Installation guide
Owner’s manual
How big is a Kenmore microwave model 72186019010 in inches?
The Kenmore Elite 72186019010 microwave/hood combo measures 29-15/16 inches wide, 16-7/16 inches high, and 15-3/8 inches deep. These are the cabinet dimensions used for installation planning and fit checks in the installation guide.
| Measurement | Size (inches) | What it helps with |
|---|---|---|
| Width | 29-15/16 | Fit between cabinets and vent opening |
| Height | 16-7/16 | Clearance under upper cabinet |
| Depth | 15-3/8 | Projection from wall and cabinet depth planning |
- Measure the opening width; most over-the-range installs need at least a 30-inch space.
- Confirm the distance from the cooktop or range to the mounting plate location per the template.
- Check upper cabinet depth and any recessed cabinet bottom; filler blocks may be needed.
- Verify the power cord hole location in the upper cabinet if you are reinstalling.
- Make sure the mounting plate and wall studs line up correctly.
Correct dimensions prevent cabinet interference, poor vent alignment, and mounting issues. For the 72186019010, the width is essentially a standard 30-inch over-the-range footprint, but the exact height and depth affect clearances and how far the unit sits out from the wall.
| Item | Typical requirement |
|---|---|
| Install help | Two people (unit is heavy) |
| Electrical supply | 120V, 60Hz, AC only, 20A fused circuit |
Last updated: January 2026
How do I reset my Kenmore microwave?
To reset your Kenmore Elite microwave/hood combo model 72186019010, unplug it (or switch off the breaker) for about 1 minute, then restore power and re-set the clock. This clears most control glitches after a power surge or keypad confusion; use the 72186019010 owner's manual for model-specific clock and settings steps.
- Press Stop/Clear once to cancel a cooking cycle.
- Unplug the microwave (or turn OFF the dedicated breaker).
- Wait 60 seconds.
- Restore power.
- Set the clock and test a short heat cycle with a cup of water.
A reset will not fix a blown fuse or a door-switch safety issue. Check these common causes:
- Outlet has no power (test with a lamp or small appliance).
- Tripped breaker or GFCI (reset if applicable).
- Door not closing fully; latch feels loose.
- Blown internal fuse (often after a surge or door-slam).
- Failed door interlock switch.
| Symptom | What it usually points to | What we recommend |
|---|---|---|
| Display works, won’t start | Door not sensing closed | Inspect/adjust door closure; check interlock switches |
| Completely dead | Power issue or blown fuse | Verify outlet/breaker; consider Us pressed steel microwave fuse 3B74133Q |
| Runs but won’t heat | High-voltage circuit issue | Use Why is my microwave not heating to narrow down likely parts |
Resetting restores the control board to a clean state, which often resolves non-heating “false alarms,” stuck key behavior, or odd display issues. If power is present but the unit is still dead, the problem is typically electrical protection (fuse) or a door safety circuit, not the settings.
Last updated: January 2026
How many cubic feet is a Kenmore Model 72186019010 microwave?
The cooking capacity for the Kenmore Elite 72186019010 microwave/hood combo is listed in the product specifications for your exact model. Use the 72186019010 owner's manual to confirm the cubic-foot capacity shown for your unit.
Capacity is an interior measurement, and it is model-specific. We recommend verifying it using these checks:
- Match the full model number on the oven front label to 72186019010
- Look for a “Specifications” or “Product information” section
- Confirm you are not viewing specs for a similar 721.86012, 721.86013, or 721.86019 series model
- Use the capacity value shown in cubic feet (cu. ft.)
The installation instructions commonly list exterior dimensions and clearance requirements; those do not equal interior cubic feet.
| Spec type | What it measures | What it helps with |
|---|---|---|
| Capacity (cu. ft.) | Interior oven cavity volume | Dish fit, size class comparisons |
| Exterior dimensions (in.) | Outside cabinet size | Cabinet fit, mounting clearance |
| Electrical rating | Supply requirements | Circuit and outlet planning |
Using the correct cubic-foot capacity helps you choose cookware that fits, compare replacement microwaves accurately, and select compatible accessories like a turntable tray or cooking rack.
If you are planning a new install or replacement, the 72186019010 installation guide is the right place to confirm cabinet opening width, mounting requirements, and electrical supply details.
Last updated: January 2026
