Tappan Gas range Parts — Browse All Models

Common replacement parts for your Tappan gas range

• Surface burner spark module. The surface burner spark module is in the ignition circuit for the gas surface burners. When a surface burner control knob is turned to the 'Lite' position, it provides voltage to the spark electrodes on the gas surface burners. If the surface spark module fails to provide the electrodes with voltage, then it should be replaced.
• Surface burner spark igniter switch. The igniter switch is an electrical switch on the stem of the gas surface burner control valve. This switch completes a circuit to the surface burner spark module, causing the burner igniters to spark when the burner switch is turned to the Lite position. Replace the burner igniter switch if the burners don't spark when you turn the burner control knob to the Lite position or if igniters spark constantly even when the burner knobs are in the Off position.
• Oven burner igniter. Most gas ovens have a glow-bar oven igniter and a safety gas valve. Those components are connected in a series-type electrical circuit. When the glow-bar oven igniter is hot enough to safely ignite the gas, the safety gas valve opens. Replace the oven igniter if doesn't glow, or if it glows but doesn't get hot enough to open the gas valve. Some ovens have a separate igniter for the bake burner and the broiler burner, which operate on the same principle.

Troubleshooting your Tappan gas range when the oven won't heat

• Check the gas supply. If surface burners aren't working, check your gas supply cut-off valve to make sure it's open.
• Test the igniter. Pull the bottom oven panel out and start the oven. If the igniter glows but doesn't light the burner, it may not be getting hot enough to open the safety gas valve. You'll likely need to replace the igniter.
• If the igniter doesn't glow, measure resistance through the igniter using a multimeter. Replace the igniter if the meter measures infinite resistance.
• Test the safety gas valve. Measure resistance through the safety gas valve using the multimeter. The meter should measure less than 5 ohms of resistance through the gas valve. If the meter measure infinite resistance, you'll need to have a service technician replace the safety gas valve.