Maytag MTW5570TQ0 washer Parts

The Maytag MTW5570TQ0 top-load washer has a 3.2 cu. ft. capacity. For the most accurate model-specific details (including cycle options and loading guidance), we recommend confirming in the owner's manual.

How to confirm capacity and loading guidance

Capacity is a tub-volume spec, but real-world load size depends on fabric type and cycle selection. In the manual, look for sections covering cycle descriptions and loading recommendations.

• Use the manual’s loading guidance for bulky items (blankets, towels) versus mixed loads.
• Avoid packing clothes tightly; leave room for the agitator to move items through the wash.
• If you routinely wash large, heavy loads, use appropriate cycles and water levels.
• Balance the load evenly around the basket to reduce vibration and out-of-balance spinning.

Why capacity matters

A 3.2 cu. ft. washer like the MTW5570TQ0 is designed for everyday household loads. Overloading can reduce cleaning performance and increase wear on drive components such as the clutch and drive motor.

Quick reference

Spec	What it means	What you’ll notice
3.2 cu. ft. capacity	Approximate tub volume	Typical mixed loads fit comfortably
Top-load with agitator	Uses an agitator to move clothes	Load placement and balance matter

Last updated: February 2026

We don’t recommend bypassing the lid lock or lid switch on your Maytag MTW5570TQ0 washer; the washer is designed to stop agitating and spinning when the lid is open to help prevent injury. If the washer won’t run or spin, the right fix is troubleshooting the lid switch circuit and replacing the failed part.

What to do instead (safe, effective fixes)

• Unplug the washer before inspecting anything under the console or top panel.
• Confirm the lid is closing fully and the hinge area is not bent or obstructed.
• If the washer will not agitate or spin with the lid closed, test and replace the washer lid switch assembly WP8318084.
• If the washer stops mid-cycle, verify the timer is set correctly and the lid is closed; the washer can pause briefly during some cycles.
• Check for power issues (tripped breaker, blown fuse) and avoid extension cords.

Quick symptom guide

Symptom	Most common cause	What we recommend
Won’t agitate or spin	Lid switch not closing electrically	Replace lid switch assembly
Starts then stops	Lid not fully closed, intermittent switch	Inspect lid strike/hinge; replace switch if intermittent
Won’t start at all	Power supply issue or control/timer setting	Check outlet/breaker; confirm cycle selection

Why the lid lock or lid switch matters

On this style of top-load washer, the lid safety system prevents the tub or agitator from moving when the lid is open. That is why a failed lid switch can look like a “no spin” or “no agitate” problem even when everything else is fine.

Helpful reference

For model-specific safety notes and operating details (including that the washer won’t agitate or spin with the lid open), use the owner's manual.

Last updated: February 2026

The most common problem we see with a Maytag washer like model MTW5570TQ0 is a no-drain or no-spin complaint. On this style of top-load washer, the issue is often tied to the lid being open, a drain restriction, or excessive suds that prevent proper draining and spinning (all covered in the owner's manual).

Most common symptoms (and what they usually point to)

• Washer will not spin or agitate: lid not fully closed or a failed lid switch
• Washer will not drain: clogged/kinked drain hose or a weak/failed drain pump
• Cycle seems stuck filling or draining: drain hose installation issue or siphoning condition
• Noisy operation: unbalanced load, washer not level, or normal gear engagement sounds
• Leaks: loose fill hoses, hose washers not seated, standpipe/drain can’t handle flow

Quick checks for MTW5570TQ0 (fastest wins first)

1. Close the lid firmly; this washer will not agitate or spin with the lid open.
2. Reduce suds: measure detergent carefully; soft water needs less detergent.
3. Check the drain hose height: the end of the drain hose should not be more than 96 in. (244 cm) above the floor.
4. Confirm the washer is level and the load is balanced (helps prevent noise, vibration, and off-balance spin issues).

Parts that commonly fix no-spin or no-drain problems

Symptom	Common part to check	What it does
Won’t spin or agitate with lid closed	Washer lid switch assembly WP8318084	Confirms lid is closed so the washer can run/spin
Won’t drain or drains slowly	Washer drain pump WP3363394	Pumps water out to the standpipe or laundry tub
Agitator “slips” or won’t move clothes well	Agitator dog 80040	Helps the agitator grip and move in the correct direction

Why it matters

When the washer can’t drain correctly, it often can’t transition into spin. That leaves clothes soaking wet, can make cycles seem “stuck,” and can trigger repeated refills or long drain times.

Last updated: February 2026

Maytag washers typically last 10 to 13 years with normal household use and basic maintenance. For your Maytag MTW5570TQ0, following the care and cleaning steps in the owner's manual helps you get the most life out of the drive system, pump, and suspension.

What affects washer lifespan the most

• Load size and balance: frequent overloading or consistently unbalanced loads shortens tub, drive, and suspension life.
• Water quality: hard water and sediment increase wear on valves, hoses, and internal seals.
• Drain performance: slow draining strains the pump and can leave residue behind.
• Routine cleaning: detergent buildup and odor issues often trace back to skipped cleaning.
• Timely repairs: replacing a small wear part early can prevent bigger damage.

Quick maintenance checklist (high impact)

• Run a periodic cleaning routine as outlined in the owner's manual.
• Use the right amount of HE detergent; too much causes buildup.
• Keep loads evenly distributed; mix items to reduce out-of-balance spinning.
• Check fill and drain hoses for bulges, cracking, or seepage.
• Address new noises, burning smells, or poor agitation quickly.

Common wear parts that can shorten life if ignored

If performance changes, these model-compatible parts are common culprits:

Symptom	Often involved part	What it does
Won’t drain or drains slowly	Washer drain pump WP3363394	Pumps water out of the tub
Won’t spin or stops when lid opens	Washer lid switch assembly WP8318084	Confirms lid is closed for spin/drain
Weak agitation or “ratcheting”	Agitator dog 80040	Helps the agitator grip and move clothes
Burning smell or poor spin	Clutch 285785	Transfers power for spin

Why it matters

A washer that is kept clean, not overloaded, and repaired promptly usually reaches the upper end of the 10 to 13 year range. Small issues like weak agitation or slow draining can cascade into bigger wear on the gear case, motor, and basket drive components.

Last updated: February 2026