How much does a Kenmore side by side refrigerator weigh?
Most Kenmore side-by-side refrigerators weigh about 250 to 320 lb when empty; your Kenmore 25354669405 is typically in that same range. For the exact shipping and installed weight for your specific unit, check the specifications section in the owner's manual.
Typical weight ranges (what to expect)
Side-by-side refrigerator weight varies mainly by cabinet size, dispenser hardware, and insulation.
- Empty (installed) weight: ~250 to 320 lb
- Shipping weight (boxed): usually 10 to 30 lb higher than empty weight
- With food and ice: often +50 to 150 lb depending on how full it is
- With doors removed: typically 20 to 60 lb lighter (helps for tight doorways)
Why the exact weight matters
Knowing the correct weight helps prevent floor damage and makes moving safer.
- Confirms if your flooring and dolly are rated appropriately
- Helps plan how many people you need for moving
- Reduces risk of door, hinge, and cabinet damage during transport
Quick planning guide
| Situation | What we recommend | Why |
|---|---|---|
| Moving across a room | 2 people + appliance dolly | Better control and less tipping risk |
| Stairs involved | 3 to 4 people + straps | Side-by-sides are tall and top-heavy |
| Tight doorway | Remove doors per installation guide | Prevents cabinet and trim damage |
Tips for moving a side-by-side safely
- Unplug the refrigerator and secure the power cord.
- Remove food, bins, and the ice container to reduce weight.
- Protect floors with plywood or a hard floor runner.
- Keep the refrigerator as upright as possible during transport.
- After moving, let it stand upright before plugging in (use the timing guidance in the owner's manual).
Last updated: February 2026
What is the code Sy Ef on a Kenmore refrigerator?
On Kenmore refrigerator model 25354669405, the SY EF (sometimes shown as Sy EF) code points to a problem in the freezer evaporator fan circuit, most often the evaporator fan not running or feedback not being detected. Start by checking for ice buildup or an obstruction, then verify the fan can spin freely.
What to check first (fast troubleshooting)
- Power reset: unplug the refrigerator for 5 minutes, then restore power.
- Listen for the freezer fan: you should typically hear airflow when the compressor is running.
- Look for frost or ice blocking airflow at the rear freezer panel.
- Check for a door left ajar or a torn door seal that can cause heavy frost.
- Confirm vents are not blocked by food packages.
Common causes and likely fixes
| What you notice | Most likely cause | What usually fixes it |
|---|---|---|
| Loud rubbing or ticking from freezer | Fan blade hitting ice | Defrost ice buildup; clear obstruction |
| Freezer cold but fresh food warm | Poor airflow from freezer | Clear vents; address frost pattern |
| SY EF returns after reset | Fan motor feedback issue or wiring issue | Inspect fan area and harness connections |
| Heavy frost on freezer back wall | Defrost system problem | Check defrost components and airflow |
If you find the fan blade damaged or wobbling, replacing the blade is a common repair for airflow-related errors; the correct blade for this model is the refrigerator evaporator fan blade 5308000010.
Why this matters
The evaporator fan moves cold air across the evaporator and circulates it through the freezer and fresh food sections. When airflow drops, temperatures drift, frost builds faster, and the control can flag SY EF.
Helpful references for this model
- Use the owner's manual for model-specific operating details and control settings.
- If you need to access the dispenser area during diagnosis, follow the steps in how to disassemble a Kenmore refrigerator dispenser.
Last updated: February 2026
Can you still get parts for Kenmore refrigerators?
Yes. We still carry replacement parts for Kenmore refrigerators, including model 25354669405. You can match parts by model number and then choose the exact component you need (for example, a water filter, door gasket, or water inlet valve) to restore proper cooling, sealing, and dispenser performance.
Best way to find the right part for Kenmore 25354669405
Use the model number to ensure the part fits your exact side-by-side refrigerator, then confirm the part name and ID before ordering.
- Match by model: 25354669405
- Use the diagrams to identify the failed component location
- Compare the part ID and description to your original part
- If you are replacing a filter, follow the change-out steps in the 25354669405 owner's manual
- Keep your old part until the repair is complete (helps confirm connectors and mounting)
Common parts customers replace on this model
These are frequent wear or failure items on side-by-side refrigerators like Kenmore 25354669405.
| Symptom | Likely part category | Example part on this model |
|---|---|---|
| Bad taste, slow water flow | Water filter | Genuine Kenmore refrigerator water filter WF2CB |
| No water to dispenser or ice maker | Water inlet valve | Refrigerator water inlet valve assembly 242252702 |
| Frost buildup, warm freezer | Defrost control parts | Refrigerator defrost bi-metal thermostat 5303918214 |
| Door not sealing, moisture | Door gasket | Refrigerator gasket (match side and color) |
Why it matters
Using the correct Kenmore part for 25354669405 helps prevent repeat issues like air leaks (warm temps and frost), dispenser problems (low flow or no ice), and unnecessary strain on the sealed refrigeration system.
Last updated: February 2026
Where is the model number on a Kenmore side by side refrigerator?
On Kenmore side-by-side refrigerator model 25354669405, the model number is printed on the serial plate located inside the refrigerator (fresh food) compartment. Open the refrigerator door and look along the interior walls near the front opening for the rating label.
Where to look (fast checklist)
- Inside the fresh food compartment (not the freezer)
- On the serial plate or rating label
- Along the side wall near the front edge (common location)
- Sometimes near the top interior area behind bins or shelves
- Use a flashlight and wipe condensation off the label to read it clearly
What you should see on the label
The Use and Care Guide notes the information is on the serial plate inside the refrigerator compartment. The model number format typically looks like this:
| Item on label | What it means | Example for this unit |
|---|---|---|
| Model number | Identifies the exact refrigerator design | 25354669405 |
| Serial number | Identifies your specific unit | Varies by unit |
| Purchase date (not on label) | Helpful for records | Your receipt |
Why it matters
We use the exact model number to match the correct Kenmore parts and diagrams for your refrigerator, especially for fit-critical items like a door gasket, water filter, or water inlet valve.
Helpful tip for parts and service info
Once you find the label, write the model and serial number down and keep it with your paperwork; the owner's manual also has a section for recording them.
Last updated: February 2026
How many cubic feet is a Kenmore Elite refrigerator?
Kenmore Elite refrigerator capacity depends on the exact model number; “Kenmore Elite” covers multiple sizes across side-by-side, top freezer, and French door designs. For your Kenmore 25354669405, the most accurate cubic-feet capacity is listed in the specifications section of the 25354669405 owner's manual.
How to find the cubic-feet capacity for your exact Kenmore Elite model
We recommend using the model number on the rating plate (inside the fresh food compartment) and then checking the specs in the manual.
- Locate the model number and serial number label inside the refrigerator compartment
- Open the specifications section in the manual and look for “capacity” or “total volume”
- If the manual lists separate volumes, add fresh food + freezer for total cubic feet
- Use the exact model number (for example, 25354669405) to avoid mixing up similar-looking Elite units
Typical capacity ranges (for quick comparison)
Most Kenmore Elite refrigerators fall into these common ranges; your exact number can vary by configuration and year.
| Refrigerator style | Typical total capacity (cu. ft.) | What that usually means |
|---|---|---|
| Side-by-side | 22 to 28 | Balanced freezer and fresh food space |
| French door | 25 to 33 | Larger fresh food section, wide shelves |
| Top freezer | 14 to 21 | Compact footprint, simpler layout |
Why it matters
Cubic feet affects how much food you can store, but it also impacts shelf and bin fit, water filter usage, and airflow needs. When ordering interior parts (bins, shelves, drawers), matching your exact model and configuration prevents sizing issues.
Related parts customers often match by model
If you are maintaining water and ice performance on a Kenmore 253-series refrigerator, these model-matched items are commonly replaced:
- Genuine Kenmore refrigerator water filter WF2CB (replacement cartridge 9911)
- Refrigerator water inlet valve assembly 242252702 (helps with weak dispenser flow or no ice)
- Refrigerator light bulb 316538904 (interior lighting)
Last updated: February 2026





