Whirlpool GS5SHAXNT01 side-by-side refrigerator Parts

The Whirlpool GS5SHAXNT01 is a full-size side-by-side refrigerator; most units in this Whirlpool class are about 25 cubic feet and roughly 36 inches wide. For the exact GS5SHAXNT01 capacity, height, width, depth, and required clearances, use the specifications section in the GS5SHAXNT01 owner's manual.

What “big” should include (so you get the right fit)

When we size a refrigerator for a kitchen opening, we focus on these measurements:

• Total capacity (cu. ft.): how much it holds
• Overall width: cabinet opening fit
• Overall height: clearance under cabinets or soffits
• Overall depth: how far it projects past counters (especially with handles)
• Door swing clearance: room to fully open doors and pull bins out

Typical size for a Whirlpool side-by-side like GS5SHAXNT01

Use this as a planning baseline, then confirm the exact numbers in the manual before moving, remodeling, or ordering delivery.

Spec	Typical for this style	Planning tip
Capacity	About 25 cu. ft.	Compare storage, not just exterior size
Width	About 36 in.	Measure the narrowest point of the opening
Height	About 69 to 71 in.	Check for soffits, trim, and hinges
Depth	About 32 to 35 in.	Include handles and door clearance

How we recommend measuring your space

Measure the opening first, then compare to the refrigerator specs and clearance notes.

• Measure width at the front and back of the opening
• Measure height to the lowest cabinet, trim, or soffit
• Measure depth from the back wall to the counter front edge
• Plan space for the water line to the rear connection point
• Follow the airflow clearances listed in the manual

Why it matters

Two side-by-side refrigerators can have similar capacity but different depth, hinge height, and door swing. Confirming the GS5SHAXNT01 specs prevents delivery surprises, pinched water tubing, and doors that cannot open wide enough for shelves and bins.

Last updated: January 2026

To change the water filter on your Whirlpool GS5SHAXNT01 side-by-side refrigerator, remove the old filter, install the new one until it locks in place, then flush the water system at the dispenser to clear air and activate the filter. See the GS5SHAXNT01 owner's manual for your exact filter location and reset steps.

Step-by-step: replace the filter and flush the system

1. Dispense a little water to relieve pressure.
2. Remove the old filter cartridge (turn or pull, depending on the filter style used on your unit).
3. Install the new filter and push or turn it until it seats fully (you should feel it lock).
4. Run water through the dispenser to flush the system; brief sputtering or air noise is normal.
5. If your model has a filter status light, reset it after replacement.

Quick checklist before you start

• Use a new, compatible water filter for Whirlpool GS5SHAXNT01
• Keep a towel handy for a few drips
• Flush the dispenser until the flow is steady
• Replace the filter sooner if dispenser flow drops noticeably
• If you use reverse osmosis, expect reduced water pressure at the dispenser

When to replace the water filter

Whirlpool recommends replacing the filter when the status light turns red (on models with an indicator) or when water flow to the dispenser or ice maker decreases noticeably. On models without an indicator, a typical replacement interval is every 6 to 9 months.

Situation	What to do
Status light turns red	Replace filter and reset light
Water flow slows down	Replace filter sooner
No status light	Replace every 6 to 9 months

Why it matters

A fresh water filter helps maintain good-tasting water and normal dispenser and ice maker flow. Flushing after installation clears trapped air so the inlet valve and ice maker can fill properly.

Related DIY help

For more detail on the process and filter types, use how to replace the water filter in a Whirlpool refrigerator.

Last updated: January 2026

5-in-1 mode is a feature on some Whirlpool refrigerators that lets you switch the appliance between multiple preset temperature and performance settings (for example, “party” or “deep freeze”) to match changing storage needs. The Whirlpool GS5SHAXNT01 side-by-side refrigerator user documentation focuses on standard cooling and water filter use, not a 5-in-1 convertible feature, so treat “5-in-1 mode” as a different Whirlpool product line feature.

What “5-in-1” usually means

On Whirlpool models that include it, 5-in-1 convertible modes typically change one compartment’s target temperature range and airflow behavior so you can prioritize:

• Extra ice production and faster recovery for gatherings
• Colder setpoints for frozen foods
• Milder setpoints for short-term chilling
• Flexible storage when your needs change seasonally

Exact mode names and temperatures vary by model, so the correct definitions come from that refrigerator’s controls section in the manual.

How to confirm whether your refrigerator has it

Use these quick checks on your Whirlpool GS5SHAXNT01:

• Look for a dedicated “convert” or “mode” button on the control panel
• Check for mode icons or labels near the temperature display
• Review the controls and features section in the GS5SHAXNT01 owner’s manual
• If your controls only show freezer and refrigerator temperature adjustments, it is a standard dual-compartment design

If you are trying to solve a cooling or ice issue (common mix-up)

Many customers ask about “modes” when the real issue is temperature stability, ice production, or water flow. These parts are common causes on this model:

• Ice maker not producing ice: Whirlpool refrigerator ice maker assembly 2198597
• No water to ice maker or dispenser: refrigerator inlet valve W10408179
• Frost buildup affecting airflow: refrigerator defrost bi-metal WPW10225581 and refrigerator heater WP2323198

Quick comparison

What you see	More likely cause	What to check first
“Mode” labels on display	Convertible feature model	Manual controls section
No “mode” button, only temps	Standard refrigerator	Setpoints, airflow, door seal
Ice slow or hollow cubes	Water supply issue	Inlet valve, filter housing

Why it matters

Using the wrong feature instructions can lead to incorrect temperature settings and food storage problems. Matching the instructions to the exact model number (GS5SHAXNT01) keeps troubleshooting focused and prevents unnecessary part replacement.

Last updated: January 2026