Electrolux EFLS517STT0 washer Parts

To reset your Electrolux EFLS517STT0 washer, we recommend doing a simple power reset first: turn the washer off, unplug it (or switch the breaker off) for 1 to 5 minutes, then restore power and start a cycle. For model-specific reset steps, use the EFLS517STT0 owner's manual.

Quick reset options (start with the easiest)

• Power reset: Unplug washer for 1 to 5 minutes, then plug back in.
• Breaker reset: Turn the laundry circuit breaker off for 1 to 5 minutes, then back on.
• Cancel and restart: Press Cancel (or Power Off), wait 10 seconds, then select a new cycle.
• Door reset: Open the door, wait 10 seconds, close it firmly, then press Start.

If the washer still will not start after resetting

These checks solve most “won’t start” and “stuck” situations on front-load washers:

• Confirm the outlet has power (test with a lamp or phone charger).
• Make sure the door closes fully and latches; a misaligned strike can prevent operation.
• Reduce the load size; an overpacked drum can keep the door from closing correctly.
• Check for standing water; a drain issue can stop the control from advancing.
• Clean the pump filter area if your model uses one; a clog can mimic a control problem.

Common symptoms and what the reset helps

Symptom	What a reset can fix	What to check next
Control panel frozen	Clears a temporary software lockup	Power supply, cycle selection
Door won’t unlock after cycle	Lets the control reinitialize	Drain/pump, water left in tub
Cycle won’t start	Clears a stuck state	Door latch/strike alignment

Why it matters

A reset clears minor control glitches after a power flicker, paused cycle, or interrupted drain. If the issue returns, it usually points to a door-latch problem, a drain restriction, or a power supply issue rather than the control itself.

Last updated: January 2026

An Electrolux washer like model EFLS517STT0 typically lasts 10 to 15 years. You will get the longest life when the washer is installed correctly, kept clean, and common wear items (like door seals and pumps) are addressed early using the guidance in the EFLS517STT0 owner's manual.

What affects washer lifespan most

• Load size and frequency: daily heavy loads shorten life faster than moderate use.
• Detergent habits: too much HE detergent can cause residue, odors, and extra strain.
• Water quality: hard water increases scale buildup in hoses, valves, and the tub.
• Vibration and leveling: an unlevel washer wears shocks, springs, and bearings faster.
• Door seal care: a dirty or torn boot can lead to leaks and corrosion.

Maintenance that adds years (simple, high impact)

• Run a monthly cleaning cycle; wipe the door glass and gasket after use.
• Leave the door slightly open between loads to dry the drum.
• Check pockets to prevent coins and debris from damaging the drain system.
• Clean the pump filter when draining slows; replace it if cracked or stripped.
• Inspect the door seal for tears or mold; replace the washer door boot 5304505004 if it starts leaking.

Quick expectations by usage level

Usage pattern	Typical life expectancy	What usually fails first
Light (1 to 3 loads/week)	12 to 15 years	Door seal, drain pump filter
Average (4 to 7 loads/week)	10 to 13 years	Drain pump, shocks
Heavy (multiple loads/day)	7 to 10 years	Suspension, pump, bearings

Why it matters

Knowing the 10 to 15 year lifespan helps you decide whether to repair or replace. If your EFLS517STT0 is under about 10 years old, replacing common parts (door boot, drain pump, water-level sensor) often restores reliable performance at a lower cost than a new washer.

Last updated: January 2026

Electrolux front-load washers like model EFLS517STT0 most often have issues related to draining, leaking at the door, door locking, filling, spinning, and vibration. Many of these problems trace back to a few wear parts (door boot, drain pump system, shocks) or simple maintenance and loading habits; see the EFLS517STT0 owner's manual for model-specific error codes and checks.

Most common symptoms (and what they usually point to)

• Won’t drain / water left in tub: clogged pump filter, blocked drain hose, failing drain pump
• Leaks at the front/door: torn or mis-seated door boot, loose clamp, debris on the sealing lip
• Door won’t lock or won’t start: worn door strike, failing door lock assembly
• Excessive vibration or banging in spin: unbalanced load, leveling issue, worn shock absorbers
• Won’t fill or fills slowly: closed supply valves, kinked hoses, clogged inlet screens
• Poor cleaning or odors: too much detergent, low-temp washing only, dirty gasket and dispenser

Quick checks we recommend before replacing parts

1. Unplug the washer for 2 minutes, then restore power and retry the cycle.
2. Confirm the washer is level and all feet are firmly on the floor.
3. Run a Drain/Spin cycle with the tub empty to isolate load-balance issues.
4. Clean the pump filter area and check the drain hose for kinks.
5. Inspect the door seal for small tears, coins, hairpins, or detergent buildup.

Parts that commonly solve these problems on EFLS517STT0

Symptom	Likely part to inspect	Example part for this model
Leaking at door	Door seal and clamp	Washer door boot 5304505004, washer door boot spring clamp 134616300
Door won’t latch/lock	Strike and lock	Frigidaire washer door strike 5304505088, washer door lock assembly 5304514774
Won’t drain	Filter and pump	Washer drain pump filter 5304505165, washer drain pump assembly 5304514775
Shakes violently	Suspension/damping	Washer single stage shock absorber 137412601

Why it matters

Catching a drain restriction, door-seal leak, or vibration issue early helps prevent water damage, repeated “no spin” situations, and premature wear on the tub and motor system.

Related DIY help

• How to get rid of mold in a front load washer
• Cleaning the drain pump filter on a front load washer with no access door video
• Troubleshooting excessive vibration during spin cycle on a washer

Last updated: January 2026