Kenmore Elite 25344733107 freezer Parts

If your Kenmore Elite upright freezer model 25344733107 is running but not freezing, the problem is usually poor airflow, heavy frost from a defrost failure, dirty condenser area, or a sealed-system/compressor issue. Start with the quick checks below before replacing parts; see the 25344733107 owner's manual for model-specific settings and access steps.

Quick checks that fix many “not freezing” complaints

• Confirm the temperature control is set colder and the door is fully closing.
• Make sure vents inside the cabinet are not blocked by food packages.
• Check for heavy frost on the back interior panel (a strong sign of a defrost problem).
• Clean dust from the condenser area and verify the unit has a few inches of clearance for airflow.
• Listen for the evaporator fan; you should hear a steady fan sound when the compressor is running.

What the symptoms usually mean

What you notice	Most likely cause	What to do next
Warm freezer, compressor runs, little or no air movement inside	Evaporator fan not running	Test/replace the freezer evaporator fan motor 297309000
Frost blanket on back wall, temps slowly rise	Defrost system failure	Check the defrost timer 5304518034, defrost heater, and defrost thermostat
Door won’t seal, frost around door, moisture	Air leak at door	Inspect/replace the refrigerator door gasket (black) 5304507206
Runs a lot, still not cold, little frost pattern	Sealed system or compressor issue	Professional sealed-system diagnosis is needed

Parts commonly involved on model 25344733107

• Evaporator fan motor (moves cold air through the freezer)
• Defrost timer (initiates defrost cycles)
• Defrost heater and defrost thermostat (melt and control frost removal)
• Door gasket (prevents warm air leaks)
• Compressor kit (for sealed-system repairs)

Why it matters

When airflow is restricted or frost builds up on the evaporator, the freezer cannot move cold air effectively, so temperatures rise even if the compressor is running. Fixing the root cause early helps prevent food spoilage and reduces compressor run time.

Last updated: January 2026

Most Kenmore upright freezers, including model 25344733107, do not have a single dedicated “reset” button. We reset the freezer by power-cycling it and then confirming the temperature control settings and door seal so the control can stabilize and cool normally.

Quick reset steps (safe and effective)

• Unplug the freezer (or switch the breaker off).
• Wait 5 minutes to let the control board fully discharge.
• Plug it back in (or turn the breaker on).
• Set the temperature back to your normal setting.
• Keep the door closed for 4 to 6 hours to let temperatures stabilize.
• If the alarm is sounding, confirm the door is fully closed and latched.

What to check if “resetting” does not fix the issue

A reset only helps if the problem is a temporary control glitch or a brief power interruption. If cooling or temperature swings continue, we check these common causes:

• Door not sealing: torn, warped, or dirty gasket lets warm air in.
• Heavy frost on the back wall: points to a defrost system problem.
• Fan not running: poor airflow causes warm spots and slow recovery.
• Overpacked cabinet: blocks vents and airflow.
• Dirty condenser area (if accessible): reduces heat removal.

Parts that commonly relate to “won’t cool” or frost buildup

If symptoms match, these model-compatible parts are often involved:

Symptom	Likely system	Example part for 25344733107
Heavy frost, warming over time	Defrost cycle	Defrost timer 5304518034
Frost returns quickly after manual defrost	Defrost heat/sensing	Defrost heater 216730700 and chest freezer defrost thermostat 297216600
Warm cabinet, weak airflow	Evaporator airflow	Freezer evaporator fan motor 297309000
Moisture, frost near door edge	Door seal	Refrigerator door gasket (black) 5304507206

Why it matters

A proper reset and correct temperature setting prevent unnecessary part replacement. If the freezer is actually losing airflow, defrosting incorrectly, or leaking air at the door gasket, it will keep warming up no matter how many times we “reset” it.

For control locations, recommended settings, and alarm behavior for model 25344733107, use the 25344733107 manual.

Last updated: January 2026

The Kenmore Elite upright freezer model 25344733107 has a 20.5 cubic foot capacity. You can confirm the published capacity and other specifications in the 25344733107 owner's manual.

Quick ways to verify capacity on the freezer

• Check the model and rating label inside the cabinet (often on a side wall).
• Look in the manual under Specifications for “capacity,” “total volume,” or “cu. ft.”
• Compare the model number on the label to your paperwork to ensure it matches 25344733107.
• If you are shopping for storage accessories, use the model number to match the correct baskets, rails, and door parts.

Capacity terms you may see

Term	What it means	What to use for comparisons
Total (gross) capacity	Overall internal volume measurement	Best for model-to-model comparisons
Usable capacity	Space available after shelves, bins, air channels	Best for real storage planning

Why it matters

Knowing the 20.5 cu. ft. capacity helps you plan food storage, compare energy and size classes, and choose correctly fitting organization parts such as shelf frames, basket slide rails, and door components.

Last updated: January 2026