Kenmore 11047532602 washer Parts

Kenmore washer model 11047532602 is a front-load design; most Kenmore front-load washers of this generation run about 3.0 to 4.0 cu. ft. capacity. For the exact rated capacity for your specific unit, we recommend confirming it in the 11047532602 owner's manual.

We use these quick checks to get the right number for your washer and avoid mixing up similar 110-series models:

• Look in the Specifications section of the 11047532602 owner's manual.
• Check the model/serial tag (typically around the door opening) to confirm the full model number is 11047532602.
• If your washer is installed under a counter, note that cabinet size is not the same as tub capacity.
• If you have a pedestal or stack setup, that changes height and fit, not capacity.
• Use the capacity to choose proper load size and detergent amount (especially for HE detergent).

If you do not have the spec page handy, this range helps you size loads appropriately.

Capacity affects cleaning and reliability. Overloading a front-load washer can increase vibration, reduce rinse performance, and contribute to drain issues that may involve parts like the water pump WPW10730972.

Last updated: February 2026

Your Kenmore washer model number is printed on the appliance’s model and serial tag. On Kenmore model 11047532602, you’ll typically find that tag around the door opening area (front-load style) or on the cabinet frame; once you have the full number, we can match the correct parts and diagrams.

Check these common tag locations first:

• Inside the door opening, along the front frame
• Behind the door, near the door hinge area
• On the back panel near the power cord entry
• Along the side of the cabinet (near the bottom edge)
• Behind the lower access panel (if your model has one)

For the exact location and how the tag looks on this model, use the 11047532602 owner's manual.

Kenmore washer model numbers are usually a long numeric string. For this unit, the model number is 11047532602. Using the complete model number helps us avoid mix-ups with similar Kenmore 110-series washers that use different components (like a door boot, drain pump, or control board).

• Copy the model number exactly as shown (all digits)
• Also record the serial number (helps with production variations)
• Take a clear photo of the tag for reference

Even small model differences can change which replacement part fits. Here are a few examples from this model’s parts list:

If you’re troubleshooting leaks or a no-drain symptom, matching the model first helps ensure you order the correct water pump WPW10730972.

The model number is the fastest way to get the right Kenmore washer parts, correct troubleshooting steps, and accurate repair instructions. It prevents ordering the wrong pump, door boot, or electronic control and saves time on returns.

Last updated: February 2026

A Kenmore washer typically lasts 10 to 15 years with normal household use. For Kenmore model 11047532602, routine care (cleaning, correct loading, and hose checks) helps you reach the high end of that range; neglected maintenance shortens it.

Most washers land in the same general window, but real-world life depends on use and upkeep.

• Loads per week: more cycles equals more wear on bearings, belt, and pump
• Overloading: increases stress on the drive system and suspension
• Detergent use: too much detergent can cause residue and odors that lead to extra cleaning cycles
• Water quality: hard water can accelerate buildup in hoses and internal passages
• Maintenance habits: periodic cleaning and inspections reduce surprise failures

We recommend following the care schedule in the 11047532602 owner's manual. Focus on the items that prevent leaks, odors, and drain problems.

• Clean the washer and door area regularly; wipe the door boot dry after use
• Inspect and replace aging inlet hoses before they burst
• Keep the washer level to reduce vibration and component fatigue
• Use the correct amount of HE detergent and avoid excessive suds
• Leave the door slightly open between loads to reduce moisture and mildew

Some parts are normal wear items; others signal a bigger repair decision.

If you’re chasing a drain issue, the water pump WPW10730972 is a common fix when the washer won’t drain or drains slowly.

Knowing the 10 to 15 year average helps you decide whether to maintain, repair, or replace. A simple leak or drain repair can be cost-effective, while repeated major failures often point to end-of-life.

Last updated: February 2026