Kenmore 25370502612 refrigerator Parts

On Kenmore top-mount refrigerators like model 25370502612, the model and serial number are printed on a serial plate inside the fresh food (refrigerator) compartment. Open the refrigerator door and look along the inside walls for the rating/serial plate; it is meant to be cleaned with soap and water only.

• Inside the refrigerator compartment on an interior side wall (most common)
• Along the upper interior wall near the light area
• Near the crisper area on the interior liner (look around the lower section)
• If you see multiple numbers, use the one that starts with 253. for the model family

We recommend writing the information down exactly as shown so you can match parts and diagrams.

• Use a flashlight and look for a silver or white sticker/plate inside the refrigerator compartment
• Wipe gently; use only mild soap and water on the serial plate (avoid harsh cleaners)
• Take a clear photo of the plate so you can zoom in on the characters
• If the plate is scratched, try viewing it from an angle to reduce glare

The model number is the key to ordering the right Kenmore refrigerator parts (like a door gasket, evaporator fan motor, or ice maker) and following the correct setup steps for leveling and door sealing.

For the exact label location and how Kenmore documents model and serial information, use the owner's manual.

Last updated: February 2026

The Kenmore top-mount refrigerator model 25370502612 is a standard full-size top-freezer unit. For exact exterior dimensions (height, width, depth) and required installation clearances, we recommend confirming the measurements listed in the owner's manual and the installation guide for your specific configuration.

The installation instructions for this Kenmore 253-series top-mount platform specify the minimum clearances needed around the cabinet for airflow and hookups:

• Sides and top clearance: 3/8 inch
• Rear clearance: 1 inch
• Place it near a grounded outlet (no extension cord or adapter plug)
• Keep it away from direct sunlight and heat sources
• Install on a level floor that can support a fully loaded refrigerator

Use a tape measure and record these three numbers:

• Width: widest point of the cabinet (often at the hinge side)
• Height: floor to top of hinge cover or top of cabinet
• Depth: front of doors to back of cabinet (note: handles can add depth)

Also measure your path:

• Doorway width and height
• Tight turns or hallways
• Space to open doors fully and slide out crisper drawers

Most Kenmore top-mount refrigerators in this family fit within these common ranges:

A refrigerator that is even 1 inch too wide or deep can block door swing, reduce airflow (hurting cooling performance), or prevent proper leveling. Using the specified clearances helps the condenser and evaporator system run efficiently.

Last updated: February 2026

Most Kenmore refrigerators, including top-mount models like 25370502612, typically last 12 to 15 years. With consistent basic maintenance (good airflow, clean seals, correct temperatures), it’s common to reach the upper end of that range.

A refrigerator’s life is driven more by operating conditions and maintenance than by the badge on the door.

• Condenser cleanliness: Dusty coils make the compressor run hotter and longer.
• Door gasket condition: Leaks force longer run times and can cause frost and moisture issues.
• Temperature settings: Over-cold settings increase run time and wear.
• Room conditions: Hot garages and tight enclosures shorten life.
• Usage habits: Frequent door openings and overpacking reduce airflow.

Use these habits to help your Kenmore top-mount refrigerator run efficiently for years.

• Vacuum dust from the condenser area (as your model design allows).
• Keep food from blocking vents in the fresh food and freezer sections.
• Wipe the door gaskets clean; confirm the doors close and seal evenly.
• Level the refrigerator so doors self-close and align properly.
• Replace failed interior lighting with the correct bulb, such as the refrigerator light bulb 316538904 if it matches your configuration.

If your unit is approaching the typical lifespan, this quick comparison helps you decide what to do next.

Knowing the typical lifespan helps you plan: you can decide whether to invest in parts like a door gasket or evaporator fan motor, or focus on maintenance steps that reduce compressor run time. For model-specific care and operating guidance, follow the owner's manual.

Last updated: February 2026

Kenmore is a brand name, and different companies manufacture Kenmore refrigerators. For Kenmore model 25370502612, the 253 model prefix identifies it as a Frigidaire-built (Electrolux/Frigidaire) top-mount refrigerator; you will also see many compatible parts listed under Frigidaire/Electrolux part families in the parts breakdown.

Kenmore model numbers commonly use a prefix system where the first three digits point to the original manufacturer.

• 253 prefix: Frigidaire-built (Electrolux/Frigidaire)
• The rest of the digits: identify the specific design series, features, and color/trim variations
• The serial plate inside the fresh food compartment confirms the full model and serial number

For model-specific details like features, temperature control operation, and water supply hookup, use the owner's manual.

Knowing who built the unit helps match the correct replacement parts (ice maker, door gasket, evaporator fan motor) and reduces returns caused by look-alike components.

• Ice maker assemblies and fill components
• Door gaskets and door handle styles
• Evaporator fan motor and fan covers
• Defrost heater and defrost wiring
• Shelves, crisper drawers, and drawer covers

Here are a few examples from the parts list for Kenmore 25370502612:

Compare the model number on the serial plate to your parts order (it should read 25370502612). If your unit has a different suffix or a close model variant, the correct gasket color, handle, or ice maker version can change.

Last updated: February 2026