White-Westinghouse Gas range Parts — Browse All Models

How to replace a White-Westinghouse gas range burner spark igniter electrode

• Shut off gas and electrical power to the range.
• Remove the grates, burner caps and burner heads.
• Remove screws that secure the top of the cooktop to the top of the burner orifice holders.
• Release the mounting clips under the front edges of the cooktop then lift the cooktop off the range and set the cooktop aside.
• Carefully disconnect the wire that's attached to the bottom of the spark igniter electrode.
• Release the metal clip from the bottom of the gas burner orifice holder and remove the clip.
• Remove the spark igniter electrode from the burner orifice holder assembly and discard it.
• Install the new spark igniter electrode and reassemble the range.
• Restore the gas supply and electrical power to the range.

Installing a new spark module in your White-Westinghouse gas range

• Carefully pull the range forward and unplug it. If necessary, have someone assist you when moving the range. Shut off the gas supply to the range.
• Remove screws from the upper panel on the back of the range and then pull the upper back panel off the range. As you remove the last screw, press on the upper back panel to prevent it from dropping.
• Disconnect all the wires attached to the spark module. The type of locking tabs or fasteners varies by model. Release the locking tab and remove the spark module from the mounting bracket. Discard the spark module.
• Position the new spark module on the top of the mounting bracket and push it into place. The locking tab should snap into place when the module is in the right position. Connect the wires to the new spark module.
• Position the upper back panel on the back of the range and hold in in place while replacing the first screw or two. Replace all of the screws and tighten them firmly.
• Plug the range back into the wall outlet and the open the gas supply valve. Slide the range into position, making sure the rear foot of the range properly engages the anti-tip bracket.