Owner’s manual
Error Codes
How do I find the cubic feet of my Whirlpool refrigerator?
For Whirlpool model ED5KVEXVQ00, the exact cubic-foot capacity is typically listed on the model’s rating label or in the specifications section of the ED5KVEXVQ00 use & care manual. If you cannot locate a stated capacity, you can estimate it by measuring the interior and calculating volume.
- Check the model/serial label inside the fresh food compartment (commonly on a side wall or door frame); some labels list capacity.
- Review the product data/specifications section in the ED5KVEXVQ00 use & care manual.
- If you only need a close estimate for planning (bins, storage, moving), use the measurement method below.
- Empty one compartment enough to measure safely.
- Measure the usable interior:
- Width (inches)
- Height (inches)
- Depth (inches)
- Multiply:
W × H × Dto get cubic inches. - Convert to cubic feet: divide by 1728.
| What you have | Convert to | Formula |
|---|---|---|
| Cubic inches | Cubic feet | cubic inches ÷ 1728 |
| Inches (W,H,D) | Cubic feet | (W × H × D) ÷ 1728 |
- Measure inside the liner, not the outside cabinet.
- Exclude unusable space taken by:
- Air ducts and vents
- Ice maker housing (if present)
- Shelving supports and molded channels
- Measure fresh food and freezer separately, then add them together.
Knowing cubic feet helps us match the right refrigerator accessories and set expectations for storage. It also helps when comparing side-by-side refrigerators, since similar-looking models can vary in usable space.
Last updated: January 2026
What is the biggest problem in a Whirlpool refrigerator?
For the Whirlpool ED5KVEXVQ00 side-by-side refrigerator, the biggest real-world problem we see is loss of cooling (fresh food too warm, freezer not cold enough, or both). It is often caused by airflow restrictions, dirty condenser areas, or a defrost system issue; all of these are covered in the troubleshooting guidance in the ED5KVEXVQ00 use & care guide.
- Refrigerator section warm but freezer OK: airflow problem (blocked vents, evaporator fan issue, frost buildup from defrost failure)
- Both sections warm: condenser coils clogged, condenser fan not moving air, compressor/start components issue
- Ice maker not making ice: water supply shutoff closed, kinked water line, low water pressure, ice maker off
- Water dispenser slow or leaking: clogged filter, air in lines after filter change, water valve or tubing issue
- Excessive noise: normal operating sounds vs. fan blade hitting ice or a failing fan motor
- Confirm both temperature controls are set near the mid-setting; then wait 24 hours after any adjustment.
- Make sure doors fully close and gaskets seal; warm air leaks can mimic a cooling failure.
- Check for blocked air vents inside both compartments (packages pushed against vents).
- Clean the condenser area if your home is dusty, greasy, or has pets.
- If ice or water performance is poor, replace the water filter and flush the system.
| Symptom | Common part to inspect/replace | Example part for ED5KVEXVQ00 |
|---|---|---|
| Water/ice issues (no fill, weak flow) | Water inlet valve | Refrigerator inlet valve W10408179 |
| Poor water taste/slow dispensing | Water filter | Refrigerator water filter EDR3RXD1 |
| Frost buildup, warm temps | Defrost control | Refrigerator adaptive defrost control board WPW10366605 |
Cooling and airflow problems can quickly lead to food spoilage and can also cause secondary issues like heavy frost, long run times, and weak ice production. Catching the root cause early usually reduces repair cost and downtime.
Last updated: January 2026
Where is the filter on my Whirlpool side by side refrigerator?
On the Whirlpool ED5KVEXVQ00 side-by-side refrigerator, the water filter is located in the base grille at the bottom front of the unit. You access it from the front by opening the grille area and removing the cartridge from the base-grille housing; see the ED5KVEXVQ00 use & care manual.
Most owners will find the filter at floor level, centered or slightly offset in the toe-kick (base grille) area.
- Look at the very bottom front of the refrigerator for the base grille (toe grille)
- Locate the round or cylindrical filter cartridge behind the grille opening
- Remove the filter by turning or releasing it (style varies by production version)
- Keep the small end cap if your filter uses one; you may need it for the replacement
- After installing the new filter, flush the dispenser to clear air and carbon fines
For ED5KVEXVQ00, the manual calls out a standard base filter cartridge replacement. A compatible option listed for this model is the refrigerator water filter EDR3RXD1.
| What to compare | What to look for | Why it matters |
|---|---|---|
| Fit style | Base-grille cartridge style | Prevents leaks and poor sealing |
| Identifier | Part ID and part number | Confirms compatibility for ED5KVEXVQ00 |
| Install method | Twist-in or push/lock style | Ensures you can remove and seat it fully |
| Flow after install | Strong, steady dispenser flow | Low flow can indicate a mis-seated or clogged filter |
- Dispense and discard about 1.5 gallons of water (or about 3 minutes after water starts flowing steadily)
- If your model has a filter status light, reset it after replacement
- If water flow is weak, re-seat the filter and check for trapped air
A correctly installed base-grille filter helps protect water taste and odor performance and helps prevent dispenser and ice maker issues caused by restricted flow.
Last updated: January 2026
