Craftsman Chipper/shredder Parts — Browse All Models

Most common Craftsman 5hp chipper shredder parts that need replacing

1. Engine air filter. The engine air filter cleans the air entering the carburetor. Replace the air filter periodically, following the guidelines in the owner's manual.
2. Carburetor. The engine carburetor mixes air and gas before the fuel mix goes to the cylinder for combustion.
3. Recoil starter. The recoil starter spins the crankshaft to start the engine when you pull the rope.
4. Engine gasket set. The engine gasket set includes all of the seals and gaskets for the engine on your chipper/shredder. Replace any gaskets that are damaged or leaking.
5. Blades. Chipper shredder blades can wear out or get damaged over time. Find the replacement blades you need at Sears PartsDirect. We also have Craftsman 8.5 hp chipper shredder blades as well as blades for other models.

How to install the hopper on your Craftsman 8ph chipper shredder

1. Attach the hopper to the rotor housing. Make sure that you engage the metal lip of the hopper liner inside the rotor housing.
2. Secure the hopper to the rotor housing using the mounting bolts and washers. Don't tighten the mounting bolts at this time.
3. From inside the hopper, install the mounting bolts and washers into the upper lower holes of the metal hopper liner. Finger tighten the bolts at this time.
4. Make sure that the hopper is seated correctly on the chipper/shredder then tighten all mounting bolts firmly.