Kenmore Elite 66514754N512 dishwasher Parts

For the Kenmore Elite dishwasher shown on this page, the model number is 66514754N512. “SmartWash” and “Quiet Pack 4” describe features or a series; the exact model number is the full identifier you use to match the correct parts list and the right Use and Care information in the 66514754N512 owner's manual.

Use the model tag on the unit to confirm you are matching the right Kenmore Elite dishwasher.

• Open the dishwasher door and look along the inner door edge
• Check the tub frame near the latch area
• Look for a sticker that lists MODEL and SERIAL
• Write the model number exactly as shown (including all digits)
• Use that exact model number when ordering parts like a door latch, drain pump, or heating element

Those names help describe the dishwasher’s cycle logic and sound package, but they are not specific enough to guarantee parts compatibility.

Kenmore 665-series dishwashers can look similar but use different racks, controls, pumps, and door hardware. Using 66514754N512 prevents ordering the wrong component and helps you troubleshoot correctly using the right cycle and option descriptions.

Once you confirm 66514754N512, order replacements from the parts list for this model, or search by model number on Sears PartsDirect.

Last updated: February 2026

To hard reset your Kenmore Elite dishwasher model 66514754N512, we use the control reset sequence: press START/RESUME, then press and hold CANCEL/DRAIN twice to reset the control, then reselect a cycle and press START/RESUME again (close the door within 3 seconds). See the exact steps in the owner's manual.

1. Open the door slightly to stop the cycle; wait for spraying to stop.
2. Open the door fully.
3. Press START/RESUME.
4. Press and hold CANCEL/DRAIN twice to reset the control.
5. Select your new cycle and options.
6. Press START/RESUME and close the door within 3 seconds.

• Make sure the door is fully latched; a loose latch prevents starting.
• Close the door within 3 seconds after pressing START/RESUME.
• If water is in the bottom, run CANCEL/DRAIN and let it drain fully (the light can stay on up to about 2 minutes).
• Check for a stuck key or unresponsive console; a reset will not fix a physically damaged keypad.
• If the door will not “click” shut, inspect the dishwasher door latch WPW10653840.

On 66514754N512, a hard reset is a control reset that clears the current cycle and lets you start fresh. It is different from turning power off at the breaker; the manual’s reset procedure is the fastest way to recover from a stalled cycle or unresponsive buttons.

Resetting correctly prevents partial washes, helps the dishwasher drain when needed, and avoids “won’t start” situations caused by the door not being closed in time after pressing START/RESUME.

You can order replacement parts for your Kenmore dishwasher from the parts list for model 66514754N512, or search by model on Sears PartsDirect.

Last updated: February 2026

For the Kenmore Elite dishwasher model 66514754N512, the overall size follows the standard built-in dishwasher footprint: about 24 inches wide, 34 to 35 inches tall (adjustable legs), and 24 inches deep to the front of the door. For the exact cutout and clearance specs, use the installation guide.

Most Kenmore built-in dishwashers in this series are designed to fit a standard 24-inch cabinet opening. Height is the dimension that varies most because leveling legs and countertop clearance affect the final fit.

• Width: typically ~24 inches (fits a 24-inch opening)
• Height: typically ~34 to 35 inches (adjustable)
• Depth: typically ~24 inches (door/front depth can vary with handle style)
• Cutout clearance: allow room for water line, drain hose, and power routing
• Leveling matters: a slightly unlevel unit can change door alignment and rack glide

Use this checklist before you order parts or plan an install.

• Measure the cabinet opening width at the front and back
• Measure height from floor to underside of countertop at left, center, and right
• Confirm the dishwasher can slide out without hitting flooring transitions
• Verify the door can open fully without contacting adjacent cabinets
• Confirm hose and cord routing space (rear or side channel)

Correct dimensions prevent installation problems like a door that rubs, racks that do not slide smoothly, or a unit that cannot be leveled properly. A proper fit also helps reduce vibration and improves wash performance.

If you are correcting door alignment, rack movement, or a door that will not close smoothly, these model-matched parts are often involved:

• Dishwasher door latch WPW10653840
• Dishwasher door balance link 8194001
• Dishwasher rack adjuster W10712395

For additional replacement parts by model number, search on Sears PartsDirect.

Last updated: February 2026

A Kenmore Elite dishwasher typically lasts 10 years with normal household use. For your Kenmore Elite 66514754N512, consistent cleaning, proper loading, and fixing small issues early (like rack roller wear or draining problems) are what most often determine whether it reaches that full service life.

Most dishwashers reach their full lifespan when the wash system stays clean and water can heat, circulate, and drain correctly.

• Water quality: hard water speeds up mineral buildup on the heater and inside the sump
• Maintenance: routine cleaning helps protect the pump, diverter, and filtration system
• Loading habits: overloading can block spray arms and reduce cleaning performance
• Drying setup: using rinse aid improves drying and helps reduce deposits (noted in the installation information)
• Small part wear: rack adjusters and rollers often fail before major components

These symptoms often show up as a dishwasher approaches the end of its useful life. Use the troubleshooting steps in the owner's manual to narrow down the cause.

Replacing a few wear items can keep the 66514754N512 running smoothly and prevent bigger problems.

• If the upper rack won’t adjust or feels loose, the dishwasher rack adjuster W10712395 is a common fix.
• If the lower rack binds or falls off track, the dishwasher dishrack roller assembly, lower WPW10195417 often restores smooth rolling.
• If the unit has draining issues after clearing the hose and air gap, the dishwasher drain pump WPW10531320 is a frequent repair part.

A dishwasher that is designed for energy efficiency can run longer cycles (often 2 to 3 hours per load) to clean well while using less energy. Keeping the wash system clean and the racks moving correctly helps you get those results for the full expected lifespan.

You can order replacement parts for your Kenmore Elite 66514754N512 from the parts list for this model, or search by model number on Sears PartsDirect.

Last updated: February 2026

On Kenmore Elite dishwasher model 66514754N512, the E15 error means the leak-protection system detected water in the base pan, so the dishwasher stops normal operation to prevent overflow. Drying the base can clear the code, but you still need to find and fix the leak.

• Turn off power at the breaker.
• Shut off the water supply to the dishwasher.
• Remove the toe-kick and check the base pan for water.
• Towel-dry the base pan (or use a wet/dry vac), then let it air-dry.
• Restore power and run a short cycle to see if E15 returns.

Start with the most frequent sources on 665-series dishwashers:

• Fill system: loose supply connection or a seeping dishwasher water inlet valve WPW10327249
• Drain system: split or loose drain line such as dishwasher drain hose 8269144A
• Sump and pump seals: leaking seal or connection at the dishwasher pump grommet WPW10538166
• Door closure: door not closing tightly due to a worn dishwasher door latch WPW10653840

When E15 is active, the dishwasher is preventing a larger leak by stopping the wash (and often trying to drain). Clearing the water resets the protection, but the code returns until the leak source is corrected.

• Use the 66514754N512 installation guide for safety steps and access-panel removal basics.
• For more code meanings and what they point to, see Kenmore 665 model dishwasher error codes.
• Order model-matched replacement parts from the parts list for 66514754N512, or search by model on Sears PartsDirect.

Last updated: February 2026