Whirlpool wall oven

The F0 code displays if there are no previous fault codes and you hold the CANCEL key for 5 seconds. Press CANCEL to clear the display.

Disconnect power or unplug the wall oven. Replace the electronic oven control (EOC).

Disconnect power or unplug the wall oven. Reconnect the keypad wire harness if loose. Restore electrical power to the wall oven and press CANCEL. If the error code returns after 60 seconds, replace the keypad. If the problem persists, replace the electronic oven control.

Disconnect power or unplug the wall oven. Reconnect the keypad wire harness if loose. Restore electrical power to the wall oven and press CANCEL. If the error code returns after 60 seconds, replace the keypad. If the problem persists, replace the electronic oven control.

Disconnect power or unplug the wall oven. Reconnect the oven temperature sensor wire harness connection if loose. Replace the wire harness if damaged. Measure the oven temperature sensor resistance using a volt/ohm meter. If the resistance isn't 1080 ohms at room temperature (70 degrees F), replace the oven temperature sensor. If the oven temperature sensor resistance and wire harness connections are okay, replace the electronic oven control (EOC).

Disconnect power or unplug the wall oven. Reconnect the oven temperature sensor wire harness if loose. Replace the wire harness if damaged. Measure the oven temperature sensor resistance using a volt/ohm meter. If the resistance isn't 1080 ohms at room temperature (70 degrees F), replace the oven temperature sensor. If the oven temperature sensor resistance and wire harness connections are okay, replace the electronic oven control (EOC).

Disconnect power or unplug the wall oven. Reconnect the oven temperature sensor wire if loose. Replace the wire harness if damaged Measure the oven temperature sensor resistance using a volt/ohm meter. If the resistance isn't 1080 ohms at room temperature (70 degrees F), replace the oven temperature sensor. If the oven temperature sensor resistance and wire harness connections are okay, replace the electronic oven control (EOC).

Disconnect power or unplug the wall oven. Reconnect the oven temperature sensor wire if loose. Replace the wire harness if damaged. Measure the oven temperature sensor resistance using a volt/ohm meter. If the resistance isn't 1080 ohms at room temperature (70 degrees F), replace the oven temperature sensor. If the oven temperature sensor resistance and wire harness connections are okay, replace the electronic oven control (EOC).

Disconnect power or unplug the wall oven. Unplug the meat probe and measure the resistance of the meat probe using a volt/ohm meter. If the resistance isn't 59000 ohms at room temperature, replace the meat probe. If the resistance of the meat probe is okay, insert the meat probe in the jack and check for a firm connection between the probe and jack in the oven. If the jack is damaged or worn out, replace it. Reconnect the wire harness connection on the meat probe jack if loose. Replace the wire harness if damaged.

Test the oven door switch operation using the oven light. Open and close the oven door to see if the oven door switch turns the oven light on and off when the oven door is opened and closed. If the oven door switch is defective, replace it. Disconnect power or unplug the oven. Reconnect any loose wires on the oven door lock assembly wire harness. Replace the wire harness if damaged. Check the door lock assembly for visible damage and replace it if broken.

Disconnect power or unplug the wall oven. Reconnect any loose wires on the oven door lock assembly wire harness. Replace the wire harness if damaged. Check the door lock assembly for visible damage and replace it if broken.