Kenmore 10657285790 refrigerator Parts

To replace the ice maker in your Kenmore 10657285790 side-by-side refrigerator, we shut off power and water, remove the ice bin and old ice maker, install the replacement assembly, then flush the water system and allow up to 24 hours for ice production (discard the first three batches). Use the 10657285790 owner's manual for model-specific safety notes.

• Unplug the refrigerator or disconnect power.
• Turn the ice maker OFF by lifting the signal arm.
• Shut off the household water supply.
• Keep a towel handy for small spills.
• Use a screwdriver or nut driver and save all screws.

1. Pull out the ice container to access the ice maker.
2. Disconnect the ice maker wiring harness.
3. Remove mounting screws; lift the ice maker out.
4. Install the new unit; tighten screws and reconnect wiring.
5. Restore water and power; lower the signal arm to turn the ice maker ON.

If you are replacing the complete unit for this model, use the ice maker assembly - refrigerator ice maker by whirlpool 4317943.

• Dispense and discard 2 to 3 gallons of water (about 6 to 7 minutes).
• Wait 24 hours for the first ice.
• Discard the first three batches of ice.

Flushing clears air and residue from the water line, and the 24-hour wait prevents mistaking normal startup time for an ice maker problem.

Last updated: February 2026

The exact cabinet dimensions for Kenmore model 10657285790 are listed in the owner's manual. For planning space, we use the manual’s clearance requirements: allow 1/2 inch on each side and at the top, plus 2 inches minimum next to a fixed wall for door swing.

Use a tape measure and record these three numbers:

• Width: left outside edge to right outside edge (doors closed)
• Height: floor to top of cabinet (include hinge cover if it sits higher)
• Depth: back to front (note two depths: cabinet only, and to the front of handles)

Tip: Measure twice, then compare to the spec section in the owner's manual so your cutout and door-swing plan match the refrigerator.

These clearances matter as much as the refrigerator’s dimensions because they affect airflow and door opening:

• 1/2 inch (1.25 cm) on each side
• 1/2 inch (1.25 cm) at the top
• Extra space behind if an ice maker water line is connected
• 2 inches (5.08 cm) minimum next to a fixed wall (varies by setup) for door swing

A side-by-side refrigerator like the Kenmore 10657285790 needs proper airflow and door swing room to cool correctly, avoid condensation, and keep the ice maker and dispenser working reliably.

Last updated: February 2026

On Kenmore model 10657285790 side-by-side refrigerators, the model and serial number label is typically on the inside of the fresh food (refrigerator) compartment, on a side wall. The owner's manual shows this label location in the Parts and Features section.

• Open the refrigerator (fresh food) door and check the left and right interior side walls
• Look near the crisper drawers and the meat pan area (lower side wall)
• Check behind or near the control panel area inside the compartment (varies by configuration)
• If shelves or bins block your view, slide them out for a clear look
• Use a flashlight; the label is often small and low-contrast

The label lists both identifiers. Use the model number when ordering parts like an ice maker, thermostat, or door gasket.

Kenmore side-by-side refrigerators can look similar across multiple model series. Using the exact model number helps us match the correct diagrams and parts (for example, an ice maker assembly - refrigerator ice maker by whirlpool 4317943) so the replacement fits and functions correctly.

Last updated: February 2026