How to restart a GE side by side refrigerator?
To restart your GE GSE25GGHECCC side-by-side refrigerator, we unplug it (or switch the breaker off) for about 5 minutes, then restore power. If it was in a normal restart or defrost condition, it should resume cooling shortly after power returns; some sounds during restart are normal.
- Unplug the refrigerator from the wall outlet (or turn the circuit breaker OFF).
- Wait 5 minutes (this lets the control reset and pressures equalize).
- Plug it back in (or turn the breaker ON).
- Confirm the interior lights and display come back on.
- Give the unit time to stabilize; cooling and fan operation may cycle as it returns to set temperature.
These checks match the most common “no operation” causes for this style of GE refrigerator.
- Make sure the power cord is fully seated in the outlet.
- Check the home fuse or breaker and reset if tripped.
- Verify the temperature controls are not set to OFF.
- If the refrigerator seems “on” but not cooling, allow about 30 minutes in case it is in a defrost cycle.
- If it appears to be in showroom mode, unplug and plug it back in to exit that mode.
After power is restored, it is normal to hear certain noises while the sealed system and fans ramp back up.
| Sound | What it usually means | Typical timing |
|---|---|---|
| Clicks or chirps | Compressor or control relays attempting to start | Up to about 5 minutes |
| Pops or cracks | Cooling coils expanding and contracting | During cool-down |
| Gurgling | Refrigerant equalizing | Right after restart |
A proper restart clears minor control glitches and lets the compressor restart safely. Waiting the full 5 minutes helps prevent rapid cycling, which can delay cooling and make the refrigerator seem “dead” even when it is working normally.
- Use the GSE25GGHECCC owner's manual for control settings, troubleshooting tips, and normal operating sounds.
- If you need replacement parts for cooling or dispenser issues (for example, a sensor or water filter), order from the parts list for this model or search by model number on Sears PartsDirect.
Last updated: February 2026
What is the most common problem with a GE refrigerator?
In our experience with GE side-by-side refrigerators like model GSE25GGHECCC, the most common complaint is inadequate cooling (fresh food too warm, freezer not holding temperature). The usual causes are restricted airflow, dirty condenser coils, or a failing cooling/defrost component; the GSE25GGHECCC owner's manual troubleshooting section helps you narrow it down fast.
- Make sure both temperature controls are not set to OFF.
- If the refrigerator just stopped, wait about 30 minutes in case it is in a defrost cycle.
- Confirm the unit is fully plugged in and the breaker is not tripped.
- Avoid overpacking; keep vents clear so cold air can circulate.
- Clean dust from condenser coils (a common cause of weak cooling and long run times).
If the quick checks do not help, these parts are frequent culprits for temperature problems on a side-by-side:
| Symptom you notice | Common cause | Example part for GSE25GGHECCC |
|---|---|---|
| Warm fridge, freezer OK or both warm | Airflow problem in the freezer section | Refrigerator evaporator fan motor WR60X10307 |
| Frost buildup, warming over days | Defrost system not clearing ice | Refrigerator defrost heater WR51X10055 |
| Temps swing, food freezing then warming | Sensor feedback issue | GE profile refrigerator temperature sensor WR55X10025 |
When cooling is weak, the compressor can run longer than normal, food safety becomes a concern, and ice maker and water dispenser performance often drops. Catching airflow and defrost issues early prevents heavier wear on the sealed system.
- Use our GE refrigerator error codes reference if your display shows a code.
- If cooling issues are tied to dispenser or ice production, follow how to prevent water dispenser and ice maker problems.
We recommend matching parts by the full model number GSE25GGHECCC to avoid fit issues. You can order model-matched replacement parts from the parts list for this refrigerator, or search by model on Sears PartsDirect.
Last updated: February 2026
How do I find the model number on my GSE25GGHECCC?
For your GE GSE25GGHECCC side-by-side refrigerator, the model number is printed on the rating label inside the fresh food (refrigerator) compartment; it’s located at the top on the right side. Use that exact model number when ordering parts or checking specifications in the owner's manual.
- Open the refrigerator (fresh food) door, not the freezer door
- Look along the upper interior area on the right side
- Find the label that lists both Model # and Serial #
- Write the numbers down exactly as shown (including any letters)
- Take a clear photo of the label for future reference
Having the correct model and serial number ensures you get the right GE refrigerator parts and instructions.
| You need | Where it’s used | Example of why it matters |
|---|---|---|
| Model number (GSE25GGHECCC) | Parts lookup and diagrams | Confirms the correct water filter style |
| Serial number | Service history and production details | Helps match revisions for certain components |
GE often uses similar-looking designs across multiple side-by-side models; one character difference in the model number can change which parts fit (for example, a water filter, control board, or door gasket).
- GE refrigerator water filter MWFP for water and ice quality
- Refrigerator electronic control board WR55X40445 for temperature and defrost control
- Refrigerator freezer door gasket WR24X10156 for sealing and preventing frost
Last updated: March 2026





