen for normal operating sounds (pulsating or high-pitched sounds can be normal as the compressor and fans adjust).
• Check whether doors are closing fully; warm air leaks can mimic compressor problems.

• Clicking every few minutes with little or no cooling (often a start attempt that fails).
• Warm refrigerator and freezer even though the unit seems to be “trying” to run.
• Compressor extremely hot to the touch after repeated start attempts (use caution).
• No steady hum/vibration from the compressor area when cooling is needed.

Your model can run longer than older refrigerators because it uses a high-efficiency compressor and fans. Use this table to separate normal behavior from likely failure.

Replacing a compressor is a major sealed-system repair. Doing the quick checks above helps avoid replacing expensive parts when the real cause is a control setting, power issue, airflow problem, or a door not sealing.

If troubleshooting points to a temperature-sensing or control issue (not the sealed system), these model-matched parts are commonly involved:

• Refrigerator temperature sensor kit W10316760
• Refrigerator electronic control WPW10356039
• Refrigerator compressor W10355489

For ordering, use the parts list for model 10657863801 on this page, or search by model number on Sears PartsDirect.

Last updated: February 2026

On a Kenmore Elite side-by-side refrigerator model 10657863801, an ER CO error typically points to a communication problem between the main electronic control and the compressor circuit. A power reset and a quick wiring check often restore operation; if the code returns, a control-board or compressor-related repair is usually next.

• Power reset: Unplug the refrigerator (or switch off the breaker) for 5 minutes, then restore power.
• Confirm the outlet is correct: Use a grounded 3-prong outlet; avoid adapters and extension cords.
• Listen and look: After power is restored, note whether the compressor tries to start (hums/clicks) and whether interior lights and fans run.
• Check for obvious wiring issues: Inspect for pinched, loose, or damaged wires near the compressor area and control housing.
• Review model-specific troubleshooting steps: Use the owner's manual for the troubleshooting section and safety steps before servicing.

ER CO is most often triggered when the control cannot reliably “talk” to the compressor system. These are the most common repair paths:

If you suspect a control issue on this model, one common related part is the refrigerator electronic control WPW10356039.

When the control and compressor communication fails, the refrigerator may not cool correctly, which can lead to unsafe food temperatures. Addressing ER CO quickly helps protect the compressor and stabilizes fresh food and freezer temperatures.

• Refrigerator electronic control WPW10356039 (control logic and power management)
• Refrigerator compressor W10355489 (cooling system drive component)
• Wiring and connectors between the control and compressor area

You can order replacement parts for model 10657863801 from the parts list for this model, or search by model number on Sears PartsDirect.

Last updated: February 2026