Jenn-Air Wall oven/microwave combo Parts — Browse All Models

Repairing arc burn marks inside the microwave cavity of your JennAir wall oven microwave combo

• For microwaves that are not stainless steel on the inside, you can repair arc marks up to the size of a quarter using this touch-up paint, but only if the marks appear on the inside walls, the floor, or the ceiling. Don't attempt repairs on the outer frame, or the door. Any repairs to the door or frame could affect the shielding and cause radiation leaks. And don’t attempt repairs on burn marks larger than a quarter, as that could be a sign of a more serious problem and should be checked out by a service technician. Also, don't use this repair on microwaves with a stainless steel the inside, because the paint won’t stick.
• Clean the area using soapy water and dry the spot thoroughly.
• Sand the burnt spot down to bare metal using a fine grit sand paper. Wipe the area clean to remove any residue.
• Apply a thin coat of microwave cavity touch up paint. Wait for 5 minutes to allow the first coat of paint to dry. Reapply a second coat of microwave cavity touch-up paint. Be sure to wait 24 hours for the paint to dry before using your microwave.

Common replacement parts for JennAir wall oven microwave combos

• Thermal switch. The thermal switch is located on the back of the wall oven. It trips if the wall oven overheats.
• Electronic oven control board. The electronic oven control board senses oven temperature and cycles the bake element and broil element on and off to maintain the oven temperature that you set on the control panel.
• Control panel. The control panel houses the selection buttons that allow you to choose oven settings and the control display.
• Oven temperature sensor. The oven temperature sensor detects oven temperature and sends the temperature signal to the electronic control board to help maintain set oven temperature.