Eureka Wet/dry vacuum Parts — Browse All Models

Vacuuming liquids using your Eureka wet/dry vacuum

• Unplug the power cord to disconnect power from the shop vacuum.
• Remove the paper cartridge filter then install the foam sleeve filter.
• Plug in the power cord and turn on the shop vacuum.
• Vacuum the liquids using the proper attachments.
• A float valve stops suction action when the canister is full of water. Empty the canister when the float valve trips.
• After use, empty the collection tank and dry the inside of the canister before storage.

Common replacement parts for Eureka wet/dry vacuums

• Caster wheels. The caster wheels fit on the bottom of the shop vacuum canister and allow you to roll the shop vacuum to the location needed.
• Power switch. The power switch turns the shop vacuum suction motor on and off.
• Paper filter. The paper filter traps dust and lint in the canister and prevent contaminants from going out through the exhaust port.
• Foam filter sleeve. The foam filter sleeve fit over the filter cage and is used when vacuuming liquids.