Kenmore 10652542101 side-by-side refrigerator Parts

For your Kenmore side-by-side refrigerator model 10652542101, the most reliable way to confirm cubic-foot capacity is to look it up by model number in the 10652542101 owner's manual. If you need a quick estimate, you can calculate capacity by measuring the usable interior space and converting cubic inches to cubic feet.

• Check the model/serial label inside the fresh food compartment (commonly on a side wall or ceiling) and confirm it matches 10652542101.
• Look up the capacity in the specifications section of the 10652542101 owner's manual.
• If you are missing shelves/bins or have heavy frost buildup, measure after clearing obstructions so your estimate reflects usable space.
• For a rough estimate, measure the main open cavity areas (not door bins) and add them together.

Use this formula for each compartment (refrigerator side and freezer side), then add them:

• Measure width x height x depth in inches (usable interior space).
• Multiply to get cubic inches.
• Divide by 1,728 to convert to cubic feet.

Knowing cubic-foot capacity helps us match the right refrigerator parts and accessories (like shelves, bins, and ice maker components) and it also helps you compare storage space when planning food storage or replacement.

Last updated: January 2026

Most Kenmore side-by-side refrigerators are about 32 to 36 inches wide. For your specific Kenmore model 10652542101, the exact cabinet width and required clearance are listed in the 10652542101 owner's manual; we also recommend planning for extra space so the doors can swing fully.

Most side-by-side units fall into these common width bands:

• 32 to 33 inches: space-saving models
• 35 to 36 inches: most common full-size width
• 42 inches: larger, premium-width models (less common)

Even if the cabinet width fits, you also need room for airflow and door swing. The Kenmore documentation calls out these common clearance needs:

• Allow about 1/2 inch on each side and at the top for ventilation
• If installed next to a fixed wall, allow about 2 inches minimum on the hinge side (varies by setup) so the door can open
• Leave extra space behind the refrigerator if you have an ice maker water line

For the exact clearance diagram and your model’s measurements, use the 10652542101 installation guide.

Width is only part of “will it fit.” Side-by-side doors need swing room, and tight clearances can reduce airflow, which can hurt cooling performance and increase run time for the compressor.

Last updated: January 2026

On Kenmore model 10652542101, the Er IF code points to an ice fan (ice compartment fan) airflow problem. That fan moves freezer air through the door ducting to keep the ice maker area cold; when airflow stops, ice production and dispensing can be affected.

• Power reset: unplug the refrigerator (or turn off the breaker) for 5 minutes, then restore power.
• Make sure the freezer door closes fully and the door gasket seals all the way around.
• Clear ice or frost buildup around the ice bin area and air passages.
• Confirm the freezer temperature is set correctly (typical target is 0°F).
• Listen for a small fan running when the freezer door switch is pressed (door closed simulation).

Er IF is usually caused by restricted airflow or a fan that is not running at the right speed.

If you suspect a defrost-related frost buildup, the parts most often involved are the defrost thermostat and heater. For this model, examples include the refrigerator defrost bi-metal WPW10225581 and the refrigerator heater WP2323198.

When the ice fan cannot move cold air through the door ducting, the ice maker compartment warms up. That leads to soft cubes, clumping, slow production, and repeated error codes.

Use the troubleshooting and control information in the 10652542101 owner's manual to locate the ice maker/ice bin area, confirm control settings, and follow the recommended checks for airflow and door sealing.

Last updated: January 2026