Maytag MSS25C4MGZ03 refrigerator Parts

Maytag refrigerators such as model MSS25C4MGZ03 do not use one universal reset button. Most “resets” are done by restoring power (unplugging briefly) or by using a specific control sequence for the feature you are trying to reset (controls, water filter light, or ice maker). See the MSS25C4MGZ03 owner's manual for the exact control steps for your panel.

Quick ways to reset common functions

• Control board glitch or after cleaning: Unplug the refrigerator, wait 5 minutes, then plug it back in.
• After a power interruption: Verify the temperature controls are set correctly after power is restored.
• Water filter status light: Use the filter reset steps listed for your control panel in the manual.
• Ice maker not cycling: Turn the ice maker OFF, wait 1 minute, then turn it ON.
• Dispenser issues (air in line): Purge air by dispensing water for several minutes.

What the manual confirms about “resetting”

Our manual guidance for MSS25C4MGZ03 supports a power-reset approach: before cleaning or service, disconnect power; when finished, reconnect power and reset the control (thermostat/refrigerator or freezer control depending on the model) to the desired setting. Use the MSS25C4MGZ03 owner's manual to match the steps to your exact control style.

Troubleshooting if a reset does not help

Use this checklist to narrow down the cause:

• Confirm the outlet has power (test with a lamp).
• Check the house breaker or fuse.
• Make sure the cord is fully seated in a grounded 3-prong outlet (no extension cord).
• Allow 24 hours after a new install or major temperature change for full cooling.
• If the issue is water or ice related, confirm the household water supply valve is fully open.

Symptom	Most likely “reset”	Next step if it returns
Display/control acting odd	Unplug 5 minutes	Check settings, then inspect wiring/connectors
Filter light stays on	Run filter reset sequence	Replace filter, then reset again
No ice	Toggle ice maker OFF/ON	Check fill, then test refrigerator water inlet valve WPW10179146
Warm fridge/freezer	Power reset + correct settings	Check airflow, fans, and defrost system

Why it matters

Using the right reset prevents unnecessary part replacement and helps you target the real failure point (controls, water supply, ice maker, or cooling/defrost). For water and filter-related issues, our how to replace the water filter in a Maytag refrigerator guide is a reliable next step.

Last updated: February 2026

On the Maytag MSS25C4MGZ03 side-by-side refrigerator, an ice maker usually stops working because water is not reaching the ice maker (shut-off valve closed, kinked line, low pressure, or a clogged/incorrectly installed filter) or because the ice maker is turned off or the bin is not seated correctly. See the MSS25C4MGZ03 owner's manual for the exact on/off method and checks.

Most common causes to check first

• Ice maker turned off: Depending on the design, the shut-off arm may be up (OFF) or the switch may be set to OFF.
• Water supply shut-off valve not fully open: No water flow means no ice.
• Kinked water source line: Reduced flow causes small, hollow, or no cubes.
• Low household water pressure: Ice and dispenser performance drop when pressure is too low (many systems need at least 30 psi).
• Water filter issue: A clogged filter or one installed incorrectly restricts flow.
• Ice bin not installed correctly: The ice maker can run but not deliver ice properly.

Quick troubleshooting steps (in order)

1. Confirm the ice maker is ON and the ice bin is pushed fully into place.
2. Verify the refrigerator is connected to the home water supply and the shut-off valve is fully open.
3. Inspect the water line behind the refrigerator; straighten any kinks.
4. If the unit was just installed or recently reconnected, allow 24 hours for ice to begin and up to 72 hours for full production; discard the first 3 batches.
5. Replace or reinstall the filter, then flush the water system.

Parts that commonly fix “no ice” symptoms

Symptom	What it points to	Example model-matched part
No fill, no ice, buzzing/clicking at times	Water valve not opening consistently	Refrigerator water inlet valve WPW10179146
Ice maker won’t cycle or harvest	Ice maker module failure	Refrigerator ice maker W10873791

Why it matters

Ice makers are very sensitive to water flow and pressure. A partially closed valve, kinked line, or restricted filter can stop ice production completely or cause small, hollow cubes.

Last updated: February 2026

For the Maytag MSS25C4MGZ03 side-by-side refrigerator, the warranty terms are listed in the Warranty section of the MSS25C4MGZ03 owner's manual. This is where Maytag spells out what is covered, how long coverage lasts, and what you need for warranty service.

What to check in the warranty section

Look for these details so you know exactly what protection you have:

• Coverage length for the sealed refrigeration system and other components
• Parts vs. labor coverage (some warranties cover parts only after a certain period)
• What is not covered (common exclusions like cosmetic issues or improper installation)
• Proof of purchase requirements
• How to request service (contact method and information needed)

Common warranty categories you will see

Most refrigerator warranties are organized by component type. Here is how to interpret them:

Warranty area	What it typically includes	Why it matters
Full appliance coverage	Most functional parts and labor	Best protection early in ownership
Sealed system coverage	Compressor, evaporator, condenser, drier, refrigerant tubing	Covers the cooling system that keeps food cold
Limited parts coverage	Specific parts only	You may pay labor even if the part is covered

Why it matters

Warranty coverage affects your repair decision. For example, if a cooling issue points to a sealed-system component like the compressor, knowing your coverage can determine whether you repair or replace. If you suspect a compressor-related problem, the refrigerator compressor WPW10466675 is the model-matched part used in the sealed system.

Last updated: February 2026