Kenmore 11074622300 gas dryer Parts

To hard reset your Kenmore gas dryer model 11074622300, unplug it (or switch the breaker off) for about 1 minute, then restore power and start a new cycle. This clears many temporary control and cycle issues; use the steps in the 11074622300 user manual for normal stop and restart operation.

• Turn the cycle selector to OFF.
• Unplug the dryer (or turn both dryer breakers off if it is hardwired).
• Wait 60 seconds.
• Restore power.
• Close the door firmly.
• Select a cycle and press PUSH TO START.

A reset helps only if the issue is a temporary control state. If the dryer still will not run, focus on the basic start conditions and the most common no-start parts.

Check these first

• Outlet power and house fuses or breakers (many dryers use 2 fuses/breakers)
• Door fully closed and latch aligned
• Cycle selector not sitting between settings
• Lint screen seated correctly and airflow not blocked

Common parts that can stop a start

Hard resets clear a stuck cycle or control logic, but they do not fix an open safety switch, a failed start circuit, or a mechanical bind. Checking power, door closure, and the start components prevents repeat shutdowns and protects the motor.

Last updated: February 2026

On Kenmore dryers, the F01 code indicates an electronic control problem (a fault detected by the main control board or its wiring). On model 11074622300 (gas dryer), treat F01 as a control or harness issue first, then confirm any model-specific reset or diagnostic steps in the 11074622300 owner's manual.

• Unplug the dryer for 5 minutes, then restore power and try a cycle.
• If the code returns, unplug again and check the control-area wiring for loose plugs.
• Look for pinched, rubbed-through, or heat-damaged wires.
• Make sure the outlet is properly grounded and the dryer is on a dedicated circuit.
• If you smell gas at any time, shut off the gas supply and stop.

If you want a quick reference for how Kenmore displays and groups fault codes across electronic models, use our Kenmore 110 series electronic control model dryer error codes guide. It helps you separate control faults from heating or airflow problems.

F01 is a control-level fault; continuing to run the dryer can lead to repeated shutdowns, incomplete cycles, and additional electrical stress on the control and wiring.

Last updated: February 2026

On Kenmore dryer model 11074622300, the model and serial number label is located at the top inside the dryer door well. We use that label to match the correct parts, installation requirements, and service information for your exact gas dryer.

Check these common label locations in this order:

• Top inside the dryer door well (most common for this Kenmore model)
• Inside the door opening on the cabinet frame
• Rear panel near the top (some dryers place an additional rating label here)
• On the side panel near the door opening (less common)

For a diagram and wording that matches your unit, use the 11074622300 owner's manual.

Record the information exactly as shown on the label:

• Model number (for example: 11074622300)
• Serial number
• Purchase date (if available)

Kenmore model numbers often look similar, but internal parts can differ (door switch style, belt routing, gas burner components). Using the exact model number helps you avoid ordering the wrong component and speeds up troubleshooting.

Last updated: February 2026