Edgestar Wine & beverage cooler Parts — Browse All Models

Most common Edgestar wine cooler parts that need replacing

1. Leveling leg. The leveling leg adjusts to keep the wine or beverage cooler cabinet level when you install the cooler in its permanent location.
2. Light switch. The light switch turns the interior light on and off when you open and close the cooler door.
3. Temperature sensor. The temperature sensor detects temperature inside the wine or beverage cooler cabinet and sends a signal to the electronic control board to indicate interior temperature.
4. User interface control. The user interface control allows you to select wine or beverage cooler settings.
5. Compressor. The compressor is a positive displacement pump rotated by an electric motor. The compressor receives low-pressure refrigerant gas from the evaporator and rotates to compress that refrigerant to a high-pressure gas that moves through the condenser. The refrigerant gets hot when compressed by the compressor pump. The condenser is a heat exchanger that removes heat from the refrigerant gas and condenses it into a high-pressure liquid refrigerant. The high-pressure liquid refrigerant flows through the expansion device and into the evaporator that's at low pressure. The high-pressure refrigerant expands and evaporates. It absorbs the latent heat of vaporization as it changes from a liquid to a gas, which causes the cooling action in the evaporator. The refrigerant flows through the evaporator and back to the compressor where the cycles starts over.

How to reverse the door swing on your Edgestar wine or beverage cooler

1. Unplug the wine or beverage cooler power cord to disconnect electrical power.
2. Remove the toe grill mounting screws and pull the toe grill off the wine or beverage cooler.
3. Remove the upper hinge bracket cover.
4. Remove the upper hinge bracket mounting screws. Support the door while removing the last mounting screw to keep from bending the door hinge pin at the bottom of the cabinet. Remove the upper hinge bracket while still supporting the door.
5. Carefully lift the door off the hinge pin at the bottom of the cabinet and place the door on a padded surface.
6. Move the hinge pin to the opposite side of the wine or beverage cooler cabinet.
7. Install the door on the hinge pin and support the door while installing the upper hinge bracket with its pin inserted in the top of the door. Reinstall the upper hinge bracket cover.
8. Plug the power cord back into the wall outlet to restore power to the wine or beverage cooler.