Kenmore Elite 79036723601 gas range Parts

A Kenmore Elite gas range like model 79036723601 typically lasts 15 years with normal household use. Consistent cleaning, correct burner flame adjustment, and fixing ignition or heating problems early help you reach that lifespan; see the maintenance guidance in the owner's manual.

Typical lifespan and what affects it

Most ranges hit their expected service life when they are kept clean, properly installed, and not run with unresolved ignition or temperature issues.

• Heavy daily cooking shortens life; light use extends it
• Grease buildup and spills accelerate wear on igniters, valves, and controls
• Poor burner flame adjustment can cause hard lighting and soot
• Overheating from restricted airflow can stress wiring and thermostats
• Repeated “clicking” ignition attempts can wear ignition components faster

Maintenance that helps you get the full 15 years

We recommend these habits for Kenmore gas stoves:

• Keep burner caps and ports clean and dry after boilovers
• Wipe the control panel area with a non-abrasive cleaner
• Use a vent hood and keep its filter clean to reduce grease buildup
• Avoid lining the oven bottom with foil (it can trap heat and affect baking)
• Address slow ignition quickly so the burner does not “whoosh” or delay-light

Quick check: surface burner ignition timing

Your installation instructions note that each surface burner should light within about 4 seconds after air is purged from the gas supply lines. If lighting is consistently slower, cleaning and flame adjustment are the first steps; persistent issues often point to an ignition or gas delivery problem.

Parts that commonly impact performance over time

If your range is otherwise in good shape, replacing a worn component can restore safe, reliable operation.

Symptom	Common area to check	Example part on this model page
Oven won’t heat or takes too long to ignite	Oven burner ignition	Igniter 5303935066
Oven temperature swings or seems inaccurate	Temperature sensing	Frigidaire range oven temperature sensor 316217002
Surface burners keep clicking or won’t spark reliably	Spark system	Cooktop spark module 5304505695

Why it matters

A 15-year lifespan assumes the range is operating efficiently. When ignition is slow or temperatures are unstable, you often use the appliance longer per meal, which increases heat stress on components like the thermostat, wiring, and controls.

Last updated: February 2026

On the Kenmore Elite gas range model 79036723601, the model and serial number are printed on the serial plate located on the oven front frame behind the oven door (some versions place it on the drawer side frame). Confirm the exact spot using the installation guide.

Where to look on the range

Check these common label locations on model 79036723601:

• Open the oven door and look along the front frame (the face frame around the oven opening).
• Look behind the oven door on the front frame for the serial plate.
• If you do not see it there, pull out the bottom drawer and check the drawer side frame.
• Use a flashlight; the plate can be easy to miss if it is low or partially shadowed.

What information to copy from the serial plate

When you find the plate, record these items exactly as shown:

• Model number (for this page: 79036723601)
• Serial number
• Lot number or letter (if listed)
• Fuel type and pressure rating (helpful for gas setup and parts matching)

Quick checklist: door frame vs drawer frame

Location	What to do	When it is most likely
Oven front frame (behind oven door)	Open door fully; inspect the front frame edges	Most common placement
Drawer side frame	Slide out the bottom drawer; check both sides	Some versions of this range

Why it matters

We use the model and serial number to match the correct Kenmore parts and diagrams for your exact build. That prevents ordering the wrong igniter, temperature sensor, or control component for your range.

Ordering parts once you have the model number

After you confirm the model number, you can order parts from the list for model 79036723601 on this page, or search by model number on Sears PartsDirect.

Last updated: February 2026

Kenmore ranges with model numbers that start with 790 (including Kenmore Elite 79036723601) are built for Kenmore by Frigidaire (Electrolux family). Use the full model number from the serial plate to match the correct parts and follow the right service information in the 79036723601 owner's manual.

How the 790 prefix helps identify the maker

Kenmore uses a model-number prefix system; the first three digits point to the manufacturing source.

• 790 prefix: Frigidaire-built (Electrolux platform)
• The remaining digits identify the exact configuration and finish
• Always use the complete model number (not just 790) when ordering parts
• The serial plate on the range shows the official model and serial number

Why it matters for parts and troubleshooting

The manufacturer platform affects component style, wiring layout, and which replacement parts fit.

• Parts may be branded Kenmore, but the design matches Frigidaire-built ranges
• Common heat-related repairs often involve ignition or temperature sensing
• Using the correct platform helps you choose the right diagnostic steps and parts

Quick reference

What you see	What it means	What to do
Model starts with 790	Built for Kenmore by Frigidaire (Electrolux family)	Match parts using 79036723601
Oven not heating or slow to preheat	Often an ignition issue	Check the igniter 5303935066
Temperature swings or inaccurate baking	Often a sensing issue	Check the frigidaire range oven temperature sensor 316217002

Where to confirm your exact model

Check the serial plate on the range and compare it to the identification section in the 79036723601 owner's manual. That exact model number is what we use to ensure proper fit for igniters, sensors, valves, and control parts.

You can also search by model number on Sears PartsDirect when you need to compare diagrams or find additional replacement parts.

Last updated: February 2026