Whirlpool ED5FVGXVS00 side-by-side refrigerator Parts

The Whirlpool ED5FVGXVS00 is a full-size side-by-side refrigerator. Most Whirlpool side-by-side models in this series are about 35 1/2 inches wide, 69 to 70 inches tall, and 33 to 35 inches deep (depth varies most depending on handles and door swing); confirm the exact cutout and clearance specs in the ED5FVGXVS00 owner's manual.

Typical size and what to measure

To size your space correctly, we recommend measuring these three items on your refrigerator and your opening:

• Width: cabinet to cabinet (ignore door handles unless you need total projection)
• Height: floor to top hinge cover (and check for leveling leg adjustment)
• Depth: compare cabinet-only depth vs with handles depth
• Door swing clearance: space needed to fully open doors and pull out crisper pans
• Ventilation clearance: space behind and above for airflow

Quick reference: common dimension ranges

These ranges help you plan when you do not have the unit in front of you.

Measurement	Typical range for Whirlpool side-by-side	Why it changes
Width	35 1/2 in.	Most are standard-width cabinets
Height	69 to 70 in.	Hinges, feet leveling, trim
Depth	33 to 35 in.	Handles, doors, and spacing from wall

Why it matters

Correct sizing prevents installation headaches like doors hitting walls, drawers not sliding out, or the refrigerator sitting too tight to breathe. It also helps avoid water line kinks that can affect the dispenser and ice maker.

Related help

If you are also planning to replace the water filter while you have the unit pulled out, follow the steps in how to replace the water filter in a Whirlpool refrigerator.

Last updated: February 2026

The most common Whirlpool refrigerator problem is a cooling complaint (warm fridge, warm freezer, or temperature swings). On the Whirlpool ED5FVGXVS00 side-by-side, the most frequent root causes are restricted airflow from dirty condenser coils, a failing evaporator fan, or a defrost drain issue that leads to frost or water buildup; check the owner's manual for model-specific care and access details.

Quick checks we recommend first

• Confirm the controls are set to normal mid-range settings (not max cold).
• Clean the condenser coils and make sure the grille area has good airflow.
• Listen for the evaporator fan in the freezer; it should run when the compressor runs.
• Check door gaskets for gaps, tears, or areas that do not seal.
• Look for ice buildup on the freezer back wall (often points to a defrost problem).
• If you see water under the crisper drawers, inspect for a clogged defrost drain.

Common symptoms and the most likely causes

Symptom	Most common cause	What to do next
Fresh food section warm, freezer OK	Airflow problem (fan, damper, frost)	Check fan sound and frost pattern; clear vents
Both sections warm	Dirty coils, condenser airflow, sealed system issue	Clean coils; verify condenser area airflow
Ice maker slow or no ice	Water supply or valve issue	Check supply line; test fill; consider valve
Water dispenser weak	Filter restriction or air in line	Replace filter; purge air
Loud humming or rattling	Fan blade hitting ice, loose panel, dirty coils	Inspect for ice contact; clean coils

Parts that commonly solve these issues on this model

When troubleshooting points to a specific failure, these are common fixes for ED5FVGXVS00:

• Water flow and ice maker fill problems: refrigerator water inlet valve W10408179
• Weak water taste/flow and dispenser issues: everydrop ice & water refrigerator filter 3 - refrigerator filtration part by Whirlpool EDR3RXD1
• Temperature control complaints (cycling too warm/too cold): refrigerator thermostat WP2198202

Why it matters

Cooling and ice maker problems often start small (restricted airflow or water restriction) and then create bigger issues like food spoilage, heavy frost, or compressor overwork. Regular coil cleaning and on-time filter changes prevent many of the most common Whirlpool refrigerator service calls.

Last updated: February 2026

For your Whirlpool side-by-side refrigerator, the model number is printed on the appliance’s rating label, usually inside the fresh food compartment on a side wall or near the ceiling. Confirm it matches ED5FVGXVS00 before ordering parts or using diagrams in the ED5FVGXVS00 owner's manual.

Where to look on the refrigerator

Check these common rating-label locations first:

• Inside the refrigerator section on the left or right interior wall
• Near the top interior trim, close to the temperature control area
• Behind the crisper drawers on the side wall (look above the drawer rails)
• On the hinge-side door frame area (visible when the door is open)

What the label looks like

The label typically includes several identifiers. Use the model number for parts lookup.

Label item	What it’s used for	Example format
Model number	Correct parts and diagrams	ED5FVGXVS00
Serial number	Manufacturing date tracking	Letters and numbers
Electrical ratings	Power requirements	Volts/amps

Tips to avoid ordering the wrong part

Model numbers can be close, so we recommend these quick checks:

• Copy the model number exactly, including all letters and digits
• Do not use the number from a water filter or ice maker as the refrigerator model
• If the label is worn, take a clear photo and zoom in to confirm characters
• Match the model number before choosing parts like the refrigerator water inlet valve W10408179 or refrigerator ice maker WPW10190965

Why it matters

Whirlpool side-by-side refrigerators often share similar styling across model families, but internal parts (water system, ice maker, defrost components, shelves) can vary by model suffix. Using ED5FVGXVS00 ensures the best fit and correct installation.

Last updated: March 2026