Maytag MFW2055DRH00 refrigerator Parts

No. French door refrigerators are not all 36 inches wide; 36 inches is simply the most common “full-size” width. You will also see narrower models (often around 30 to 33 inches) and wider models (often around 42 inches). For exact dimensions and required clearances, use the MFW2055DRH00 owner's manual.

Common French door width ranges (what you will see most often)

• 30 to 33 inches: space-saving kitchens, smaller capacity
• Around 36 inches: most common size and widest selection
• Around 42 inches: larger capacity, wider cabinet opening needed
• Counter-depth vs. standard-depth: counter-depth is usually shallower, not necessarily narrower

What to measure before you buy or replace a refrigerator

Measure the space, not just the old refrigerator. We recommend checking:

• Cabinet opening width (wall-to-wall)
• Height to the lowest cabinet or soffit
• Depth to the front of surrounding counters
• Door swing clearance (handles and door arc)
• Ventilation clearance (top, sides, and rear)

Quick reference: “36-inch fridge” vs. real-world fit

What you see in listings	What it usually means	Why it matters
36-inch wide	Fits a 36-inch opening	The cabinet opening is the limiting factor
Actual width	Often slightly under the nominal size	Helps prevent rubbing and installation issues
Counter-depth	Reduced depth profile	Can reduce interior capacity

Why it matters

A refrigerator that is even 1/4 inch too wide can be difficult to install, can rub cabinets, and can prevent doors from opening fully. Getting the opening and clearance measurements right helps your Maytag refrigerator install cleanly and run efficiently.

Last updated: February 2026

Water leaking from the bottom of your Maytag MFW2055DRH00 refrigerator is usually caused by a clogged/iced defrost drain, a leaking water supply connection, or a failing water inlet valve letting water seep into the cabinet and down to the floor. Use the MFW2055DRH00 owner's manual to confirm access points and safety steps.

Quick checks we recommend first

• Look for a sheet of ice or standing water on the freezer floor (points to a defrost drain issue).
• Check the water line connection at the back for drips or mineral buildup.
• Inspect the water filter area and housing for cracks or a filter not fully seated.
• Pull the toe grille (if equipped) and look for water trails from the center (drain) vs. left/right (water line).
• Verify the refrigerator is level; a forward tilt can encourage water to spill out instead of draining.

Most common causes and what to do

1) Clogged or frozen defrost drain

When the drain clogs, defrost water overflows and runs out the bottom.

What to do:

• Unplug the refrigerator.
• Remove freezer items and check for ice on the freezer floor.
• Melt ice with warm air (hair dryer on low) and flush the drain with hot water using a turkey baster.
• Clean the drain pan area if accessible.

2) Water inlet valve leaking or not closing fully

A weak valve can seep water to the ice maker or dispenser circuit and create intermittent puddles.

What to do:

• Turn off the household water supply.
• Check for dripping at the valve body and outlet tubes.
• If seepage continues, replace the refrigerator inlet valve WPW10238100.

3) Ice maker fill or supply line leak

Cracked tubing or a loose compression fitting can drip and run down the cabinet.

What to do:

• Inspect the line from the wall to the refrigerator and the internal tubing you can see.
• Tighten fittings gently; replace damaged tubing or fittings.

Symptom-to-cause guide

What you see	Most likely cause	Where to look
Water only after defrost cycles, ice on freezer floor	Defrost drain clogged/frozen	Freezer floor and drain hole
Slow puddle near back, constant dampness	Water inlet valve seeping	Rear lower area
Leak happens during ice maker fill	Supply tube/fitting leak	Behind unit and near ice maker

Why it matters

Leaks can lead to ice buildup, poor cooling airflow, and floor damage. Fixing the drain or water supply leak early also helps prevent evaporator fan and temperature control issues.

Last updated: February 2026

You can get replacement parts for your Maytag MFW2055DRH00 bottom-mount refrigerator by ordering the exact model-matched parts from our parts list for this model. Using the model number helps ensure you get the correct fit for items like filters, ice maker components, and water system parts.

Best way to find the right part for MFW2055DRH00

• Match the full model number: MFW2055DRH00
• Identify the symptom (no ice, warm fridge, water leak, bad odor)
• Look up the part by name and confirm it matches your refrigerator section (fresh food vs. freezer)
• Compare the part ID and description before ordering
• Use the diagrams and instructions in the MFW2055DRH00 owner's manual

Common replacement parts customers order for this model

These are frequently replaced items that are available for MFW2055DRH00:

• Refrigerator air filter W10311524 (odor control)
• Refrigerator ice maker assembly 4317943 (no ice or intermittent ice)
• Refrigerator inlet valve WPW10238100 (no water to dispenser or ice maker)
• Refrigerator thermistor WPW10383615 (temperature sensing issues)

Quick part selection guide

If your issue is...	Check this part first	What it affects
Bad smells in fresh food section	Refrigerator air filter	Odor control and airflow freshness
Ice maker not producing ice	Refrigerator ice maker assembly	Ice harvest and fill cycle
No water to ice maker/dispenser	Refrigerator inlet valve	Water flow into the refrigerator
Temps swing or seem inaccurate	Refrigerator thermistor	Temperature feedback to controls

Why it matters

Ordering by model number and matching the correct part ID prevents returns and repeat repairs. On a bottom-mount refrigerator like the Maytag MFW2055DRH00, the same symptom (for example, “not cold enough”) can be caused by different systems such as airflow, sensors, or water and ice components.

Last updated: February 2026

Most Maytag refrigerators, including the Maytag MFW2055DRH00 bottom-mount refrigerator, last 10 to 15 years. Regular upkeep that reduces run time (clean airflow, good door sealing, correct temperatures) pushes service life to the top of that range.

What affects lifespan the most

A refrigerator lasts longer when the compressor and airflow system do not have to work overtime.

• Dirty condenser area that traps dust and pet hair
• Worn or warped door gaskets that leak warm air
• Weak evaporator fan airflow that causes warm spots
• Overpacked shelves that block vents and circulation
• Water and ice leaks that create corrosion or electrical damage

Maintenance that helps you reach 15 years

These steps reduce stress on the sealed system and help temperatures stay stable.

• Clean the condenser area and keep ventilation space around the cabinet
• Keep interior vents clear; do not pack food tightly against air returns
• Replace odor-control consumables on schedule, such as the refrigerator air filter W10311524
• Follow the cleaning and care schedule in the MFW2055DRH00 owner's manual
• Address early symptoms quickly (clicking, grinding, heavy frost, warming)

Common wear parts vs. major repairs

Category	Examples	What it usually changes
Routine upkeep	Air filter, cleaning, leveling	Lowers run time and heat load
Mid-level repairs	Thermistor, fan motor, inlet valve	Restores normal cooling control
Major repairs	Compressor or sealed system	Often determines repair vs. replace

If cooling becomes inconsistent, parts such as the refrigerator thermistor WPW10383615 or refrigerator compressor W10233960 are common failure points in many bottom-mount designs.

Why it matters

Longer run times mean higher energy use and more heat on the compressor. Keeping airflow strong and doors sealing tightly is the most effective way to extend the life of your Maytag refrigerator.

Last updated: February 2026

The major parts of a refrigerator like the Maytag MFW2055DRH00 include the sealed cooling system (compressor, condenser, evaporator, and refrigerant controls), airflow components (fans and dampers), temperature sensing/control parts, and door sealing and lighting parts that keep cold air in and heat out.

Core cooling system parts (the “sealed system”)

These parts move heat out of the refrigerator and freezer compartments:

• Compressor: pumps refrigerant through the system (example: refrigerator compressor W10233960).
• Condenser: releases heat to the room (often paired with a condenser fan).
• Evaporator: absorbs heat inside the freezer; this is where cooling is created.
• Metering device (capillary tube/expansion device): controls refrigerant flow into the evaporator.

Airflow and temperature control parts

These parts circulate cold air and help maintain stable temperatures:

• Evaporator fan motor and blade: moves cold air across the evaporator and into the compartments (examples: fan blade WP2163777, refrigerator evaporator motor WPW10464673).
• Electronic damper: regulates how much freezer air enters the fresh food section (example: refrigerator electronic damper W11087463).
• Thermistor: senses temperature so the control can run the compressor and fans correctly (example: refrigerator thermistor WPW10383615).
• Defrost components: prevent frost buildup that blocks airflow (example: refrigerator defrost bi-metal WP627985).

Door sealing, water, and convenience parts

These parts prevent air leaks and support features like ice and filtration:

System	What it does	Example part on this model
Door closing/sealing	Helps doors shut and stay sealed	Refrigerator door cam WPW10470155
Ice making	Produces ice when water supply and temps are correct	Refrigerator ice maker assembly 4317943
Water supply	Opens to send water to the ice maker (and dispenser if equipped)	Refrigerator inlet valve WPW10238100
Odor control	Reduces food odors in the fresh food section	Refrigerator air filter W10311524

Why it matters

When you know which “system” a symptom belongs to, troubleshooting gets faster. For example, warm temperatures often point to airflow parts (fan, damper, frost blockage), while no ice often points to the inlet valve, ice maker, or temperature issues.

Quick troubleshooting mapping

• Warm fridge, freezer OK: damper issue, airflow restriction, thermistor.
• Both sections warm: compressor/sealed system, condenser airflow, control issues.
• Frost on freezer back wall: defrost problem (defrost thermostat/bi-metal).
• Bad odors: replace the air filter and clean interior surfaces.

For diagrams and part locations specific to the MFW2055DRH00, use the owner's manual.

Last updated: February 2026