Electrolux EW28BS87SS1 refrigerator Parts

Yes. For your Electrolux EW28BS87SS1 refrigerator, we recommend DIY replacement for many non-sealed-system parts (filters, gaskets, sensors, fans, ice maker components) as long as you unplug power first and follow the steps in the EW28BS87SS1 owner’s manual. Sealed refrigeration repairs (compressor, evaporator tubing) are professional-level.

What you can usually replace yourself

These repairs are typically straightforward with basic hand tools and careful handling:

• Air filter and routine maintenance items
• Ice maker assembly and related water/ice components
• Door gaskets and hinges (fit and alignment matter)
• Temperature sensors (thermistors)
• Fan components (blade or motor)
• Drawer removal and reinstallation (follow the screw locations)

Safety and prep steps we follow

The manual for this model calls out key electrical safety points; we use these steps before any repair:

• Unplug the refrigerator (controls set to “off” do not remove power to all components)
• Use a dedicated, properly grounded 115V outlet; do not use extension cords or adapters
• Pull the plug by gripping the plug, not the cord
• Protect floors and avoid stressing water lines when moving the unit
• Keep track of screws; only remove the fasteners specified in the instructions

DIY vs. pro: quick decision guide

Repair type	Typical DIY?	Why
Filters, gaskets, hinges, drawers	Yes	Low electrical risk; mostly mechanical fitment
Fans, sensors, ice maker	Often	Moderate disassembly; unplug first
Control boards, wiring issues	Sometimes	Requires careful diagnostics and safe handling
Sealed system (compressor, refrigerant tubing)	No	Specialized tools and refrigerant handling

Model-specific tip: freezer drawer removal

Your installation instructions describe removing the freezer drawer by taking out 4 hex-head drawer screws, lifting the drawer off, then reinstalling and tightening those same 4 screws. Use the EW28BS87SS1 installation guide so you do not loosen or remove the wrong screws.

Parts that commonly come up on this model

If your symptom points to one of these, matching the part by model is the fastest way to avoid returns:

• Odors: refrigerator door air filter EAFCBF
• No ice or poor ice harvest: refrigerator ice maker 243297613
• Warm temps or noise from freezer area: refrigerator evaporator fan motor 809069206
• Water not dispensing or slow fill: refrigerator water inlet valve assembly 242253002

Why it matters

DIY repairs can save time and money, but the right prep (unplugging power, using correct fasteners, and keeping doors sealing properly) prevents repeat failures like leaks, frost buildup, and temperature swings.

Last updated: February 2026

On an Electrolux EW28BS87SS1 refrigerator, water leaking underneath is usually caused by a clogged defrost drain, a cracked or shifted drain pan, or a leaking water supply connection to the ice maker or dispenser. Start by checking the drain path and all water line fittings.

Quick checks we recommend first

• Verify the refrigerator is level so defrost water flows to the drain pan (front-to-back and side-to-side).
• Look for ice or debris blocking the defrost drain opening inside the freezer or fresh food section.
• Inspect the drain pan underneath for cracks, overflow, or being out of position.
• Check the household water line and compression fittings behind the unit for slow drips.
• Avoid 1/4-inch plastic water tubing; it increases leak risk compared to copper or braided stainless.

Most common causes and what to do

Symptom	Most likely cause	What to do next
Water appears after defrost cycles	Defrost drain partially blocked	Flush the drain with warm water; clear the tube with a flexible cleaner (no sharp tools).
Water only when dispensing or making ice	Supply connection or valve leak	Tighten fittings; inspect the refrigerator water inlet valve assembly 242253002 for seepage.
Water under front center	Drain pan shifted or cracked	Re-seat the pan; replace if damaged.
Ice buildup then water later	Drain line freezing or restricted airflow	Clear drain; confirm doors seal and airflow is not blocked by packages.

Water line and valve leak tips (model-relevant)

Your installation instructions call out turning the water supply on and tightening any connections that leak. Use the installation guide to confirm the correct routing and connection points, and leave a service loop so the refrigerator can be pulled out without stressing the line.

Why it matters

Leaks can damage flooring and also lead to ice maker and dispenser problems if the water supply system is dripping or pulling air. Fixing the drain or water line early prevents repeat puddles and temperature swings.

Last updated: February 2026

The average lifespan of an Electrolux refrigerator like model EW28BS87SS1 is 13 years. Regular maintenance (clean airflow paths, good door sealing, and stable temperatures) helps it reach that service life and reduces compressor and defrost-system strain.

What affects lifespan the most

• Door seal condition: air leaks force longer run times and can lead to frost and temperature swings.
• Condenser airflow and cleanliness: restricted airflow raises operating temperatures and workload.
• Ice maker and water system health: slow fills, leaks, or valve issues can create recurring problems.
• Defrost performance: a normal defrost cycle runs periodically (about 30 minutes), but failures can cause heavy frost and warm temps.
• Temperature control accuracy: sensor or control issues can cause overcooling, warming, or error codes.

Quick maintenance checklist (monthly to quarterly)

• Keep food packages from blocking interior air ports.
• Confirm doors close fully and the gasket makes full contact all the way around.
• Vacuum dust from the toe-kick area and ensure the unit has breathing room.
• Replace consumables on schedule (air filter, water filter if equipped).
• Watch for new noises (fan rubbing, clicking, or buzzing) and address early.

Common wear items vs. major components

Category	Examples	Typical impact on lifespan
Consumables	Air filter, water filter	Improves odor and water quality; low cost upkeep
Wear parts	Door gasket, fan motor, inlet valve	Prevents long run times, leaks, and poor cooling
Major sealed system	Compressor, evaporator, condenser	Most expensive repairs; strongly tied to airflow and run time

Why it matters

A refrigerator that runs too long or too often (common with airflow restrictions or door leaks) puts extra load on the variable-speed compressor and cooling system. Keeping seals tight and airflow clear is the simplest way to protect long-term reliability.

For model-specific care and operating guidance, follow the EW28BS87SS1 owner’s manual.

Last updated: March 2026