Owner’s manual
Error Codes
How many cubic feet is a Whirlpool model GS6SHAXMB00?
The Whirlpool GS6SHAXMB00 side-by-side refrigerator is typically in the 25 cu. ft. class (about 25.4 cu. ft. total capacity). For the exact capacity listing tied to your unit’s configuration, confirm it in the GS6SHAXMB00 owner's manual.
Capacity can vary slightly by configuration and how manufacturers report usable space. The most reliable places to verify are:
- The specifications section in the GS6SHAXMB00 owner's manual
- The model and serial tag inside the fresh food compartment
- The product data sheet section (often included in the manual PDF)
“Cubic feet” is the total interior volume rating. It does not tell you exactly how much food fits once shelves, bins, the ice bucket, and the water filter housing take up space.
| Total capacity class | Typical use case | What you’ll notice |
|---|---|---|
| 22 to 24 cu. ft. | Smaller households | Less freezer bin space |
| 25 to 26 cu. ft. | Most families | Balanced fridge and freezer storage |
| 27+ cu. ft. | Heavy grocery loads | More door bin and shelf flexibility |
Knowing the capacity helps when you are comparing replacement refrigerators, planning kitchen space, and choosing storage accessories (bins, ice container size, and shelf layout). It also helps set realistic expectations for freezer space if the ice maker is installed.
Last updated: January 2026
How wide is a 24.5 cu ft refrigerator?
Most 24.5 cu. ft. refrigerators are built in the “full-size” class and typically measure about 33 to 36 inches wide. For your Whirlpool GS6SHAXMB00 side-by-side refrigerator, we recommend confirming the exact cabinet width and required clearances in the GS6SHAXMB00 owner's manual.
Capacity alone does not lock in one width; door style and depth matter most.
- Standard-depth side-by-side: commonly 35 to 36 inches wide
- Standard-depth French door: commonly 35 to 36 inches wide
- Counter-depth designs: often 32 to 34 inches wide (varies by brand and layout)
- “33-inch class” models: can still reach 24 to 25 cu. ft. with different interior layouts
Even if the cabinet is 33 to 36 inches wide, you need extra room for airflow and door swing. The Whirlpool GS6SHAXMB00 manual calls out these common clearance guidelines:
- Allow about 1/2 inch on each side and at the top for ventilation
- If installed next to a fixed wall, allow about 2 inches minimum on the hinge side so the door can swing open
- Leave extra space at the back if you have an ice maker and water line connection
| Advertised class | Typical actual width | Best for |
|---|---|---|
| 36-inch refrigerator | ~35.5 to 36 inches | Most standard-depth kitchens |
| 33-inch refrigerator | ~32.5 to 33.5 inches | Tighter openings, some counter-depth |
| Counter-depth (varies) | ~32 to 34 inches | Flush look with cabinets |
A refrigerator that is “almost” the right width can still bind against cabinets, fail to open fully near a wall, or run warmer if airflow is restricted. Measuring the opening and following the manual’s clearance guidance prevents fit and performance problems.
Last updated: January 2026
Where is the water filter on a side-by-side whirlpool refrigerator?
On the Whirlpool GS6SHAXMB00 side-by-side refrigerator, the water filter is located in the base grille at the bottom front of the unit. You access it from the front by opening the grille area and removing the filter cartridge as described in the GS6SHAXMB00 owner's manual.
Most GS6SHAXMB00 units use a base grille (toe-kick) filter that releases when you lift or unlatch the filter cover.
- Look at the bottom front of the refrigerator for the base grille.
- Locate the round or capsule-style filter cartridge behind the grille.
- Use the “lift up to remove” tab or cover (if your grille has one).
- Pull the filter straight out once it releases.
- Install the new filter by pushing it in firmly until it seats.
- Reset the filter status light (if your model has one).
The manual describes two common reset methods used on this platform.
| Reset style | What you do | Where you do it |
|---|---|---|
| Style 1 | Press the light switch 5 times within 10 seconds | Refrigerator compartment light switch |
| Style 2 | Press and hold the water filter reset button until the status light turns green | Dispenser area or control panel |
If your refrigerator does not have a filter indicator light, we replace the filter every 6 to 9 months, or sooner if water flow drops.
A stuck filter or slow dispenser flow is usually caused by pressure, a clogged cartridge, or an installation issue.
- Dispense water for a few seconds to relieve pressure, then try again.
- Make sure the cartridge is fully seated and aligned.
- Check for kinks in the home water line behind the refrigerator.
- Confirm the shutoff valve is fully open.
- If you’re troubleshooting repeated dispenser or ice maker issues, use how to prevent water dispenser and ice maker problems.
A correctly installed, regularly changed water filter helps maintain normal water flow to the dispenser and ice maker, and it reduces the chance of air in the lines and leaking at the dispenser.
Last updated: January 2026
