Kenmore Elite 10656706500 side-by-side refrigerator Parts

Most Kenmore Elite refrigerators, including model 10656706500, typically last 10 to 15 years. With consistent care (cleaning, good door sealing, and stable temperatures), many units reach the high end of that range, and some run longer before major sealed-system repairs become likely.

What affects lifespan the most

• Condenser coil cleanliness: dust buildup makes the compressor work harder.
• Door gasket condition: air leaks cause longer run times and moisture issues.
• Ice maker and water system health: leaks and clogs can create secondary damage.
• Defrost performance: poor defrosting can lead to frost buildup and warm temps.
• Power quality: frequent outages or surges can stress controls and motors.

Maintenance checklist we recommend

• Vacuum coils and the grille area every 6 to 12 months.
• Keep freezer at 0°F and fresh food at 37°F.
• Confirm doors close fully and the cabinet is level.
• Replace the water filter on schedule; a restricted filter can reduce water flow.
• Review the care and troubleshooting sections in the 10656706500 owner's manual.

Common “end-of-life” symptoms vs. fixable issues

Symptom	Often indicates	Typical next step
Warm fridge/freezer, compressor runs a lot	Airflow/coil/defrost issue	Clean coils; check evaporator fan and defrost system
Frost blanket on freezer back wall	Defrost problem	Test defrost thermostat/heater
No ice or slow water	Filter/valve/line restriction	Replace filter; inspect valve and tubing
Loud clicking, hard starts	Start components or compressor strain	Check capacitor/start device; evaluate compressor

Why it matters

Knowing the typical 10 to 15 year lifespan helps you decide when maintenance is worth it versus planning for replacement, especially if a compressor, control board, or sealed-system repair becomes necessary.

Last updated: January 2026

Yes. For Kenmore Elite model 10656706500, the most reliable reset is a power reset: turn the controls OFF, disconnect power, then restore power and set the controls back to your normal temperatures. If your dispenser shows PF after an outage, reset the power outage indicator from the dispenser panel.

Quick reset options (most common)

• Power reset (hard reset): Turn the refrigerator control(s) OFF, unplug the unit (or switch off the breaker), wait about 5 minutes, then restore power and set the controls to the desired setting (see the 10656706500 owner's manual).
• Reset PF (power failure) on the dispenser: If the display reads PF and dispenser functions are disabled, press and hold RESET for 3 seconds until it beeps; the display may show outage hours for about 10 seconds.
• Control lock toggle (dispenser won’t respond): Press and hold LOCKED for 3 seconds to lock or unlock the dispenser.

Step-by-step: power reset (recommended)

1. Turn the Temperature Control or Refrigerator/Freezer Control to OFF.
2. Unplug the refrigerator (or turn off the circuit breaker).
3. Wait 5 minutes.
4. Restore power.
5. Set controls back to your normal settings and allow time for temperatures to stabilize.

What to check right after a reset

• Confirm the outlet has power (test with a lamp).
• Make sure the controls are ON and not set to OFF.
• Allow up to 24 hours after restoring power for full cooling.
• Verify air vents inside the compartments are not blocked by food packages.

When a “reset” won’t fix the problem

A reset clears temporary control issues, but it will not correct a failed part or a water flow restriction.

Symptom	Most likely next step
Dispenser shows PF	Hold RESET 3 seconds on the dispenser
No water or slow water	Replace the filter; check supply valve and tubing
No ice	Confirm ice maker is on; check water supply and fill system

If you are troubleshooting water or ice performance, the refrigerator water filter EDR3RXD1 is the correct filter option listed for this model.

Why it matters

Resetting the control system restores normal operation after a power interruption and re-enables dispenser features (PF mode disables them). It also helps you separate a one-time control glitch from a true cooling, ice maker, or water supply problem.

Last updated: January 2026

Your Kenmore Elite model 10656706500 has 25.6 cu. ft. of total capacity (about 15.4 cu. ft. fresh food plus 10.2 cu. ft. freezer). For the exact breakdown and feature details for your configuration, use the 10656706500 owner's manual.

Capacity breakdown for model 10656706500

Here is the standard capacity split used for this model:

Section	Capacity
Refrigerator (fresh food)	15.4 cu. ft.
Freezer	10.2 cu. ft.
Total	25.6 cu. ft.

What can change the space you actually use

Even with the same rated cubic feet, usable storage can feel smaller or larger depending on setup.

• Ice maker and storage bin reduce freezer room for bulky items
• Door bins and shelf positions affect tall-item clearance
• Air channels and vents take up some interior volume
• Filter housing and dispenser components can reduce door storage

How to verify on your appliance

Use these quick checks to confirm you are matching the right specs to the right refrigerator.

• Match the model/serial tag inside the fresh food section to 10656706500
• Check the specifications section in the 10656706500 owner's manual
• Compare your shelf and bin layout to the manual illustrations

Why it matters

Capacity helps you compare side-by-side refrigerators accurately and plan kitchen fit and food storage. The total cubic feet is a standardized volume; the layout and ice maker setup determine how much you can comfortably store.

Last updated: January 2026