Kenmore Elite 40141009900 refrigerator Parts

Your Kenmore Elite model 40141009900 is a side-by-side refrigerator, not a washer. The capacity shown in the model chart in the 40141009900 owner's manual is 24.1 cu. ft., which is the total refrigerator storage volume (fresh food plus freezer).

Where to find the capacity for this model

The capacity is listed in the specifications chart in the manual for this Kenmore Elite side-by-side platform.

• Look for the “Capacity (Cu. Ft.)” line in the specs table
• Confirm you are referencing model 40141009900 (model number is on the rating label)
• Use capacity when comparing storage space and planning installation clearances

Quick spec snapshot (from the manual chart)

Spec	Value
Capacity	24.1 cu. ft.
Overall width	35 13/16 in.
Overall height	70 in.
Overall depth	30 in.

Why this matters

“Cubic feet” means very different things for washers versus refrigerators. For model 40141009900, the cubic-foot number is about food storage space, which helps when choosing door bins, shelves, and planning door swing and ventilation clearance.

Related parts that match common capacity and storage questions

If you are trying to restore usable space (ice buildup, warm temps, dispenser issues), these parts are commonly involved:

• Refrigerator temperature sensor DA32-10109W (helps regulate cooling)
• Refrigerator condenser fan DA31-00146B (supports heat removal for proper cooling)
• Samsung refrigerator ice maker assembly DA97-07549B (ice production and bin fill)
• Samsung refrigerator water filter HAFCU1 (water flow and taste)

Last updated: February 2026

On a Kenmore Elite side-by-side refrigerator like model 40141009900, a bad compressor usually shows up as poor or no cooling even though the unit has power, often with repeated clicking (start attempts) or the compressor running hot and never stabilizing temperatures.

Quick checks we use before blaming the compressor

• Confirm the refrigerator section is set near 37°F and the freezer near 0°F (typical targets).
• Listen at the back lower area: steady hum (running) vs. repeated click every few minutes (failed start).
• Check airflow: warm air should blow from the condenser area when running.
• Look for heavy frost on the evaporator cover inside the freezer (can indicate a defrost or airflow problem instead).
• Make sure doors are sealing and closing fully; these doors self-close when left less than about 3 inches open.
• Rule out water or ice issues as “cooling” symptoms; low water pressure affects ice and dispensing, not compressor cooling.

What the symptoms usually mean

Symptom	Most common cause	What to do next
Clicking, then silence; little or no cooling	Start device or compressor overload tripping	Test/inspect the start components; consider replacing the compressor overload protector if it is failing
Compressor runs constantly; still warm	Sealed system issue, weak compressor, airflow problem	Check condenser fan operation and condenser cleanliness first
No compressor sound at all; lights work	Control issue, start device, or compressor	Verify fans and controls; then electrical diagnosis

Parts that can mimic a “bad compressor” on this model

A compressor can be fine but unable to start or stay running if a supporting part fails. These parts are commonly involved:

• Refrigerator compressor overload protector DA34-00004D (protects the compressor from overheating and overcurrent)
• Refrigerator condenser fan DA31-00146B (moves heat off the condenser; poor airflow can cause overheating and shutdown)
• Refrigerator temperature sensor DA32-10109W (bad sensing can cause incorrect run behavior)
• Refrigerator electronic control board DA41-00649C (can prevent proper compressor operation)

Why it matters

Replacing a compressor or sealed-system components is a major repair. Verifying airflow, fans, sensors, and the compressor start protection first prevents unnecessary parts replacement and gets cooling restored faster.

For model-specific component locations and service access steps, use the owner's manual.

Last updated: February 2026

Common problems we see with the Kenmore Elite 40141009900 side-by-side refrigerator include warm temperatures (cooling failure), water leaks, and ice maker or dispenser issues. These often trace back to airflow restrictions, a defrost/drain problem, or a water supply issue; our owner's manual covers operating and care details.

Most common symptoms and likely causes

• Not cooling or weak cooling: blocked air vents, dirty condenser area, failing fan, or a temperature sensor issue
• Ice maker not making ice: low water pressure, frozen fill path, or an ice maker assembly problem
• Water leaking or puddles: clogged/iced drain system, mis-seated water line, or a drain tube grommet issue
• Door not sealing or popping open: door closer/hinge cam wear or door bin interference
• Noisy operation: condenser fan problems or ice buildup contacting the evaporator cover

Quick checks you can do first (no special tools)

1. Confirm the doors fully close and seal; this model uses automatic door closers when the door is within about 3 inches of closed.
2. Make sure interior vents are not blocked by food packages.
3. If the dispenser is slow or the ice maker is weak, verify household water pressure is in the 20 to 125 psi range.
4. If you see water under the unit or inside the fresh food section, inspect for a frozen or clogged drain path.
5. If ice production is inconsistent, remove and reinstall the ice bucket carefully (do not force it).

Parts that commonly solve these problems

Symptom	Part to consider	What it affects
Slow water, poor ice production	Samsung refrigerator water filter HAFCU1	Water flow and taste; restrictions can reduce dispenser and ice maker performance
Warm temps or erratic temps	Refrigerator temperature sensor DA32-10109W	Temperature feedback to the control system
Water leaks from drain area	Refrigerator drain tube grommet DA63-00951C	Helps seal and route drain water properly
Noisy or hot cabinet sides	Refrigerator condenser fan DA31-00146B	Moves air across condenser to remove heat
Ice maker not cycling	Samsung refrigerator ice maker assembly DA97-07549B	Ice harvest and fill functions

Why it matters

Cooling, ice, and leak complaints are usually connected: restricted airflow or a drain/defrost issue can cause ice buildup, which then reduces cooling and creates water overflow. Fixing the root cause prevents repeat failures and food spoilage.

Last updated: February 2026

On the Kenmore Elite side-by-side refrigerator model 40141009900, the model number is printed on the appliance identification label inside the refrigerator compartment; it is typically on a side wall near the fresh food section. Use the label information to match parts and the correct instructions in the 40141009900 owner's manual.

Where to look first (fast checklist)

• Open the fresh food (refrigerator) door and look along the inside side walls
• Check near the crisper drawers area and the lower side wall
• Look around the door frame area inside the refrigerator compartment
• Use a flashlight and wipe condensation or smudges off the label so it is readable
• Write down both the model number and serial number exactly as shown

What the label information is used for

The model number identifies the exact design version of your refrigerator so we can match the right Kenmore parts list and diagrams. The serial number helps identify production details that can affect part compatibility.

Label item	What it tells you	Why it matters
Model number (example: 40141009900)	Exact refrigerator configuration	Ensures correct parts fit and correct procedures
Serial number	Production identifier	Helps confirm version changes within a model

Why it matters

Kenmore side-by-side refrigerators can look similar across model families, but parts like a water filter, ice maker assembly, temperature sensor, or door bin can vary by model. Using the exact model number helps prevent ordering the wrong part and reduces repeat repairs.

Tip for parts matching once you find it

• Compare the model number on the label to the model shown on the parts page
• Use the model number when selecting common replacements such as the samsung refrigerator water filter HAFCU1
• If you are troubleshooting dispenser or ice issues, the model number also helps narrow down the correct diagrams and assemblies

Last updated: February 2026