Kenmore 11088752796 stacked laundry center Parts

Kenmore model 11088752796 is a 24-inch (61 cm) wide stacked laundry center (washer with electric dryer). For the most accurate overall dimensions and required clearances for your space, we recommend confirming the full measurement diagram in the 11088752796 owner's manual.

What “size” means for this model

This model is commonly described by its cabinet width (24 inches), but you may also need depth, height, and clearance for venting and hookups.

• Width: 24 in (61 cm)
• Type: stacked laundry center (top-load washer paired with electric dryer)
• Space planning: allow room for water hoses, drain, and dryer venting
• Floor requirement: sturdy, level surface (important for dryer tumbling and sensor cycles)

Quick sizing and clearance checklist

Use this list when measuring your laundry area:

• Measure the opening width at the narrowest point (trim can reduce clearance)
• Measure depth including space for the exhaust vent elbow behind the dryer
• Confirm height clearance for the lid/controls and any shelving above
• Verify hot and cold faucets are within about 4 ft of the fill valves
• Check the floor is level (a slope can affect dryer performance)

Typical measurements to record (before you buy parts or move the unit)

Measurement	What to measure	Why it matters
Width	Side-to-side across cabinet	Confirms 24-inch fit
Depth	Front to back including vent space	Prevents crushed venting
Height	Floor to top of cabinet	Avoids overhead interference
Rear clearance	Space behind dryer for vent elbow	Helps airflow and drying

Why it matters

Correct sizing prevents installation headaches and helps the dryer vent properly; restricted venting can cause long dry times and overheating. A level, supported installation also reduces vibration and improves cycle performance.

Last updated: February 2026

The dryer capacity for Kenmore stacked laundry center model 11088752796 is typically in the standard to large range for 24-inch laundry centers (often about 3.4 to 3.8 cu. ft.). For the exact rated capacity for your unit, we recommend checking the specifications section in the 11088752796 owner’s manual.

How to confirm the exact capacity on your unit

Capacity is usually listed in the product specifications, feature list, or model information section.

• Look for “Dryer capacity” or “Capacity (cu. ft.)” in the specs pages
• Check the model/serial tag on the unit to confirm you have 11088752796
• If the manual lists multiple related models, match the exact model number
• If you are comparing dryers, measure the drum size only as a rough reference (not an official rating)

Typical capacity ranges (what to expect)

Most 24-inch wide, stacked laundry centers like this Kenmore model are designed for smaller spaces and use a smaller drum than full-size 27-inch dryers.

Dryer type	Typical capacity range	Best for
24-inch laundry center dryer	3.4 to 3.8 cu. ft.	Everyday loads, smaller households
Full-size 27-inch dryer	6.5 to 7.4+ cu. ft.	Large loads, bedding, big families

Why it matters

Knowing the correct capacity helps us recommend the right cycle settings and loading level so clothes dry evenly, airflow stays strong, and dry times stay reasonable. Overloading a smaller-capacity laundry center dryer is a common cause of long dry times.

Last updated: February 2026

To reset the washer in your Kenmore stacked laundry center model 11088752796, unplug it (or switch off the breaker) for 5 minutes, then restore power and restart a cycle. This clears many temporary control and cycle interruptions.

Quick reset steps (power reset)

• Turn the washer OFF by pushing in the cycle control knob.
• Unplug the laundry center (or turn OFF the dedicated breaker).
• Wait 5 full minutes.
• Restore power.
• Close the lid, select a cycle, then pull out the cycle control knob to start.

For model-specific control locations and cycle details, use the 11088752796 owner's manual.

If the washer is stuck mid-cycle

Sometimes you do not need a full reset; you can stop and restart the cycle using the timer control.

• To stop: push in the cycle control knob.
• To restart: close the lid and pull out the cycle control knob.
• If you used Soak, set the timer to a SPIN setting to drain and spin out the water.

Common “stuck” symptoms and what to do

What you see	What it usually means	What to try first
Won’t start after selecting a cycle	Power or lid not fully closed	Power reset; close lid firmly
Pauses for a couple minutes	Normal cycle pause	Wait; do not reset
Full of water after Soak	Soak holds water until you choose SPIN	Set to SPIN and pull knob out

Why it matters

A power reset restores the washer’s starting state and helps clear minor electrical glitches. Using the timer knob correctly (stop, restart, SPIN after Soak) prevents unnecessary part replacement and gets the load finished faster.

Last updated: February 2026

Your Kenmore stacked laundry center model number is printed on the appliance ID label; for this unit, the model is 11088752796. On most Kenmore top-load washer sections, you will find the label under the washer lid, around the lid opening, or on the back panel. Use the model number to match the correct parts and manual.

Where to look on model 11088752796

Check these common label locations first (power off is fine, but you do not need to disassemble anything):

• Under the washer lid, along the rim of the tub opening
• On the underside of the washer lid
• On the back of the laundry center cabinet near the power cord
• Inside the lower access panel area (if your unit has a removable panel)

For diagrams and model identification details, use the 11088752796 owner's manual.

What the model number looks like (and why it matters)

Kenmore laundry centers commonly use a numeric model format. For this model, you are looking for 11088752796 (11 digits). The model number is what we use to ensure part compatibility for the washer and dryer sections.

Model number vs. other numbers

You might see	Example format	What it’s used for
Model number	11088752796	Correct parts lists, diagrams, manuals
Serial number	Letters and numbers	Manufacturing tracking, service history
Part number	3366877	Identifies a specific replacement part

Quick tips to avoid ordering the wrong part

• Copy the model number exactly as printed (all digits)
• If the label is worn, take a clear photo and zoom in
• Match parts by model first, then confirm by part name and symptom
• If you are fixing a washer agitation issue, a common wear item is the agitator dog 80040

Why it matters

Kenmore model numbers can look similar across different laundry centers, but internal components (like the drive system, drain pump, or timer) can vary. Using 11088752796 keeps your repair aligned with the correct Kenmore configuration.

Last updated: February 2026