Kirkland Washer Parts — Browse All Models

Troubleshooting common Kirkland washer problems

Kirkland washers are built to last, but age, heavy use, or faulty components can lead to performance issues. Here's how to spot the source and take the next steps.

Washer won’t drain or spin

If your washer is stuck with standing water, check for a kinked or clogged drain hose first. If that’s clear, a failed drain pump may be to blame. On top-load models, a defective lid switch can also interrupt the cycle. You can replace the drain pump or install a new lid switch to restore function.

Washer fills constantly or overfills

A damaged or stuck-open water inlet valve may cause the tub to fill nonstop, even when the washer is off. Swap out the water inlet valve if that’s the case. Overfilling during the cycle could also indicate a faulty water-level pressure switch.

Commonly replaced Kirkland washer parts

• Lid switch – Prevents the washer from operating with the lid open. A failed switch stops cycles from starting or spinning.
• Drain pump – Removes water after each cycle. Replacing it can resolve poor draining or standing water.
• Water inlet valve – Regulates the flow of water into the tub. Failure can cause leaks or overfilling.
• Drive belt or motor coupler – These parts transfer power to the spin basket. Wear or breakage can halt agitation or spinning.
• Control board – Coordinates washer functions. If the washer is unresponsive or erratic, a faulty control board may be the issue.

Why use Sears PartsDirect for Kirkland washer repairs

You’ll get OEM replacement parts that are designed to fit your Kirkland washer model number. Illustrated parts diagrams show exactly where each part fits, and our DIY washer repair help offers step-by-step instructions and videos to help you complete your repair confidently.

Kirkland washer FAQs

Who makes Kirkland washers?

Most Kirkland Signature washers were manufactured by Whirlpool and may share parts and design similarities with Whirlpool models.

How do I find my Kirkland washer model number?

Look for a label on the underside of the lid or inside the door frame. It may also be located on the rear panel or under the control console.

Why does my washer make a loud banging noise during spin?

This often means the load is unbalanced. If redistributing doesn’t fix it, worn suspension rods or shock absorbers might be the issue.

Can I replace the control board myself?

Yes, if you're comfortable working with electronics. Be sure to unplug the washer and refer to a service manual or a guide before replacing the board.

What’s the average lifespan of a Kirkland washer?

With routine maintenance and repairs as needed, Kirkland washers can typically last 12–15 years.