Kenmore 59672382411 refrigerator Parts

Common problems we see on Kenmore Elite refrigerators like model 59672382411 include warm temperatures from airflow or defrost issues, frost buildup, water dispenser or ice maker failures, leaks, and unusual noises. Many of these trace back to door sealing, fan operation, or water supply and filtration setup (see the 59672382411 owner's manual).

• Not cooling or weak cooling: dirty condenser coils, blocked vents, evaporator fan issues, or a defrost problem causing ice on the evaporator
• Frost buildup in freezer: door not sealing, frequent door openings, or a defrost heater/control issue
• Loud humming, buzzing, or rattling: evaporator fan, condenser fan (if equipped), or compressor/inverter related noise
• Water leaking or puddles: clogged defrost drain, mis-seated water line, or dispenser/ice maker supply leak
• Ice maker not making ice: low water pressure, frozen fill tube, or a failing ice maker module
• Water dispenser slow or not dispensing: shutoff valve not fully open, kinked line, low water pressure, or a valve problem

1. Confirm doors close and seal fully (a poor seal causes frost and temperature swings).
2. Allow 24 hours after installation or major temperature changes for full stabilization.
3. Check water supply basics:
   • Shutoff valve fully open
   • No kinks in the supply line
   • Home water pressure at least 35 psi
4. Flush the water system after a filter change if you see gray or dark discoloration in water or ice.
5. Listen for the evaporator fan when the doors are closed; loss of airflow is a common root cause of warm temps.

Cooling, ice, and water problems often cascade: a small door-seal gap can create frost, frost blocks airflow, and then temperatures rise. Addressing the root cause early helps protect food, reduce energy use, and prevent repeat failures.

If you’re ready to order, we list model-matched replacement parts for 59672382411 on this page, and you can also search by model number on Sears PartsDirect.

Last updated: February 2026

If your Kenmore 59672382411 is warm at the bottom, the most common causes are restricted airflow (blocked vents or a stuck damper), dirty condenser coils reducing heat removal, or an evaporator fan issue that prevents cold air from circulating. Confirm your temperature settings in the owner's manual first.

• Set the refrigerator to the factory recommended 37°F and the freezer to 0°F, then wait 24 hours before judging results.
• Make sure air vents are not blocked by food packages (this is a top cause of “cold on top, warm on bottom”).
• Clean condenser coils (dust and pet hair can cause weak cooling, especially in the fresh food section).
• Verify the doors close fully and the gaskets seal all the way around.
• Listen for the evaporator fan; if it is not running, cold air will not move through the refrigerator.

Bottom-area warming usually points to an airflow restriction between the freezer evaporator and the refrigerator compartment.

• Blocked return or supply vents inside the refrigerator
• Damper not opening (limits cold air entering the fresh food section)
• Frost buildup on the evaporator (can choke airflow)

If you suspect the damper is sticking or not responding to temperature changes, the refrigerator air damper control assembly WPW10248595 is the model-matched part to check.

When the bottom of the refrigerator stays warm, food safety is the concern. Restoring proper airflow and heat removal helps the refrigerator hold a steady 37°F and prevents spoilage.

We list model-specific replacement parts for Kenmore 59672382411 on this page; you can also search by model number on Sears PartsDirect.

Last updated: February 2026

The model number and serial number for your Kenmore refrigerator are printed on the model and serial number label on the product. For model 59672382411, use that label to record the complete model number and serial number for parts lookup and service.

Check these common label locations for bottom-mount Kenmore refrigerators like model 59672382411:

• Inside the fresh food compartment on a side wall
• On the ceiling of the fresh food compartment near the light
• Behind the crisper drawers on an interior wall
• Along the door frame when you open the refrigerator door
• On a label visible when the freezer drawer is pulled open (less common)

If you see a model prefix like 596.7238 on the tag, keep looking for the full model number; the complete number is what you will use to match parts correctly.

Record all the information exactly as shown on the label:

• Complete model number
• Serial number
• Purchase date (if available)

The full model number identifies the exact configuration (doors, controls, ice maker, and internal components). Using the complete model number prevents ordering the wrong refrigerator door gasket, thermistor, or water inlet valve.

• Wipe the label gently with a damp cloth and dry it
• Take a close-up photo and zoom in
• Copy the characters exactly (including dots or dashes if shown)

For more label and recording details, use the owner's manual.

Last updated: March 2026