Kenmore Elite 66513793K603 dishwasher Parts

To take your Kenmore Elite dishwasher model 66513793K603 out of Lock mode, press and hold HEATED DRY for 4 seconds until the Lock On light turns off. If you press a button while locked, the Lock light typically flashes 3 times.

• Make sure the dishwasher door is closed or at least fully latched.
• Locate the HEATED DRY button on the control panel.
• Press and hold HEATED DRY for 4 seconds.
• Confirm the Lock On indicator light turns off.
• Press START/RESUME to run a cycle if needed.

Lock mode prevents unintended button presses between cycles. It is especially helpful if the dishwasher is in a high-traffic kitchen or if kids can reach the controls.

• Hold the button a little longer (count a full 4 seconds).
• Wipe the control panel dry; moisture can make pads act unresponsive.
• Restore power by turning the breaker off for 1 minute, then back on, and try again.
• If the panel stays unresponsive after a reset, a control issue is possible; the dishwasher electronic control is a common part involved.

For the exact control-panel details and indicator behavior for this model, use the 66513793K603 owner's manual.

Last updated: January 2026

Common problems on the Kenmore Elite dishwasher model 66513793K603 are no-start or stopping mid-cycle, not draining, poor cleaning, leaks, and weak drying. Most of these trace back to power/door-latch issues, water supply problems, or clogs in the filter, drain path, or spray system; use the 66513793K603 owner's manual for model-specific checks.

• Dishwasher will not start: tripped breaker, blown house fuse, door not fully latched, cycle not set correctly, water supply turned off
• Stops during a cycle: door opened mid-cycle, brief normal pauses, motor overload reset, power interruption
• Not draining: blocked drain hose/air gap, clogged sump area, failed drain pump
• Poor cleaning: blocked spray arms, overloaded racks, wrong detergent, hard water buildup
• Leaks: door seal issues, loose hose connections, overfill/float problems
• Poor drying: rinse aid low, venting issue, heater or control problem

1. Confirm the door closes tightly and latches.
2. Verify the cycle is selected correctly and Start/Resume is pressed.
3. Check the home breaker or fuse.
4. Make sure the water shutoff valve is fully open.
5. Run the shortest cycle and, after about 2 minutes, open the door and confirm there is water in the bottom of the tub.

Catching a simple issue (like a tripped breaker, closed water valve, or a clog) prevents repeat cycle failures and helps protect the pump motor and electronic control from strain.

Last updated: January 2026

On the Kenmore Elite dishwasher model 66513793K603, the filter is located in the bottom of the tub, directly under the lower spray arm area. To access it, we remove the lower rack and then lift or twist out the filter assembly so it can be rinsed clean.

1. Turn the dishwasher off and open the door.
2. Pull out the lower dishrack.
3. Look at the bottom center of the tub, beneath the lower spray arm.
4. Remove the filter assembly (many Kenmore 665 models use a twist-lock style filter).
5. Rinse the filter under warm running water; use a soft brush for stuck-on debris.
6. Reinstall the filter fully seated and locked before running a cycle.

• Food debris or labels blocking the filter screen
• Broken plastic tabs or a filter that will not lock in place
• Standing water that suggests a drain restriction
• A loose lower spray arm that can interfere with the filter area
• Odors that point to buildup in the sump area

A clogged filter restricts water flow and can lead to poor cleaning, gritty residue on dishes, and drainage problems. Keeping the filter clean helps the wash system circulate properly and reduces the chance of water backing up.

Some installations use a drain air gap near the sink or countertop. If the dishwasher is not draining, we check and clean the air gap as well because it can clog even when the internal filter is clean.

For model-specific diagrams and the exact filter removal method for your unit, use the 66513793K603 owner’s manual.

Last updated: January 2026