How to reset Frigidaire side by side refrigerator not cooling?
If your Frigidaire FGSS2635TFB side-by-side refrigerator isn’t cooling, the most effective “reset” is to make sure the cooling system is actually turned on, then restore power to clear a temporary control glitch. On this model, the control panel can be set to power off, which disables cooling until you turn it back on (see FGSS2635TFB use & care manual).
- Check for “power off” on the display: if you see it, press and hold Set for 3 seconds to turn cooling back on.
- Power reset: unplug the refrigerator (or turn off the breaker) for 5 minutes, then restore power.
- Confirm temperature settings: set fresh food to 37°F and freezer to 0°F.
- Give it time: after a reset or warm-door event, allow 24 hours for temperatures to stabilize.
- Make sure doors are sealing: a poor seal can mimic a cooling failure.
Use these quick checks before replacing parts:
- Freezer fan area is unusually quiet (possible evaporator fan issue)
- Heavy frost on the freezer back wall (possible defrost problem)
- Refrigerator side warm but freezer cold (possible airflow/damper issue)
- Condenser area very hot and unit runs constantly (possible airflow/coil issue)
- Temperatures fluctuate widely (possible sensor issue)
| Symptom you notice | What it often points to | Example compatible part |
|---|---|---|
| Warm fridge and warm freezer | Control or sealed-system related | Refrigerator power control board 5304521260 |
| Warm fridge, freezer colder than normal | Airflow control issue | Refrigerator air damper 241853801 |
| Temps erratic or incorrect display behavior | Sensor/thermistor issue | Refrigerator temperature sensor 240597220 |
On the FGSS2635TFB, “power off” mode disables the cooling system without unplugging the refrigerator. That can look like a major failure, but turning cooling back on and doing a short power reset often restores normal operation.
Last updated: January 2026
What is the most common problem with a Frigidaire refrigerator?
For the Frigidaire FGSS2635TFB side-by-side refrigerator, the most common customer-reported issues typically fall into two buckets: cooling performance problems (warm fridge, freezer frost, temperature swings) and ice maker or water dispenser problems. Many of these start with airflow restrictions, filter clogs, or door sealing issues; see the FGSS2635TFB use & care manual for model-specific operating checks.
- Fresh food section warm but freezer cold: restricted airflow, evaporator fan issue, or a stuck air damper
- Freezer frost buildup: door not sealing, frequent door openings, or a defrost system problem
- Ice maker not making ice or small cubes: clogged water filter, low water pressure, or inlet valve trouble
- Water dispenser slow: filter restriction or air in the water line
- Runs a lot or seems loud: dirty condenser area, warm room temps, or heavy use
- Confirm set temps are near 37°F (fresh food) and 0°F (freezer).
- Make sure doors close fully and seals contact the cabinet all the way around.
- If ice or water is weak, replace the water filter and flush the system.
- Listen for the evaporator fan running when the unit is cooling.
- Check for obvious frost patterns or blocked vents inside the freezer.
| Symptom | Common part to inspect/replace | Example from this model’s parts list |
|---|---|---|
| Slow water, poor ice | Water filter | Refrigerator water filter and filter cap EPTWFU01 |
| No water to dispenser/ice maker | Water inlet valve | Frigidaire refrigerator water inlet valve assembly 242252702 |
| Frost, warm temps, poor airflow | Evaporator fan motor | Frigidaire refrigerator evaporator fan motor 809069206 |
| Frost from air leaks | Door gasket | Refrigerator freezer door gasket (gray) 241786014 |
Cooling and ice maker complaints often share the same root causes: airflow and water flow. Fixing a simple restriction (like a clogged filter or poor door seal) can prevent bigger problems such as overheating, heavy frost, and food spoilage.
Last updated: January 2026
How do I find the model number on my FGSS2635TFB?
The model number for your Frigidaire side-by-side refrigerator is printed on the appliance’s rating label. On FGSS2635TFB, the label is typically inside the fresh food (refrigerator) compartment on a side wall near the crisper area or on the door frame; match the full model number exactly.
Check these common rating-label locations on FGSS2635TFB:
- Inside the refrigerator section on the left or right side wall
- On the door frame (the vertical frame the door seals against)
- Near the crisper drawers or lower liner area
- Behind the toe grille or near the front base (less common)
Use the full model number (letters and numbers) from the label, not a partial series name.
| What you see | What to do |
|---|---|
| Model number (example: FGSS2635TFB) | Use this to look up diagrams and exact-fit parts |
| Serial number | Keep for service records; it is not used to choose most parts |
| Brand name (Frigidaire) | Helpful, but not specific enough for ordering |
Frigidaire can use similar-looking designs across multiple models; the exact model number ensures the correct fit for items like a water filter, door gasket, or ice maker assembly.
- Wipe the label gently with a damp cloth and dry it
- Use your phone camera zoom and good lighting
- Copy the model number exactly, including any suffix letters
For diagrams and model identification details, use the FGSS2635TFB owner's manual.
Last updated: March 2026





