LG LSC27925ST/00 refrigerator Parts

The LG LSC27925ST side-by-side refrigerator has a total capacity of 26.5 cu. ft., with 10.2 cu. ft. in the freezer (the remaining capacity is in the fresh food section). For feature and compartment details specific to your unit, use the LSC27925ST manual.

Capacity is the interior storage volume; it helps you compare similar LG side-by-side refrigerators and estimate usable space for groceries.

• Total capacity: 26.5 cu. ft.
• Freezer capacity: 10.2 cu. ft.
• Fresh food capacity (calculated): 16.3 cu. ft.
• Usable space can feel smaller once shelves, bins, and the ice maker are installed
• Door bins and crisper drawers affect how the space is organized, not the rated volume

Knowing the capacity helps when you are planning a kitchen layout, comparing replacement models, or deciding how much food storage you can realistically expect from the LSC27925ST.

Last updated: January 2026

For the LG LSC27925ST side-by-side refrigerator, the most common customer-reported issue is a cooling problem (refrigerator and or freezer not staying cold). In many cases, the root cause is airflow or sealed-system related, so we start with basic checks before suspecting major components; see the LSC27925ST manual.

• Fresh food section warm but freezer still cold
• Freezer warm and ice cream soft
• Unit runs constantly or cycles too often
• Clicking, buzzing, or louder-than-normal running noise
• Frost buildup on the freezer back wall
• Ice maker and water dispenser performance drops after cooling issues start

1. Confirm temperature settings (typical targets are 37°F fresh food and 0°F freezer).
2. Make sure vents inside both compartments are not blocked by food.
3. Clean dust from condenser area and verify the condenser fan is moving air.
4. Listen for the evaporator fan; if it is not running, airflow will be weak.
5. Check door gaskets for gaps and torn sections.

If your LSC27925ST is not cooling well, these model-matched parts are often involved depending on the symptom:

Cooling problems can quickly lead to food spoilage and can also trigger secondary issues like frost buildup, water leaks from defrost drain icing, and ice maker failures. Catching airflow problems early can prevent longer run times and extra wear on the compressor.

Last updated: January 2026

On the LG LSC27925ST, an ice maker usually stops working because it is turned off, the ice bin is jammed, the freezer is not cold enough to harvest ice, or the refrigerator is not getting steady water flow (often from a clogged filter or a weak inlet valve). Use the checks below, then test the water-supply parts.

• Confirm the ice maker is switched ON and the shutoff arm (if equipped) moves freely.
• Make sure the ice bin is fully seated and not packed with clumped ice.
• Verify the freezer is cold enough for ice production (target about 0°F).
• Dispense water at the door (if equipped); weak or no water points to a supply issue.
• Look for a frozen fill tube or ice blocking the mold.

For control locations and basic operating steps specific to this model, use the LSC27925ST manual.

If water dispensing is slow or the ice maker never refills, focus on the filter and valve.

• Replace the refrigerator water filter if it is overdue or flow is reduced: LG lt500p refrigerator water filter ADQ72910911.
• If a new filter does not restore flow, the inlet valve may be sticking or not opening fully: refrigerator water inlet valve 5221JA2006D.
• If you are troubleshooting a filter housing issue (leaks, poor flow at the head), inspect the filter head and tubing connections.

The ice maker on the LSC27925ST depends on two things: freezer temperature cold enough to cycle, and consistent water flow through the filter and inlet valve. Fixing the root cause prevents repeat clogs, hollow cubes, and dispenser leaks.

Last updated: January 2026

To reset the ice maker on an LG LSC27925ST, make sure the ice maker is turned ON and the freezer is cold enough, then press and hold the ice maker’s reset/test button for about 3 to 5 seconds to start a test cycle. Allow up to 24 hours for normal ice production to resume.

1. Confirm the ice maker switch/lever is in the ON position.
2. Verify freezer temperature is set cold (ice makers typically need a properly freezing compartment to cycle).
3. Locate the ice maker reset/test button (commonly on the underside or side of the ice maker module in the freezer).
4. Place a towel under the ice maker area (a test cycle can drop ice or water).
5. Press and hold the reset/test button for 3 to 5 seconds, then release.
6. Close the freezer door and wait; check for ice within 24 hours.

For diagrams and control locations specific to this model, use the LSC27925ST manual.

These checks solve most “no ice” complaints on side-by-side refrigerators:

• Confirm the household water supply valve is fully open.
• Make sure the fill tube is not frozen or blocked.
• Replace an overdue water filter (restricted flow can reduce or stop ice production).
• Dispense water at the door (if water is weak, the ice maker usually will not fill well).
• Check for a kinked water line behind the refrigerator.
• If you hear no water fill during a harvest cycle, the inlet valve may not be opening.

Model-matched parts that commonly affect ice production include the refrigerator water inlet valve 5221JA2006D and the LG lt500p refrigerator water filter ADQ72910911.

A reset forces a test cycle, which helps clear a stalled ice maker and quickly tells you whether the ice maker can harvest and call for water. If it resets but never refills, the issue is usually water flow (filter, tubing, inlet valve) rather than the ice maker itself.

Last updated: January 2026