Whirlpool Washer Parts — Browse All Models

Troubleshooting common Whirlpool washer issues

Even reliable Whirlpool washers can run into occasional hiccups. Here’s how to identify and address a few common problems.

Washer won’t fill or stops mid-cycle

If your washer doesn’t fill, first check the water supply. If the hoses are clear and valves open, the water inlet valve may need to be replaced. If the washer fills but then stalls, it could point to a faulty water-level pressure switch or timer.

Whirlpool washer won’t agitate or spin

If your washer is powered but the drum doesn’t move, the issue might lie with the drive motor or coupler. Listen for humming, which can suggest the motor is getting power but not engaging the spin basket.

Commonly replaced Whirlpool washer parts

• Drain pump – Removes water from the tub; failure causes standing water or spin issues.
• Electronic control board – Coordinates wash cycles; a faulty board can stop the washer mid-cycle.
• Door lock assembly – Prevents door from opening mid-cycle on front-load models; failure triggers error codes.
• Lid switch – Detects if the lid is closed; a bad switch can stop the spin cycle on top-load washers.
• Suspension springs – Help stabilize the drum during spin; worn springs can cause shaking and noise.

Why use Sears PartsDirect for Whirlpool washer repairs

At Sears PartsDirect, we make it easy to find exactly what you need. With manufacturer-approved parts, model-specific diagrams, and helpful resources like our DIY washer repair help, you can fix your washer fast—and with confidence.

Whirlpool washer FAQs

How do I reset my Whirlpool washer?

Unplugging the washer for one minute and then plugging it back in resets many Whirlpool top-load models. However, reset procedures can vary by model, so it’s best to check your owner’s manual for instructions specific to your washer.

Why does my Whirlpool washer keep going out of balance?

Common causes include overloading, unlevel floors, or worn suspension rods. Redistribute the load and check the leveling first.

What are some common Whirlpool washer error codes?

These error codes include F01 (control board issue), F21 (drain problem), and F11 (communication error). Refer to the chart to identify the cause.

Can I replace the spin basket myself?

Yes, if the basket is cracked or loose, you can replace the spin basket using step-by-step instructions.

What’s the average lifespan of a Whirlpool washer?

Most Whirlpool washers last 10–14 years with regular cleaning and maintenance.