Kmart Front-engine lawn tractor Parts — Browse All Models

Common replacement parts for Kmart front-engine lawn tractors

• Brake interlock switch. The brake interlock switch detects whether you have the brake pedal fully pushed down. The parking brake holds the brake pedal in the fully depressed position so the brake interlock switch also recognizes whether you have the parking brake set. The brake interlock switch won't allow you to start the tractor without the parking brake set or the brake pedal fully depressed.
• Blade clutch cable. The blade clutch cable connects the blade clutch lever to the blade belt idler arm on the mower deck. When you shift the clutch lever to engage the cutting blades, the cable pulls the idler arm, which then tightens the blade belt and spins the cutting blades. The blade clutch cable releases blade belt tension so the blades don't spin when you shift the blade clutch lever to disengage the cutting blades.
• Carburetor rebuild kit. The carburetor rebuild kit includes gaskets, seals, a hinge pin and other components to refurbish the carburetor.
• Fuel filter. A fuel filter is a filter in the fuel line that screens out dirt and rust particles from the fuel. The fuel filter paper is usually integrated into a cartridge. Fuel filters used with in most internal combustion engines.

Replacing the ignition switch in a Kmart front-engine lawn tractor

• Park the tractor on a level surface and set the parking brake. Turn the ignition switch off and remove the key.
• Wear work gloves to protect your hands. Lift the seat. Remove the bolt connecting the negative cable to the battery and tuck the cable away from the battery so it doesn't touch the battery post.
• Lift the hood to access the back of the ignition switch. Release the locking tabs and push the switch out though the front of the dash. Disconnect the wire harness attached to the back of the ignition switch; if it's difficult to unplug, wiggle the plug as you pull on it. Remove the ignition switch.
• Connect the wire harness to the back of the ignition switch. Push the new ignition switch into the dash and engage the locking tabs. Lower the hood.
• Reconnect the negative cable to the negative battery terminal. Lower the seat.