Jenn-Air JDPSG244LS2 dishwasher Parts

The most common dishwasher failure is a drain problem: water stays in the tub because the filter area or drain path is restricted, or the drain hose is kinked or partially clogged. On the JDPSG244LS2, leaks (door seals) and poor cleaning (spray arm blockage or low water fill) are also frequent.

• Won’t drain: standing water at the end of the cycle, gurgling, slow drain.
• Leaks: water at the front corners or along the bottom edge of the door.
• Not cleaning well: gritty dishes, soap left in the dispenser, weak spray.
• Not filling enough: unusually quiet wash, detergent not dissolving, poor wash action.
• Won’t start or stops mid-cycle: door won’t latch firmly or the latch switch is intermittent.

• Clean the sump and filter area; remove labels, glass, bones, and food debris.
• Confirm the drain hose has a high loop and is not pinched behind the unit.
• Run hot water at the sink until it is hot, then start the dishwasher.
• Check spray arms for clogged jets; rinse and clear holes with a toothpick.
• Verify the door closes squarely and latches without needing extra force.

Drain and wash issues usually start as simple restrictions (food, labels, hard-water scale). Fixing them early prevents odors, repeat clogs, and extra strain on the sump and motor.

Last updated: February 2026

Yes. We sell replacement parts for the Jenn-Air JDPSG244LS2 dishwasher, from small hardware to major components, so you can fix leaks, restore washing performance, or replace worn racks without replacing the whole appliance.

For the JDPSG244LS2, these are some of the most frequently replaced items:

• Water fill parts (to fix no-fill, slow fill, or fill errors)
• Door sealing parts (to help stop drips at the bottom or around the tub)
• Wash system parts (to improve spray and cleaning)
• Drain parts (to address poor draining or water left in the tub)
• Door latch parts (to fix a door that will not start or will not stay closed)

Use this as a starting point when choosing what to replace.

• Match your model number exactly: JDPSG244LS2
• Start with the symptom (leak, no fill, poor wash, no drain)
• Inspect for simple causes first (clogs, kinks, loose clamps, debris)
• Replace seals and gaskets when they are torn, flattened, or hardened
• If you are replacing a water or drain component, plan to check for leaks after the repair

Buying the correct dishwasher parts for your exact model helps restore proper water flow, spray pressure, and sealing. That means better cleaning, fewer leaks, and less risk of repeat failures from mismatched components.

Last updated: February 2026

A Jenn-Air dishwasher typically lasts 10 to 15 years with normal household use and basic maintenance. For the JDPSG244LS2, consistent cleaning and fixing small issues early (leaks, poor filling, weak spray) usually extends service life and prevents bigger failures.

• Water quality: hard water speeds up mineral buildup on spray arms and valves
• Usage: multiple loads daily shortens lifespan compared to 3 to 5 loads per week
• Detergent and rinse aid: correct amounts reduce residue and wear
• Drain and filtration care: clogs strain the wash system and motor
• Door sealing: leaks can damage components and flooring

If your JDPSG244LS2 is under about 12 years old, replacing a failed wear part is often the most cost-effective path.

These are frequent fixes when a dishwasher is not filling, washing well, or leaking:

• Fill valve assembly W11434044 (controls water flow into the tub)
• Water inlet W11535094 (inlet component tied to filling issues)
• Dishwasher manifold and spray arm assembly W11545334 (improves spray distribution)
• Dishwasher spray arm, lower W11550888 (restores lower rack wash coverage)
• Seal, door bottom W11664713 (helps stop door-edge leaks)

Knowing the typical life expectancy helps you decide whether to repair or replace. A simple fix like a fill valve, spray arm, or door seal can restore cleaning and prevent water damage, while major motor or sump repairs make more sense earlier in the dishwasher’s life.

Last updated: February 2026

Yes, for the Jenn-Air JDPSG244LS2 dishwasher, many common parts are DIY-friendly if you shut off power at the breaker and turn off the water supply first. Simple swaps like a spray arm, door seal, or latch are usually straightforward; wiring-heavy or leak-related repairs take more care.

Typically DIY-friendly

• Replacing a lower spray arm such as the dishwasher spray arm, lower W11550888
• Replacing a door latch such as the latch assembly (includes switch) W11412299
• Replacing a drain hose such as the hose-drain,e W11414944
• Replacing a door/tub seal (leak at the door perimeter) such as the gasket-tub,d W11483553

Often better for a technician (or advanced DIY)

• Water supply and fill issues (risk of leaks) such as the fill valve assembly W11434044 or the water inlet W11535094
• Motor/sump repairs (heavier disassembly, sealing surfaces)
• Electrical diagnosis beyond a simple latch or connector check

• Turn off power at the circuit breaker (do not rely on the door switch).
• Shut off the dishwasher water supply valve.
• Protect the floor; keep towels handy for residual water.
• Take photos of wire routing and hose positions before removal.
• Use the correct fasteners; a stripped screw can turn a small job into a big one.

DIY replacement can restore wash performance and stop leaks quickly, but dishwashers combine water, electricity, and tight seals. Choosing the right repair level helps prevent repeat leaks, nuisance shutdowns, and unnecessary part returns.

Last updated: February 2026