Kenmore Elite 25328093805 freezer Parts

Set your Kenmore Elite upright freezer model 25328093805 to keep food at 0°F (-18°C) for safe long-term storage; then give the cabinet time to stabilize after any adjustment. Use the temperature control guidance in the 25328093805 owner's manual to match the control setting to your kitchen conditions.

• Set the control to a colder setting if foods are soft or ice cream is melting.
• Set the control to a warmer setting if items are rock-hard or packages are frosting over.
• Allow several hours after each change for the temperature to stabilize.
• Limit door openings; warm air entering makes the freezer run longer.
• After a full shutdown or move, allow about 4 hours for the freezer to cool down completely.

Keeping the freezer near 0°F helps prevent partial thawing and refreezing (which hurts food quality) and reduces run time caused by frequent door openings or warm loads.

These issues commonly cause warm temperatures even with the control set correctly:

• Door not sealing well (gasket leaks let warm air in)
• Heavy frost buildup restricting airflow (defrost system issue)
• Evaporator fan not running (no cold air circulation)

If you suspect a failed defrost or airflow problem, common related parts for this model include the defrost heat 5304496284 and the freezer evaporator fan motor 297309000.

Last updated: January 2026

If your Kenmore Elite upright freezer 25328093805 is running but not freezing, the most common causes are incorrect temperature control settings, poor door sealing (warm air leaks), restricted airflow around the cabinet, or a defrost/cooling system problem such as a failed evaporator fan motor or defrost heater. Use the 25328093805 owner's manual troubleshooting steps to narrow it down.

• Make sure the temperature control is not set to OFF (OFF stops the compressor but does not fully disconnect power).
• Confirm the freezer is plugged in firmly and the house breaker is not tripped.
• Limit door openings; frequent openings quickly warm the cabinet.
• Check that the door closes and seals all the way; a slightly open door causes warm, moist air to enter.
• Verify the freezer is level; an unlevel cabinet can misalign the door and prevent a good seal.

A weak seal or poor airflow can mimic a major failure.

• Look for gaps, rips, or hardened areas on the door gasket.
• Clean the gasket and mating surface; dirt can prevent sealing.
• Ensure the freezer has enough clearance for air circulation around it.
• Avoid overpacking; blocked vents reduce cold air movement.

If the freezer is warm and you do not hear normal air movement inside, the evaporator fan system is a prime suspect.

A freezer that is not freezing is often caused by a door sealing or airflow problem, and those are the fastest fixes. Catching a failing evaporator fan motor or defrost heater early also helps prevent food loss and excessive frost buildup.

Last updated: January 2026

For the Kenmore Elite 25328093805 upright freezer, the most reliable “reset” is a power reset: unplug the freezer for a few minutes, then plug it back in and allow time for temperatures to stabilize. You can also unlock the control panel by holding Alarm Reset for 3 seconds. See the 25328093805 use and care guide for control-panel steps and normal display behavior.

• Power reset: unplug the freezer, wait 5 minutes, then plug it back in.
• Control lock reset: press and hold Alarm Reset for 3 seconds to unlock or lock the controls.
• Turn OFF then ON at the panel (if equipped): press the DOWN (v) button until the display shows “0” (OFF), then press UP (^) until it shows “4” or your preferred setting.
• Silence alarms: press Alarm Reset to silence the buzzer (this does not reset cooling).

1. Move food to another freezer or keep the door closed as much as possible.
2. Grip the plug and unplug the unit (do not pull on the cord).
3. Wait 5 minutes.
4. Plug the freezer back in.
5. Let it run several hours before judging temperature changes.

A “reset” clears minor control glitches and restores normal operation after a power interruption, but it will not fix airflow or defrost problems. If the freezer still will not cool after a reset, common causes include a failed evaporator fan motor or a defrost system issue.

Last updated: January 2026

The exact cubic-foot capacity for your Kenmore Elite 25328093805 upright freezer is listed in the specifications section of the 25328093805 owner's manual. If you need a quick planning estimate before you look it up, most full-size upright freezers are commonly in the 14 to 21 cu. ft. range.

Use these checks so you match the correct rating to your freezer.

• Confirm the model number on the rating label is 25328093805.
• Look for a “Specifications” or “Product data” section in the 25328093805 owner's manual.
• If your freezer has multiple variants, match the capacity to the exact model number on the label.
• Use the capacity rating for comparisons; shelves and air channels reduce usable space.

Your manual gives a practical rule for loading: freeze 3 pounds of fresh food per cubic foot of freezer space at one time to help temperatures recover quickly.

Knowing the correct cubic-foot rating helps you plan bulk shopping, choose bins and baskets, and avoid overloading. Following the per-cubic-foot loading guideline reduces long run times and helps keep temperatures stable.

Last updated: January 2026